Question about 1994 Chevrolet Suburban

1 Answer

The transfer case keeps slipping out of gear and grinding on my 1994 surban. any ideas?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 16 Answers

You will have to climb under and check linkage. plastic clips hold rods into place make sure they are not bent and pulling it out of gear.

Posted on Sep 30, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When shifted into gear the truck makes a loud grinding sound, sounds like its spinning freely and will not go anywhere any ideas? Could it possibly be the transfer case


well it is the gear they are slipping it happened to me once 2nd gear i dropped the transmission drive shaft first i popped open the tran pull gear put in new put back together if u in there u should get the clutch done too u have to drop tran too fix u mite as well but its a pain have someone else do it easier that way
25935194-m5rq34jlxxof5c0hetsdpeby-1-0.jpg

Nov 01, 2015 | 2001 Chevrolet Chevrolet Silverado 1500HD...

1 Answer

My 1987 GMC s15 automatic 4x4 pickup keeps popping out of normal gear. The only gear it stays in is 4 low. Where do I start?


I'm assuming you're talking about the transfer case popping out of 2 high or even 4 high. It could be that the transfer case needs a chain or gears replaced and is slipping on the cogs/gears. In 4 low it takes less pressure/strain to move the vehicle so it doesn't slip. I would put the trans. AND transfer case in neutral, with the FRONT wheels blocked, and NOT running, jack at least one rear wheel off of the ground, and try turning the rear drive shaft back and forth to feel the free play (free play in the transfer case, not the rear end). Excessive free play should tell you that the drive chain/gears are very warn and could be slipping. That would be a start.

Jun 08, 2014 | Cars & Trucks

1 Answer

Driving down the Interstate last week, just fine, suddenly it's like someone put the car in neutral. coasted to a stop, when i put in Park, there was a fine grinding, BUT car still wanted to roll down hill...


i would say the fine grinding was when you put it in park the output shaft was turning and the parking paw was trying to engage into park then the paw engaged into park but you say it rolled i am thinking that your problem is in the transfercase

Jan 11, 2010 | 1996 Jeep Cherokee

1 Answer

Transfer case grinding


its hard to believe 2 trucks with same noise. you really need to verify where noise is from. it could be the trans

Oct 18, 2009 | 1999 Chevrolet Silverado 1500

1 Answer

Slips out of gear (while driving)


sounds like the synco gears might be going in the tranny,they are only soft gears and gets damged easily campared too the rest of then or the forks are worn in the tranny they have nylon on the forks, and sometimes wears down as well

May 10, 2009 | 1987 Chevrolet Blazer

2 Answers

My 4x4 in my k1500 chev 1/2 ton makes a bad grinding noise in 4x4


chain can't slip, but if noise is definitely in t case, there is either an engagement problem or some serious internal damage!

Dec 27, 2008 | 1993 Chevrolet K1500

1 Answer

Transmission or transfer case noise


I have the same problem with my 94 explorer with a manual transmission, Just replaced the trans a month ago because of gear failure and now It's slipping out of gear when the engine isn't under load aka Coasting, was Told By a Really good Trans Guy that this is a failure in the Linkage in the transfer case am about to tear into mine tho It's way over my technical ability but will repost here after I get it torn apart with potential prices for worn parts for the do it yourselfer, And Has to be the issue I hope because the gears in the transmission are in pristine condition the other reason for suspecting the transfer case is that when my trans is slipping and making that weird Rattle Clatter sound coming from the trans if I put it in 4x4 low it drives great even tho the front wheels aren't pulling since I have the front drive shaft off at the moment,, Well Here goes Nothing Wish me luck on this teardown gonna need it..

Dec 27, 2008 | 1997 Ford Explorer AWD

2 Answers

1996 chevy K1500 transfer case slipping out of 4 wheel drive


Your trouble is most likely not in the transfer case but in the front differential engagement solenoid.

Dec 20, 2008 | 1996 Chevrolet K1500

1 Answer

Gear box


You will have to pull the gear box and the transfer case and determine the cause by tearing them dowm for inspection.

Aug 30, 2008 | 1995 Toyota Land Cruiser

Not finding what you are looking for?
1994 Chevrolet Suburban Logo

Related Topics:

122 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8195 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...