Question about 1998 Ford Expedition

1 Answer

How to change spark plugs on a 1998 Ford Truck Expedition 2WD 5.4L EFI 8cyl

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 51 Answers

Youll need a spark plug socket and a long extension and rachet.

Posted on Sep 30, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is causing 1998 4.6L expedition to hesitate on hills, rough idle


Are you sure the spark plug wires are on the correct spark plug? Recheck the firing order and spark plug wires. Additionally check timing on distrubutor

Jun 05, 2014 | 1998 Ford Expedition

3 Answers

Engine light is on, flashes when driving above 100 Km


stop by local parts store (Autozone,Advance, etc) and have them do a free fault code test. They can print out a list of faults and clear the codes

Jan 02, 2011 | 1998 Ford Explorer

1 Answer

I have 1998 epxpedition my engine light is on truck run rough ,I t is saying the number cyl is miss firing I need to know what is the firing order on the expo it is a 5,4l. I think it may be the ignition...


a factory weatherstripping on the hood leaks causes the cylinders 2 &3 on the pass side to misfire. pull the coils for the cyl. .take off boot with long spring inside, thats your plug wire. they are rusty, no? clean them up, put some dielectric grease all over the spring and reassemble. theres your prob!!!!

Dec 10, 2010 | 1998 Ford Expedition

1 Answer

I dont know if my 1998 Ford Expedition XLT has a 4.6 or 5.4L engine and how many bolts does it have. It's a V8.


Both conditions:
* 8 Cylinders VIN 6 4.6L EFI SOHC Windsr 1998 Ford Expedition 4WD
* 8 Cylinders VIN L 5.4L EFI 1998 Ford Expedition 4WD
* 8 Cylinders VIN W 4.6L EF 1998 Ford Expedition 4WD

I suggtes visit your dealer.

Oct 06, 2010 | Ford Expedition Cars & Trucks

1 Answer

I locate oxygen sensor on my ford expedition


for 1998 Ford Truck Expedition 4WD 5.4L EFI 8cyl the Oxygen Sensor is located under vehicle, driver side, below seating area, mounted in exhaust pipe in rear of catalytic converter.

Application: Number three

Hope helps (remember rated this).

Aug 09, 2010 | 1998 Ford Expedition

1 Answer

On a 1998 expedition, where is the pcm and the ecm--5.4 litre


1998 Ford Truck Expedition 4WD 5.4L EFI 8cyl

PCM Ford's Location:
* Ranger - behind instrument panel (cowl), center to both driver and passenger sides.
* Explorer/Mountaineer - behind instrument panel (cowl), (access from engine compartment dash panel) on passenger side to center of vehicle.
* All other F-Series, Expedition/Navigator - lower dash panel on passenger side.
* Excursion - lower dash panel on driver side.

The PCM is behind the glove box and has a big harness connector in the firewall that you access from the engine compartment.

REMOVAL & INSTALLATION

a927c58.jpg

Fig. 1 The calibration number will be needed to order such parts as a replacement PCM, various sensors, and almost any emission control component. Typically this number is attached to a label found on the driver's door or the door pillar


1997-00 F-150, F-250, Expedition and Navigator

00a02b5.jpg

Fig. 2 Loosen the connector retaining bolt and remove the PCM connector

2cda058.jpg

Fig. 3 Remove the passenger side front door scuff plate

1fe310f.jpg

Fig. 4 Remove the passenger side kick panel

234c3f5.jpg

Fig. 5 Remove the PCM bracket clip and remove the PCM
  1. Remove the battery and the battery tray.
  2. Loosen the connector retaining bolt and remove the PCM connector.
  3. Remove the passenger side front door scuff plate.
  4. Remove the passenger side kick panel.
  5. Remove the PCM bracket clip.
  6. Remove the PCM.
To install:
  1. Installation is the reverse of removal.
  2. Tighten the PCM connector retaining bolt to 36-44 inch lbs. (4-5 Nm).

Hope helps.

Jul 13, 2010 | Ford Expedition Cars & Trucks

2 Answers

Where do i find the O2 sensor on a 1998 ford f-150 4.6lt truck


1998 Ford Truck F150 1/2 ton P/U 4WD 5.4L EFI 8cyl
The Oxygen Sensor is located under vehicle, passenger side, below seating area, rear of catalytic converter, mounted in exhaust pipe.

Application: Number three

Hope helps (rated this) Good luck.


Jan 12, 2010 | Ford F-150 Cars & Trucks

2 Answers

Firing order and timing count


1991 Ford Truck F150 1/2 ton P/U 2WD 4.9L FI 6cyl Firing order 1-5-3-6-2-4 10 Degrees 1991 Ford Truck F150 1/2 ton P/U 2WD 5.8L FI Windsor 8cyl Firing order 1-3-7-2-6-5-4-8 10 Degrees 1991 Ford Truck F150 1/2 ton P/U 2WD 5.0L FI 8cyl Firing order 1-5-4-2-6-3-7-8 10 Degrees

Jun 03, 2009 | 1991 Ford F150

2 Answers

Firing order


that is true your firing order is wrong here is a link to a web sight that has all the 1998 explorers 6cyl just click on the one that your explorer is and it'll show you the correct firing order also make sure you have your plugs gaped right good luck.
http://autorepair.about.com/library/firing_orders/bl-ford-firing-98.htm

Mar 22, 2009 | 1998 Ford Explorer

2 Answers

1998 ford motor swap 8cyl to a six inline


Unfortunately, You will need to Change it all. None of the V8 Components will Transfer to the Inline 6. Please Rate My Response! Thanks!

Feb 02, 2009 | 1998 Ford F150 Regular Cab

Not finding what you are looking for?
1998 Ford Expedition Logo

Related Topics:

147 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...