Question about 1990 Dodge Dakota

1 Answer

Has rough idle just did plugs wires cap rotor distrbutor fuel pressure regulator and fuel filter runs and drives just doesnt feel right

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 473 Answers

Check for Vaccum Lost on avery hose Check PC's Valve, check hair filter, Vaccum hose system are important on any Vehicle for Idle control and air mixture calibration control for Fuel economie..

Posted on Oct 01, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Rough idle 95 astro van, I did a full tune up , plugs,wires,cap, rotor,air filter,and fuel filter and cleaned egr vavle.


I actually had to replace my EGR valve and the gasket. I clean the valve well and reused both. I don't think the gasket sealed well enough though. So I went ahead and got a new valve, gasket and changed them. It runs a lot smoother now.

Dec 14, 2012 | 1995 Chevrolet Astro

1 Answer

Idles irratic and runs rough down road after warmed up


Rough on idle when the engine is warm means there are many areas to be checked and it can start with the ECM , the fuel pump and more likely the sensors, check the throttle valve, the camsensor which can be set off which might need a correction. Also the vacuum feed for auto advance needs to checked.

Nov 15, 2011 | 1993 Jeep Grand Cherokee

3 Answers

Driving 60mph power drops as though out of gas. Coast 2-300 yds pump gas pedal van back to normal. Now at home it starts then stalls, will only run 5-10 seconds. New plugs&wires distributor cap and...


signs of a bad fuel pressure regulator. the vehicle runs rough, the engine will not start usually in the mornings. many times engine starts but stalls shortly after starting. a bad regulator can result in fouled plugs. black soot on plugs, blake smoke from tailpipe, running rough, stalling. you could have residue in fuel tank and need to change fuel filter again. have a very good day !!

Mar 09, 2011 | Volkswagen Eurovan Cars & Trucks

2 Answers

2003 ford ranger edge regular cab 3.0 Liter 6 Cyl.. 2 problems...Replaced Plugs and wires. Truck idles rough (especially after running for awhile) and misses when driving. You can...


You state you changed plugs and wires - Do distributor cap & rotor? If not you should then set timing. That should cure hesitation (might change fuel filter also and run good fuel system cleaner through it)
Prob 2 - sounds like a u-joint or possible brake pad/rotor issue. Does the squeal only happen in mornings when cold? Sometimes after sitting overnight, rotors get condensation and when backing out they'll squeal/grind. Somethings to look at...

Feb 27, 2011 | 2003 Ford Ranger Regular Cab

2 Answers

98 gmc jimm 4x4 4.3l v6 replaced plugs, wires and distributor cap and rotor. Still getting P0304 code and rough idle. Higher rpms flatten out roughness but take off feels off. Any help??


spray carb/choke cleaner all around intake gasket mating surface on heads. (while motor is running) If rpms change you have a bad intake gasket.

Feb 07, 2011 | 1998 GMC Jimmy

2 Answers

Ford F150 engine backfiring, running/idling rough


I Have a 1999 ford f150 4.6 that back fires and is just running really ruff when idling alot of nack fire a sord of like a pulse going on what is my problem?

Apr 16, 2010 | Ford F-150 Cars & Trucks

1 Answer

Car was running great. driving home all of a


Here are a couple of guesses for things to check: vacuum leak (low vacuum pressure), worn distributor cap or rotor, incorrect timing, clogged fuel injectors, malfunctioning fuel pump (low fuel pressure), ignition module on its way out. I hope these suggestions help you out.

Jan 09, 2010 | 1990 Oldsmobile Cutlass Ciera

1 Answer

95 Chevy C-1500 runs rough at idle and during accelleration. OBD-1 code 45. (rich exhaust)Runs ok at highway speed but gas milage seems worse. Replaced coil, cap, rotor, plugs, wires, fuel filter. BG-44K...


Check the vacuum line to the fuel pressure regulator and check to see if the fuel pressure regulator has gone bad. Give the throttle body a good cleaning and the injectors too. Do not use carb cleaner, it's to corrosive for the gaskets used in the throttle body. The other thing too that would cause this is a stuck or bad EGR valve, Try cleaning the EGR valve too since your cleaning the throttle body. Good luck and keep me posted.

Jun 11, 2009 | 1995 Chevrolet K1500

2 Answers

93 grand cherokee has a very rough idle what could be the problem


Also check the vaccum hose from the fuel pressure regulator to the intake manifold, it is right on top, to the front right of the valve cover where the fuel lines attach to the fuel rail, there is a small vaccum hose that runs from the regulator to the intake manifold, I have a 93 grand cherokee limited w/ 4.0L 6cyl, it was hard to start at times, wouldnt start at times without starting fluid spray and had your symptoms at idle, running rough like it wanted to stall like it was out of gas, I had various opinions ranging from fuel pump was bad to the fuel filter to the fuel presure regulator, the fuel pump relay ,etc....after replacing the relay and having the same symptoms, some digging brought me to this vaccum hose, wich had a break in it, when it was replaced it allowed the regulator to have the correct fuel pressure output and solved all the afforementioned problems way cheaper than the suggested alternitives. good luck.

Feb 08, 2009 | 1993 Jeep Grand Cherokee

2 Answers

1999 Ford Taurus mechanical problem


Hello,
your problem appears to be the idle control motor located on the air intake manifold it is a small motor that goes bad quite often. Other items that can cause this is a bad /clogged air filter or a tune up (spark plugs and wires), or clogged fuel injectors. to clean the injectors you can buy a container of fuel system cleaner and pour it into the gas tank and as you drive it cleans the system.

Once the fuel system is cleaned via a tankful of cleaner & gas then the idle controller motor would be next on the list to be replaced.

Good Luck !
Rich Lilja

Dec 03, 2008 | 1999 Ford Taurus

Not finding what you are looking for?
1990 Dodge Dakota Logo

Related Topics:

169 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...