Question about 2003 Ford F250 Super Duty Crew Cab

1 Answer

Have 2002 diesel f250 and am replacing mirror but replacement mirroe has round plud and truck has rectangular i do not have an adaptor so how can i splice the wires new mirroe 3 wires black purple yello and old has 4 wire(2 yellow)black and red or blue i believe

Posted by on

1 Answer

I would guess, you take it back and get the correct mirror, wouldn't you agree?

Posted on Sep 30, 2010

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2002 Ford F250 deiselelectrical problems

I would reccomend you go back to the alternators again. Have it tested. There are many bad parts going over the counter these days, and I have replaced"new alternators" 3 times before getting a good one.

Apr 03, 2014 | 2002 Ford F250 Super Duty SuperCab

1 Answer

Ford F250 2002 7.3 Diesel won't start

check engine immobiliser and crank position sensor . Run fault codes and replace faulty units.

Apr 04, 2013 | Ford Cars & Trucks

1 Answer

2002 ford f250 super duty left side mirror installation try this website, hope it helps

Nov 19, 2011 | 2002 Ford F250 Super Duty SuperCab

1 Answer

Is there a special glue for the replacement of a rear view mirror or is there a special mount to get the mirror to on the window. We have tried twice with the adhesives and it fails because of the weight...

There is usually a allen head screw that holds the mirroe onto its mounting device, may have a snap on cover over it for cosmetic purposes. It can be found right were the metal peice attaches to the window on the side facing out. You must first stick the metal mounting bracket to the window, allow to dry for the recommended time the adhesive calls for then reinstall the mirror after it has has sufficient time to dry, tighten the screw, and replace any cosmetic covers after the mirror is rreinstalled. Good Luck!

Sep 15, 2011 | 2002 Jaguar X-Type

1 Answer

Replace drivers side mirror 2001 chevy tahoe,mirror only

To just replace the mirror glass there are a few different styles, but they all pull off. I suggest you wear gloves and glasses. Get a grip behing the glass and pull out. You should see a round circular bracket in the center. The new mirror just snaps into the bracket. Center new mirror and push evenly in the center of glass until it snaps into place. Dont push in by holding the edges, you'll break it. If you don't see the circle or it comes off with the glass it was too damaged for just glass. Power or manual mirros differ inside, but the mirror replacement is the same. If you mean the entire mirror only, remove door panel. Lower window, remove electrical connector if power, remove 3 bolts attaching mirror to door. Remove.

Jan 27, 2011 | 2001 Chevrolet Tahoe

1 Answer

Howdo i take off the passenger side mirror to replace it

mcdevito75 here, All or at least part of the inner door panel will have to come off, maybe a special tool needed to reove the inner panel, Let your local shop replace the mirroe.

Jun 17, 2010 | 2002 Ford F250 Super Duty SuperCab

1 Answer

Dash light came on, I have a 2002 f-250 7.3 diesel, light has arrows with 2 rows of dots, upper right hand part of dash light area

That light indicates that it is time to replace your air filter. After replacing the filter you will want to reset the lamp. On the air filter housing is a filter indicator. It is a small (2" round) cylinder with red, yellow and blue colors on it, as well as 2 wires. Push in the rubber yellow cap on top of the cylinder until you feel a snap and see the yellow plunger in the cylinder move. This should reset the light.
I hope this helps

Apr 10, 2010 | 2002 Ford F250 Super Duty SuperCab

1 Answer

Can you add heated mirrors to a 2002 F250 that just has remote mirrors now

yes there is a kit you can get from ford to replace your factory mirrors and the wiring is fairly simple.just ask for the kit the next model above your current truck with the options you are looking for and if the dealership doesn't offer it try going to an aftermarket supplier and ask for the heated power mirror kit and they can usually get a plug and play kit.

Dec 27, 2009 | 2002 Ford F250 Super Duty SuperCab

1 Answer

Ford 2002 f250 7.3 diesel won't start on cold mornings just replaced the cold start relay and still won't start...what else could it be?

It probably is your glow plugs which are controlled by the cold start relay. They burn out over time. This is normal. Haynes Diesel Engine Repair Manual, part 10330, will walk you through the diagnosis and replacement easily. It's about $20. Hope this helps.

Oct 05, 2009 | 2002 Ford F250 Super Duty SuperCab

1 Answer

Power mirror not working but no fuse blow

I don't know what your question is but if it is what fuse is for your power mirrors it is fuse #4 in your central junction box which is in the cab of your truck. Good luck.

May 05, 2009 | 2000 Ford F250 Super Duty Crew Cabs

Not finding what you are looking for?
2003 Ford F250 Super Duty Crew Cab Logo

Related Topics:

182 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers


Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides