Question about 2002 Nissan Xterra

Open Question

Nissan X Trail back door will not open. Remote key releases door but door only opens about two inches. when you then close the door and open in the normal manner the door only opens the two inches.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

ndguy2481
  • 251 Answers

SOURCE: Trunk release will not work, but I can open it with my key

inside the trunk near the latch is a switch that kills the trunk remote

Posted on Dec 04, 2008

  • 3 Answers

SOURCE: 2000 nissan pathfinder back doors will not open

Are the doors manual or auto? Are your door lock actuators engaging when you hit the open/close button? Did you check all your fuses to make sure there all good? If every thing is checking good, and the door wont open from inside or outside, then your problem is : Inside your door are a series of rods, one goes from your inner door handle straight to the door lock assembly (it is dislocated from opening the door roughly) and one goes from the actuator to the door lock assembly which I believe also is dislocated, only way to fix this problem is to weasel your way through the edge of the door panel with a very long screwdriver (16-20") and a light and try to trigger the mechanism directly on the lock to open. This is alittle tricky and might require a trained technician to perform because with the door closed your panel might not come off which will raise the risk of destroying your door panel, in the long run paying a little money could save you a lot more if you break that panel!

Posted on Feb 13, 2009

  • 1 Answer

SOURCE: 2004 Nissan Murano, back door can't open

I had a similar problem with a sienna and sometimes the cable ( inside the door) between the handle and the latch gets stuck in the sleeve. Kind of like the brake cable on a bike.
take the panel off by removing all the screws you can see on the panel and pull the panel off. There will be plastic pins holding it. Some of them may pop off and some will break off.
Drip oil down the sleeve so the cable slides freely. I used bike chain oil. Do not use WD40. This is **** and will not work for very long. Try the handles a few times before you put the panel back.

Posted on Mar 03, 2009

MNfisherman
  • 11896 Answers

SOURCE: Driver side window stuck on Nissan Maxima 2004

It is likely the window motor is wearing out and will need to be replaced. You can always try a different switch on those wires to rule out switch problem. Otherwise, the motor will have to be replaced.

Posted on May 25, 2009

  • 80 Answers

SOURCE: My friend has a 1994 Nissan Infiniti that's alarm

I have the same Infiniity and it has a similar problem. On my car the alarm can be shut off by turning the lock on the drivers door with the ignition key. Works every time.

Posted on Aug 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Is there a release trunk button inside the car?


New Member - Trunk release question - Nissan Forum ' Nissan Forums

forums.nicoclub.com/new-member-trunk-release-question-t320939.html
Mar 12, 2008 - I had a question regarding installing a trunk release. Since there is noneinside the car, a key is necessary to open the trunk. ... Hit the unlock button on the key fob twice (to unlock all the doors) and as EV says, walk over and press ... So thereis no way to open ther versa HATCH without the the key remote? trunk release inside the rogue?
Apr 18, 2009
I found the Trunk Button!!!
Sep 13, 2008
Anyone got Trunk release button on his remote ?
Aug 22, 2008
How do you open the hatch from inside?
Sep 13, 2007
More results from forums.nicoclub.com

2015 NISSAN Versa Sedan - Trunk Release - YouTube

? 0:37
https://www.youtube.com/watch?v=cE1SOFs_Tc4
May 5, 2014 - Uploaded by Nissan USA
2015 NISSAN Versa Sedan - Trunk Release. Nissan USA ...From inside the vehicle, pull up on the open lever. ? Unlock the trunk using the key. ... Press and hold the trunk button on the Intelligent Key.

Jan 19, 2016 | Cars & Trucks

1 Answer

Mazda 6 2005 driver door jammed


if you talking about door latch wont let door close.try to reset all door locks.first if you cant get door close.work unlock button with remote or door switch.then hold open door handle while you flat screw driver pull up latch in door latch should stay up so door will close.once get door close.try resetting all door locks by sitting inside vechicle with all doors close.remove key from ignition.open drivers door.wait 24 seconds.turn ignition switch on and back to lock position 3 times.press and release drivers door courtesy light 3 times.ensure doors lock and unlock.if not wait 40 seconds and repeat procedure.if this procedure fails. you have problem in the door latch and lock mechanism inside the door itself.

Jan 04, 2013 | 2004 Mazda 6 Sport

2 Answers

Door lock problem


@mark, how would you open the inside door panel when the door itself cannot be opened...i have the exact same problem, and I cannot figure out how to open the damn panel while the door jammed shut...please help...

Jul 02, 2012 | 2006 Nissan X-Trail 2.2

1 Answer

Nissan sentra 2006 My trunk wont open && I spent 2 1/2 hrs trying to break in from the back seats. trying to reach the seat release but cant. The key or remote wont open it. The car latch wont open...


does the key turn the trunk lock?if not theres one issue right there.the other may be that the valet lever on trunk latch assy. may have inadvertantly been engaged if deck lid was slammed closed.the release solenoid will make noise when activated by fob or lever in car but because of valet being engaged cannot release latch.does key unlock glovebox?if not this may also be a valet key cut.contact nissan dealer to cut regular key.ive seen the slamming the deck lid scenario a million times as the valet lever takes hardly any effort to engage.good luck and let me know how you make out.

