Question about 1991 Chevrolet Corvette

1 Answer

Security light flashing and doesnt let me start the car

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

  • Expert
  • 355 Answers

The security system (VATS/PassKey) is having problems, it's typical on those cars/years. It's been a nightmare for us. You can find a great write-up here: http://newrockies.ca , it was the only thing that saved my 94 Park Avenue that has the same security system.

Posted on Dec 06, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How do ibroche security block on my s80 volvo. It wont start.


If your security light is flashing leave the key in the on pos for 10 min and the light should stop flashing . when it does your car will start

Oct 23, 2014 | Volvo S80 Cars & Trucks

1 Answer

Why does my remote start just make the car horn beep and security lights flash but doesnt start?


it sounds like security start relay malfunction ,check and or change out relay.

Sep 07, 2014 | 2007 Chevrolet Malibu

1 Answer

Security reset


Depending on the make model and year, did you have a key cut to match the new lock cylinder and the old key chip ?

Jul 06, 2013 | Cars & Trucks

1 Answer

Security lights won't flash


The security light will only flash if theres a problem, are you talking about when the alarm is on and car is off the secuirty light doesnt flash, if thats the problem then the alarm may not be arming or the light is bad, there may be a module problem.

Feb 15, 2012 | 2002 Pontiac Grand Prix

3 Answers

2001 monty carlo changed battery securty light flashing car wont start. car ran great before any trick or code i dont know to get it to start


Leave the key in the run position until the security light stops blinking. This should take 10 minutes. Then turn the key off, wait 5 seconds and try to start it. The security light should be blinking again. Leave the key on again for 10 minutes. Repeat this 3 times. After the third time on the the next start it should start and run fine. This will reprogram your theft system.

Feb 06, 2011 | 2001 Chevrolet Monte Carlo

1 Answer

2003 TOYOTA 4RUNNER WONT CRANK... LIKE DOESNT GET A SIGNAL.. THEN SUDDENLY IT STARTS


probably the security system or safety interlock. Is there a security light flashing? If not, try starting in neutral.

Please see my tip at http://www.fixya.com/cars/r6222268-engine_doesnt_crank_turn_over . These are generic instructions. If you get stuck or need specific instructions for your car, please get back to me with model, year and engine info.

Oct 27, 2010 | 2003 Toyota 4Runner

2 Answers

My 2002 Grand am is have a passlock problem. The


I discovered the hard way- ($85.00 later) Step 1: turn key to "on" position. step 2: open driver door. (security light should be flashing on and off) step 3: wait ten minutes with key in "on position and driver door open. step 4: when 10 minutes is up-(youll know-because security light will have stoped flashing after 10 minutes) close driver door ,turn key to "off" position, then turn key "on" to start. drives me crazy!! I have to do it to mine sometimes 2-5 times a day! GM doesnt have a fuel reset button etc. like fords do.

Jul 17, 2009 | 2002 Pontiac Grand Am

1 Answer

Security light flashing and ignition doesnt work


your ignition switch is bad for now though turn your key on for at least ten minutes until the light stops flashing this will reset your security system after stops flashing turn key off and then start the truck

Mar 17, 2009 | 1999 Chevrolet S-10 Pickup

2 Answers

2004 alero


If the security light is flashing when that happens, you need to turn the key to the ON position, and let it sit for 10 minutes, so it can reset the security code. Start it up as normal and let it idle for 5 minutes.

Nov 04, 2008 | 2004 Oldsmobile Alero

Not finding what you are looking for?
1991 Chevrolet Corvette Logo

Related Topics:

180 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6924 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...