Question about 2004 Jeep Grand Cherokee

1 Answer

My 2004 jeep suddenly started to stay in first gear foe about a mile before acting normally.. Any suggestions?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Jeep Master
  • 959 Answers

Check your trans fluid and make sure it is pink and clean ( not dark and burnt).
If the fluid is pink or red... then you just experienced a sticky valve body....

Posted on Sep 30, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does my 2004 Ford Taurus start but wont stay running if I let off of the gas or try to put it in gear?


I'd be checking the throttle linkage stop on the throttle body/carb. Sounds like the throttle plates are closing off completely when you let off the pedal. Throtlle adjustment screw may have just backed out also.

Jul 10, 2017 | Cars & Trucks

1 Answer

2004 Jeep Grand Cherokee temp gauge high when heat is on


If your "check engine" light is turn on, I suggest scanned the PCM to know exactly what fault code is stored there. Additionally, could be some problem with the "temp sending unit".

Keep us updated.

Jan 23, 2012 | 2004 Jeep Grand Cherokee

1 Answer

I have a 2004 Jeep Grand Cherokee Laredo 4x4 with the 4.0L. It has approximately 150k miles on it. I started the Jeep with 1/4 tank of fuel in it and it started rough and acted like it was going to die....


long post.
ill reduce it for you.
misfires. (is RPM below 700 then misfire can be normal) for idle speed controls dead.
ISC the isc controls speed, of idle,.
mine stuck like zillion times, in 400k miles. endless.sticking
mine was a tiny gutless stepper motor drive ISC valve.
the cone valve is side gets nasty and sticks (
(PCV gases caused as seen on all engines)
i clean it.
the proof is the easy press of right foot easy raises idle back to 700rpm and engine stops misfiring.
ever get a tuneup this decade or running spark parts 500,0000 miles
for the new world record.?


now the tricky part of ISC, , fully explained in the SM serv. man.
the PCM learns its behaviors.
it learns all hot start settings and cold
so when you key on, it goes to the correct HISTORICAL spot.
if it can move there(sticks) engine car race.
or run too slow,
cold start would be worse, as hot isc is more closed
so if sticks there closed, the next cold start will be horrid
some newer manuals telly you to add 5% throttle if car is hard starting this is so common.

clean it. end story.
ISC

Mar 09, 2017 | 2004 Jeep Grand Cherokee

1 Answer

I have a 2004 concorde 2.7 liters , i just washed the car , suddenly check engine light appears out , the car shifts fine within the early few minutes but later it wont shift to 3rd it stay on 2nd gear,...


Could be water that touched one of your electronics that makes your transmission having problems try to dry the Transmission electronic connectors with low air pressure and see whats happens.Good luck

Dec 13, 2010 | 2004 Chrysler Concorde

2 Answers

HOW MANY MILES SHOULD OIL BE CHANGED ?


5K kms or equivalence in miles.

Dec 13, 2010 | 2008 Jeep Liberty

1 Answer

04 Jeep starts but stalls when put into gear.


make sure your idle air control motor is working, if you give and hold gas pedal a little will it stay running in drive.

Oct 03, 2009 | 2004 Jeep Grand Cherokee

1 Answer

2004 Jeep Wrangler - Clunking Noise when shifting out of Park


It could be lash in the differential which is normal, but it could also be a loose u-joint in the driveshaft. Check the rear driveshaft u-joints.

Mar 12, 2009 | 2004 Jeep Wrangler

Not finding what you are looking for?
2004 Jeep Grand Cherokee Logo

Related Topics:

52 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...