Feb 07, 2011 | 2006 Nissan Sentra

1 Answer

Keyless entry not working


Programming
When
Remote control added or replaced. System malfunction.
How
Obtain all remote controls. Remove key from ignition switch. Close all doors. Open driver's door. Carry out the following within 24 seconds: Turn ignition switch ON and back to LOCK position 3 times. Remove key. Press and release driver's door courtesy light switch 3 times. Ensure doors lock and unlock. If not, wait 40 seconds and repeat procedure starting with driver's door already open. Press each remote control lock or unlock button twice. Ensure doors lock and unlock after each remote control operation. If not, proceed as follows: Press and release driver's door courtesy light switch once. Ensure doors lock and unlock twice. Repeat procedure starting with driver's door already open.
NOTE: A maximum of 3 remote controls can be programmed.

Mar 29, 2010 | 2004 Mazda 6

1 Answer

2000 Celica GT - I can get into the programming mode just fine, but I have tried to program THREE separate remotes and none of them will program. They are used, so I am "rewriting" them, but they never...


I saw this on one of the toyota forums;
1) Getting a Replacement Remote

Look on ebay or google, make sure the remote has the following FCC-ID: bab237131-056

2) Installing the remote (credit to iPal)

1 open door, take key out...

2 insert and remove key from ignition 2 times

3 close and open driver's door 2 times

4 insert and remove key from ignition

5 close and open driver's door 2 times

6 insert key into ignition

7 close door

8 turn ignition from 'lock' to 'on' and back to 'lock'

if you do step #8

*1 time it's for add mode

*2 times for rewrite mode

*3 times for confirmation mode

*4 times for prohibition mode

9 remove key

10 then door lock will cycle 'lock' and 'unlock' a number of times
corresponding to your key cycles in step #8

11 press lock and unlock button together for 1 ~ 1.5 sec then release

12 then within 3 sec press lock button for 1 sec then release

13 if you did correctly door lock will cycle once...

if wrong, twice... then do it over...

Jan 27, 2010 | 2002 Toyota Celica

1 Answer

2003 Nissan Murano hatch back door won't unlock or open. Glitchy for a long time, always opened eventually with a ritual of locking/unlocking using the remote/lock on the door, etc. Upon opening,...


I have a 2004 Murano. I opened the small hatch and with a screw driver and someone on the outside managed to open the hatch. The problem appears to be bent pieces inside. After straightening them out and using a good silicon spray, mine works again. It should be lubricated quite frequently.

Nov 05, 2009 | Nissan Murano Cars & Trucks

2 Answers

How do you change battery in Toyota Prius keyless remote


ok take the remote push the the key release on the top remove the valet key or door key then hold it firmly in your hand and with one finger push the key release slide all the way over again as if you were removing the key take your other hand and firmly place your thumb on the toyota symbal on the back and push it firmly upward towards the key release the back cover will slide up revealing a small door held on by four very small screws youll need a jewelers or eyeglass philips screwdriver to remove them un do them and out pops the battery its a cr21 just in case you didnt know

Jul 17, 2009 | 2007 Nissan Maxima 3.5 Sl Sedan

1 Answer

How can I re active the wireless remote control system ?


sit in car all doors closed put key in ignition and turn from OFF to ACC 3 times as fast as you can leaving it in ACC on the last cycle then press your remote button. your blinkers should flash to tell you this has worked.... may take you a couple of tries to get it!!

Jun 30, 2009 | 2002 Toyota Camry Solara

1 Answer

Program my remote


Program your factory keyless entry functions
For 2001+ Tacomas equipped with a factory alarm or keyless entrymag-glass_10x10.gif, here are some programming options that allow you to adjust the way your locks work.
The first programming option allows you to set the entry unlock to: (A) unlock the driver door with one push, and the remaining doors with a second push OR (B) unlock all of the doors with a single push.
  • Open the driver's door. Remove the key from the ignition switch.
  • (Complete these steps within 40 seconds)
    1. Insert the key into and remove it from the ignition switch 2 times.
      (IN - OUT - IN - OUT)
    2. Close, then open the driver's door 2 times.
      (SHUT - OPEN - SHUT - OPEN)
    3. Insert the key into and remove it from the ignition switch 1 time.
      (IN - OUT)
    4. Close, then open the driver's door 2 times.
      (SHUT - OPEN - SHUT - OPEN)
    5. Insert the key into the ignition switch and leave it in.
    6. Close the driver's door.
    7. Turn the key from LOCK to ON 4 times, ending at LOCK
      (LOCK - ON - LOCK - ON - LOCK - ON - LOCK - ON - LOCK)
    8. Wait for the locks to stop, then remove the key from the ignition switch.
  • On the key fob, press and release both LOCK and UNLOCK buttons at the same time.
    1. [For all doors unlock] press and release the UNLOCK button.
    2. [For driver door unlock] press and release the LOCK button.
  • Open the driver's door. The programming is complete. If programming did not occur, start over.

Jan 13, 2009 | 2001 Toyota Tacoma

Not finding what you are looking for?
2002 Nissan Xterra Logo

Related Topics:

357 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...