Got into a fender bender, driveline popped out and motor shifted forward how do i fix this? what does this mean? nothing works in my truck now

Minor fender bender ? Where , front , rear etc.... Could have damaged wiring harness , sometimes GM mounts the PCM - engine computer behind fenders , body parts etc...

9 times out of ten you half to replac them even if was a minor fender bender. The seat belt reel has a component the breaks and locks under a certain amount of load.

For car not changing gears it can be shifter assembly issue, or it can also be transmission issue. Get the shifter assembly inspected with ignition OFF.

For more troubleshooting, I suggest you to get the Following help link checked, its complete step by step procedure to inspect gear shift issues: -----

GEAR SHIFT ISSUES

http://alltypesofpartsreplacing.blogspot.com/2012/11/gear-shift-issues.html

==========

These will help.

Thanks.

You need to be a bit more specific when describing your problem. By "not getting any gears" do you mean (A) the shift lever will not move into position to select a gear?, or (B) shifts into gear position, but does not move? For (A), try reverse (it is not synchronized); Do you get a grinding of gears sound when you try to engage it? If so, this sounds like a problem with the hydraulic clutch release system. If it gets low on fluid, it will not release enough to let you put it in gear. top off the reservoir(tiny 1/2 cup sized one on driver side fender under hood below and to the right of the brake master cylinder) and frantically pump the clutch pedal about 100 times (that\'s right, 100!)
If the tranny goes into gear but the vehicle won\'t move, this sounds like either the clutch disc is worn too thin to grab, or something is broken in the driveline. Try locking the hubs and putting it into 4WD and see if it moves then. If so, then the rear wheel driveline or driveshaft has a problem. Good luck!
<Splinter, LA, CA 1990 Trooper >352,000 miles>

you need to have the car scanned for codes to be sure, but it is possible that one of the discriminating sensors was compromised in the fender bender. should be a fairly straight forward diagnosis and repair.

inertia switch

Turn the key to the on position and plug in a scan tool and scan the computer. use the trouble code and go to mitchell on demand and search the trouble code and the program will tell you what is malfunctioning and how to fix it.

Yes there is, but not sure if it has a reset button or different type.What did dealer say & where did they say it was?

In the front of the cherokee, right side under the bumper there is a football shaped plastic canister.
The canister is a resoiver for vacuum that control the heat and defrost doors. Either it is cracked from the fender bender or the body shop didn't connect the vacuum lines.

ford has a fuel cut off switch in case of a fender bender sometimes located in trunk or by pass floor board need to reset switch