Question about 1997 Mitsubishi Eclipse

1 Answer

Eclipse won't start

It started twice and then died with a bad miss or a vibration it seems like a vacuum leak but everything checked out. what is a good way to single out my problem or what steps should I take to find this problem.

Posted by on

1 Answer

You might want to check the fuel pump

Posted on Jun 12, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Engine dies when idling seems like electrical problem. wait a couple of minutes with key off, starts right up.


re-tune the idle mixture setting
check for vacuum leaks at the auto transmission actuator , vent controls
raise the idle rpms to around 650

Nov 02, 2015 | Cars & Trucks

1 Answer

2007 Nissan altima 105xxx miles. Slow & cranking start. Turns over a lot before firing up. It's a very quite chug. I had the brake switch relay fixed about 2 months ago at which point my car had completely...


It could be a vacuum leak in the engine. When you slam on the brakes, you rob vacuum pressure from the engine so your engine becomes starved of fuel and air temporarily. You should check all your hoses in the vacuum part of the engine.

Mar 25, 2015 | 2007 Nissan Altima

1 Answer

It runs okay for a few minutes then you have to keep one foot on the gas and one on the brake to keep it ri


You seem to have a very bad vacuum leak. Look at all your rubber hoses under hood , for cracked, loose , broken or missing hoses. You may even here them hissing. Replace any that you find. GOOD LUCK FRIEND.

Feb 15, 2014 | 1989 Chevrolet K1500

2 Answers

1994 Oldsmobile Bravada dies at stoplights, just changed fuel pump/filter and egr valve.Appriciate any help. thanks


check for vacuum leaks. You can do this with a can of carb spray but please be careful as it is flammable! if the ignition wires are leaking and you hit them with carb spray you will start the engine on fire!

The safer alternative is to have the engine "smoked" for vacuum leaks. This is done with a smoker. Any place that is leaking you will see smoke.

A trained ear will also be able to hear a leak.

If no leaks are found try unplugging the MAF sensor. Is is in the air tube next to the air filter box. If performance improves try cleaning it with some MAF sensor cleaner. If that doesn't work than you may need to replace it.

Feb 08, 2012 | Cars & Trucks

1 Answer

1996 chevy k1500 runs when idleing slight miss drives down the road fine but when comming to a stop it dies


When the light flashes it means a cylinder misfire, so you must check everything, spark, (first) injector fuel delivery intake manifold vacuum leaks and compression if not other problem accounts for the misfire.

Feb 04, 2012 | Chevrolet 1500 Cars & Trucks

1 Answer

I changed the plugs,o2 sensors,but it's still vibrating,hard I think it has an vacuum leak some where but don't know where,2001 ford focus


good chance you have a bad coil causing the miss fire. mist some water over your coils see if that makes a change in how the car idles if it gets worse or if you have single coils over your plugs look to see if they are broken. or if you have wires you might see some sparks from the current. that is a good way to go.

Sep 17, 2009 | 2001 Ford Focus

1 Answer

Car won't idle without revving when cold and dies when in drive


This Vehicle needs an Idle air control/Idle speed motor. Good Luck

Dec 28, 2008 | 1996 Mercury Grand Marquis

1 Answer

Car will turn over but will not start unless gas is fully applied


check for massive vacuum leak at intake and also check timing ...compression test alone does not eliminate timing as suspect

Dec 15, 2008 | 1993 Pontiac Grand Am

1 Answer

PROBLEMS!!!!


That sounds to me like the catalytic converter is going out. suggestion, take it to a muffler shop and have them check it out. As for the ticking and missfiring, mine has done the same thing for a while and I keep throwing out a vacuum leak as well as Throttle position control, cruise won't work as cruise, it will actually slow down on hills from 70-40 mph, but I know both are the problem, solution, the throttle position control is under the air intake, take the air box off of the throttle body and replace it after having autozone run a check. From there..... find someone good at mufflers as well as vacuum leaks and fix it. lol.

Jun 16, 2008 | 2003 Jeep Grand Cherokee

Not finding what you are looking for?
1997 Mitsubishi Eclipse Logo

Related Topics:

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6879 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...