Question about 2004 Nissan Titan

1 Answer

Missing wire I cannot find the wire hookup under dash to install brake controle for my hitch . I took it tonissan dealers and they could not find it. Is possible that its a manufactor defect?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 24 Answers

That is possible. Another venue for you would be to go to a U-Haul store. They install hitches and might be able to help.

Posted on Jun 20, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I am moving and I need to know if I can rent a u-haul trailer to hitch to my car.


yes, most authorised u-haul dealers can install a temporary hitch and light hookups

Nov 30, 2011 | 1998 Buick LeSabre

3 Answers

I have a 1999 F250 Super Duty Lariat Super Cab 7.3L diesel.The wiring for the tow hitch is 4 prong flat with 3 extra wires.What was included from the factory and\r\nwhat do I need to pul camper with rv...


With 4 prong and 3 extra, that will give you what you need for 7 prong for towing RV. If your not too experienced in that area, a mechanic at any trailer place, or hitch installation place or who knows RV wiring, should be able to do it for you in about 1/2 hr. or less. Testing the wires from your truck for what they do as in right , left, stop, running/taillights, etc is about the hardest part, and the 7 prong usually comes with what terminal does what.48e2ffb.jpg

Jun 10, 2010 | 2002 Ford F250 Super Duty SuperCab

1 Answer

Were do you hook up the two wires under the hood for trailer brakes on a 2000 silverado


Sometime around 2000, GM started putting trailering pre-wire harnesses in the vehicle. Your truck may have this harness built in and would greatly simplify brake controller installation. Look under the glovebox and see if there is a wire harness tied off. There will be four wires in this harness, which should be run over to the steering column to use it. Most trailer brake controllers are compatible with this harness.
The four wires in the harness are: Red, 12vdc; black, ground; blue or purple, brake pedal; and brown or white, trailer brake wire to seven pin, four pin, or five pin connector at trailer hitch, if your truck came from the factory with a trailer hitch.
If you are adding the hitch and do not have the four wire harness, the under hood wires from your brake controller are Red, connect to one of the studs under the distribution box cover (the distribution box is on the driver's side against the firewall. Underneath the cover are two large threaded studs which are hot from the battery all the time); and the other wire from your brake controller would have to be run the length of the truck along the frame, tied off in several places, to the trailer hitch connector on the bumper. Follow the directions that came with trailer hitch wiring connector to connect this wire to the proper pin in the connector.
If this has helped you, great, and please remember to vote/comment.
Good luck!

Feb 21, 2010 | 2000 Chevrolet Silverado 1500

1 Answer

2006 trailblazer with tow package electric brake hookup on dash


It's taped to a large bundle of wires just above the parking brake. There will be a large white sticker on it calling out each wire.

Aug 24, 2009 | 2005 Chevrolet Silverado

2 Answers

Electric trailer brake hookup


Truck Brake control

Red/Black stripe Black

Blue Blue

Lt. Blue/white stripe Red

White White

Orange Not used

Jun 28, 2009 | 2006 Toyota Tacoma

1 Answer

2007 Nissian Frontier trailer lights


There should be a 30 AMP mini blade fuse in the fuse box under the hood that you are probably missing. I assume that since you got the relays with the wiring kit, that you got the kit from a Nissan dealer. If that is true, there should be a fuse in the kit also- in a sealed bag that has the "trailer wiring harness owner's manual" in it.


Hope this is helpful!


Nissan Scope Technician- 10+ years experience in Nissan dealership.

Oct 24, 2008 | 2007 Nissan Frontier SE Crew Cab

6 Answers

Trailer wiring for 2005 Ford Escape without factory tow package


I had the sam problem with my '02 escape when I installed the hitch. I changed the turn signal relay under the dashboard on the drivers side of the dash with one from an escape that had a tow package(one was blue and the other was yellow...). worked fine for me after that. Don't know if it changed later...

Oct 17, 2008 | 2005 Ford Escape

2 Answers

Hitch installation w/electrical wiring for brake


Disconnect all that trailer connector mess and start over. Someone messed up. Do you have a 6- or 7- way RV connector, a 4- or 5-way flat (U-Haul) connector, or what? Was an electric brake box installed under the dashboard for trailer electric brakes?

Better yet, sell me your Jeep cheap, it probably can't be fixed, and it's worthless.

Jul 30, 2008 | 2000 Jeep Grand Cherokee

1 Answer

Hitch w/electrical wiring brakes


Disconnect all the hitch wiring and test for ability to crank. Someone did the hitch hookup incorrectly, or damaged other wiring hooking it up.

Jul 30, 2008 | 2000 Jeep Grand Cherokee

Not finding what you are looking for?
2004 Nissan Titan Logo

Related Topics:

95 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...