Question about 2002 Chrysler Voyager

Open Question

I need to remove the roof liner in my 2002 chrysler voyager. seems to be an awful lot of wiring that has been glued to to moulded roof. does all this need to be pulled off or can i unplug the wiring loom some where ?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
dennymulford
  • 1055 Answers

SOURCE: locating a 2002 chrysler voyager thermostat

trace out the top raidtor hose where it goes too the block and thats where the thermostat is,

Posted on Mar 05, 2009

Ad
cbgarner
  • 138 Answers

SOURCE: how to remove injectors

Take the bolts out of the fuel rail and lift the fuel rail off the injectors then remove injectors

Posted on May 19, 2009

  • 715 Answers

SOURCE: I NEED TO FIND WHERE THE THERMOSTAT IS ON CHRYSLER

follow top radiator hose to engine where the hose hooks up is where the t-stat is .inside the housing connected to engine

Posted on Dec 17, 2009

  • 11 Answers

SOURCE: 2002 chrysler voyager deisel 2.5. Alarm problem

Check for things hanging inside or from rear view mir, it can cause movement trigering motion sensors

Posted on Feb 15, 2010

seanpwright
  • 2030 Answers

SOURCE: Installing roof mounted dvd system

The door control wire can be picked up from any of the doors light switches in the door jamms.

the ACC+ wire must connect to a source at the fuse panel that has 12 volts to it only when the ignition is turned on.

Posted on Mar 31, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1985 Dodge Power RAM 50, Head liner question.


The fabric and foam are one piece, it is then glued to the cardboard backing and that just site in the roof, no attachment needed.

Dec 01, 2016 | Dodge Cars & Trucks

1 Answer

Moon roof won't open on my 2002 bonneville sle


The motor and module is in front of the moon roof window, under the headliner. You can pull the liner down to work on it, but be careful not to pull it so far that it breaks. If the cables are broke or really loose, you have to remove the liner. Replace the regulator. Most times it is the module. It can be replaced without removing the liner.

Aug 31, 2014 | 2002 Pontiac Bonneville

1 Answer

My moonroof on my 2005 PT Cruiser will not retract. One side seems to catch on something as only one corner starts to move. The rear vent pop up works fine. How do I remove the window to check it?


you need to remove the head liner to inspect. try pushing down on the corner that is stuck while trying to open. a lot of the time the back of the roof gets wedged against the roof roof.lol. and it needs to go down before it will go back

Mar 13, 2013 | Cars & Trucks

1 Answer

How i fix window motor for chrysler voyager 2001


INNER DOOR PANEL OFF, 4? SCREWS, UNCLIP WINDOW GLASS,AND REMOVE FROM DOOR. MIGHT HAVE TO REMOVE SOME WINDOW TRIM MOULDING. UNPLUG MOTOR. 4 BOLTS, REMOVE REGULATOR AND TRACK, THEN REINSTALL EVERYTHING

Oct 13, 2012 | 2001 Chrysler Voyager

1 Answer

How do I access the wiring in the roof


Typically by dropping the head liner.They are large,ridged and don't bend .Most head liners are fastened anywhere you see something touching them,sun visors,grab handles,dome light housing.most of the time you should be able to do your wiring thing without completely removing liner,but if needed it could be done by dropping down at angle and sliding out through rear hatch.Be careful as they are very expensive to buy.

Oct 24, 2011 | 2002 GMC Yukon XL

1 Answer

I have a 2002 Chrysler Voyager that won't turn on even after replacing the gas filter, gas pump, and spark plugs. Do you know if anything else that is preventing it from turning on?


Immobilizer? Its likely to be the 21 pin plug behind the heater control panel. Remove the long plastic strip under the control panel (prise of gently, held on by 2 clips) remove 2 screws behind this and 2 screws above on panel. The whole lot should easily come away. There will be 3 plugs, remove all three and try to start the car. If it starts your problem would be the earth. Hope it helps

Sep 03, 2011 | 2002 Chrysler Voyager

1 Answer

How remove starter from 2002 voyager


Good day allen,
raise your vehicle high enough to slide under. make sure you support the vehicle when raised.
Now some voyagers have a plastic shield underneath for protection. Remove this shield.
Remove the positive from the battery, Make sure all your tools are near you. remove the wires from your
starter and take note how the are seated. With a ratchet, remove the two bolts.that hold the starter in place
Sometimes there is a shield near the Tranny/Motor which needs to be remove before you remove the started
When you get the new starter reverse this this letter

Jul 24, 2010 | 2002 Chrysler Voyager

1 Answer

Installing roof mounted dvd system


The door control wire can be picked up from any of the doors light switches in the door jamms.

the ACC+ wire must connect to a source at the fuse panel that has 12 volts to it only when the ignition is turned on.

Mar 31, 2010 | 2003 Chrysler Town & Country

1 Answer

At hiway speeds the top of th cab buckles due to the wind sounds like someone pounding on top of the cab there seems there is no support between the roof and the head liner.


I WOULD TAKE IT BACK TO THE DEALER ,BUT IF NOT ,YOU CAN PULL THE HEADLINER, AND WHERE THE CROSS BEAMS WERE NOT GLUED PROPERLY, USE A CAN OF GREAT STUFF FROM HOME DEPOT ETC, AND SPRAY IT BETWEEN THE CROSSBEAMS & THE ROOF ,ALLOWIT TIME TO EXPAND AND DRY BEFORE REPLACING THE HEADLINER ,YOU MADE NEED TO TRIM SOME OF THE GREAT STUFF OFF SO THE HEADLINER WILL FITS BACK IN PLACE RIGHT.

Dec 04, 2009 | 2008 Ford F-350

1 Answer

Rear View Mirrors Adjustment


The Chrysler voyager van you have has manual mirrors. If it would have power mirrors the controls would be mounted on the drivers side door or the dash panel beside the headlight switch.

May 28, 2008 | 2002 Chrysler Voyager

Not finding what you are looking for?
2002 Chrysler Voyager Logo

Related Topics:

123 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...