Question about 1995 Pontiac Grand Prix

Open Question

1995 Grand prix. Linkage from door handle to latch actuator came off the actuator.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
rick_amick
  • 69 Answers

SOURCE: Door latch linkage came off handle

Where the rod end goes in to the door handle there should be a clip that snaps down over the rod to keep it locked in to the handle.

Posted on Mar 27, 2009

Ad
jrod1125420
  • 161 Answers

SOURCE: 1997 Pontiac Grand Prix Door Latch

i havnt come across any easy fixes for this but to replace the linkage in the door....sry to tell ya that.....

Posted on Sep 30, 2008

  • 1 Answer

SOURCE: Installing exterior driver side and passaner side door handles

I found this on another page, hope it helps:)

Remove the plastic cover behind the door handle assembly by removing one black 14mm nut from just above the door handle, and 1 screw (usually phillips) from the bottom of the plastic cover.
Remove linkages from lock cylinder and door handle assembly. Use a small flathead screwdriver to slide retaining clips forward, and linkages will come free.
Remove one black 14mm nut from the very top of the door handle assembly.
Remove one phillips screw drom the bottom of the door handle assembly.
Door handle assembly should now come free by pulling out slightly at the top, and pulling upwards.
Transfer lock cylinder and key minder light (if applicable) to new door handle assembly. Lock cylinder is retained by a single TORX bolt.
Reinstall in reverse.
TIP: If you lose or damage any of those black plastic coated nuts, order new ones. They are GM p/n 10067214 and should be around $0.58/each. There are two on each door.

Posted on Apr 03, 2009

  • 2841 Answers

SOURCE: 2001 Pontiac Grand Prix. Frozen Hood Latch

Try using a hair dryer to unfreeze the latch.

Posted on Dec 10, 2009

Testimonial: "Very helpful. The hair dryer worked in 10 minutes. Thanks."

  • 1455 Answers

SOURCE: How do you release the rear liftgate latch on a

Unlock the doors with the power unlock button then you have to push in on the bottom part of the plastic bezel that surrounds the liftgate handle, while at the same time pulling the liftgate handle outwards. It should open then.

Posted on Feb 01, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1999 Pontiac Grand Prix driver side door will not shut


The latch is stuck,get WD40 and spray it and move latch handle and move latch at same time Angie.

Nov 06, 2012 | 1999 Pontiac Grand Prix

1 Answer

The door shut after linkage was removed. How do i open it?


if you have the panel off from the inside of the door you should be able to use a screw driver to push open the latch.

Mar 30, 2012 | 1995 Pontiac Grand Prix

2 Answers

1996 lincoln continental door latch does not lock/unlock door from inside or outide...door stays open basically...door latch has no response, unlock/lock switch works


I have the same problem.(Door will not stay closed) The door latch itself seems worn to the point where the linkage from both the actuator or door handle causes the latch to get stuck. I can free it with a screw driver applied where linkage connects to the latch, but it will stick again. Dealer wants over 300 with actuator. I am looking in junk yard for part. Remove door panel, somehow disconnect linkage from latch. It makes more sense to remove 3 hex or star screws 1st (27mm) so latch will be more accessible. My problem is the door latch, not anything else. Good luck

Jan 24, 2011 | 1996 Lincoln Continental

1 Answer

My 2006 hhr passenger door doesn't work . both handles will not open the door. I have pulled the passenger seat and the door panel and tried to open the lock manualy and it still won't open? Lost with my...


This is common, the door lock actuator is frozen, when this happens the lock wont move, some of these the actuator is part of the latch, look at the lock linkage for the door lock lever and follow to latch and see if you locate another linkage arm from actuator, remove that arm and then unlock the door , hope this helps.

Nov 08, 2010 | Chevrolet HHR Cars & Trucks

2 Answers

Door handles don't open....


i have the same problem on my 1995 grand prix gtp 2 door coupe...the only differnce is that i had door poppers installed and took off the lock rod, turnes out the solenionds cant pull the latch open, so i need stronger solenoids. but my door wont open either...if anyone has any fixes to this problem let me knows ASAP!! i cant crawl thru the passenger side in the middle of a S. Dak. winter...

Oct 09, 2009 | 1995 Pontiac Grand Prix

1 Answer

90 525i bmw key will n ot lock/unlock door and door will not clos


I would check the door lock actuator and the actual linkage. you need to remove the outside handle assembly for full inspection. on your model year car the linkages sometime wear out at a camon the handle that rotates the linkage. sounds really like you have worn linkage/handle.

Apr 06, 2009 | 1990 BMW 5 Series

1 Answer

The front doors on my 1994 pontaic grand prix won't open from the outside only from the inside where they open very easily


you will need to remove the door panels and see why the linkage from the handle to the latch is not operating. Often, the linkages are held on by thin metal clips or nylon bushings that break over time.

Mar 27, 2009 | 1994 Pontiac Grand Prix

1 Answer

Both door handles broken


there are to rods one for the lock and one for the handle pull the handle rod if it is exposed pull on it / The only way to replace the handle and or lock is to take the door apart/ please rate my response thank you very much

Jan 31, 2009 | 1996 Pontiac Grand Prix

1 Answer

1997 Pontiac Grand Prix Door Latch


i havnt come across any easy fixes for this but to replace the linkage in the door....sry to tell ya that.....

Jul 03, 2008 | 1997 Pontiac Grand Prix

Not finding what you are looking for?
1995 Pontiac Grand Prix Logo

Related Topics:

411 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8572 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...