Question about 1998 Honda Accord
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Try these things. Why don't you call the Honda customer service at 1-800-999-1009 have your radio serial number and VIN to your car and they will help you to unlock your radio. If you don't have the serial code to your radio and you are the original owner they will tell you have to get the code and turn it back on and also how to get your serial number to you radio to unlock it. Here are some websites too: www.Radio-code.com & www.webcrawler.com type in radio unlock code. But if you are the original owner you should have a white card that came with the car. It says HONDA Anti-theft radio Identification card . It has you code number and serial number on it and how to put in the code to unlock the radio.
Posted on Aug 02, 2009
yes you can replace it, more than likely I would try getting a replacement window from your local import salvage yard. you will need to remove the door panel screws (normally in the small pull compartment to close the door) and one in the latch, both have a plastic cap that needs to be pried up, it is also connected to the screw or bolt. next, you will need a flat blade screw driver or flat pry bar to take off the panel, start at the bottom. it should just pop out (loud snapping noise). In addition, there is a triangular shaped black plastic cap in the corner, that will also pry off. You will need to unplug the window and door lock connector, carefully remove the lining, you should be able to gain access to the two bolts that hold the window in place. you might have to raise or lower the door till you see them in the removal holes, should be a 10 mm socket. After you loosen remove old glass and install new one and re assemble as you have taken apart, Good Luck!!
Posted on Sep 11, 2009
Difficult to describe, but I will give it a try.
Inside the driver's side fender, close to the front of the car, there is a bracket that is held in place by one bolt, but which has a short horizontal bar as part of it which has two large clips encircling two cylinderical devices which have wires clipped into them at the bottoms. The one closest to the front (radiator) is the compressor clutch relay. The other one is the condenser fan relay.
Hope this helps you find it.
Posted on Oct 20, 2009
Detach the cable from the negative terminal of the battery. Caution: If you have an anti-theft radio, make sure you have the activation code before disconnecting the battery.
Remove the battery and battery tray from the engine compartment (remove the battery first, then remove the bolts for the battery tray and remove it.).
Remove the lower radiator hose and the wiring harness from the starter bracket. Make sure they are positioned out of the way.
Clearly label, then disconnect the wires from the terminals on the starter motor solenoid (the smaller cylinder attached to the starter). Disconnect any clips securing the wiring to the starter.
Remove the mounting bolts (two) and detach the starter (pull it gently out of its housing).
Reverse this procedure for installation.
Hope this is of help to you.
Posted on Dec 26, 2009
Tips for a great answer:
Oct 05, 2010 | 1998 Honda Accord
Sep 19, 2010 | 1998 Honda Accord
May 04, 2010 | 1998 Honda Accord
Apr 17, 2010 | 1998 Honda Accord
Jan 29, 2010 | 2004 Honda Accord
Oct 17, 2009 | 1998 Honda Accord
Sep 08, 2009 | 1998 Honda Accord
Dec 01, 2008 | 1998 Honda Accord
364 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: