Question about 2005 Chevrolet SSR

1 Answer

My ssr engine will start but immediately within 2 seconds it shuts off

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 473 Answers

Chek for Fuel Filter and Pump.... Vacumm lost. and Idle sensor for contact lost during engine run Possibility gas line interuption
due to Fuel Pompe Damage

Posted on Sep 30, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 Nissan Sentra 1.8 has hard start acting lot not firing and finally starts and immediately runs great. .


Check fuel pressure after it's been sitting for a while. It should be within 5-psi of spec. If not, you have a bad check valve in the fuel pump.

Aug 02, 2017 | Nissan Cars & Trucks

1 Answer

Reset change oil light on a 2001 Saturn l300


I don't know the year of the vehicle so I'll give you 2 possible ways to reset it.

2004-2005

Turn the ignition to run (one position before starting engine).
Immediately after Step 1 press and release the gas pedal 3 times within 5 seconds. If the Change Engine Oil light is flashing, the system is reset. The light will flash for up to 30 seconds or until the ignition is turned off. If the light comes on again and stays on for 30 seconds at the next engine start, it did not reset. You will need to reset the system again.
Turn the ignition off and then start the engine to verify the indicator has been reset.





Turn the key to run, but don't start the car. Open up the underhood fuse box (move the coolant line out of the clips for easier access). In the fuse box is a button labeled "OIL-R". Hold it down for five seconds. The "change oil soon" light should flash for about 30 seconds or so. That means it's reset.

...


Sep 09, 2016 | Saturn L300 Cars & Trucks

1 Answer

Shut off the change oil lite in a 2011 ram gas petal trick does not work comes right back on when started


1) turn ignition switch to on position(do not start engine)-- 2) fully depress accelerator pedal slowly three times within 10 seconds -- 3) turn ignition switch to off position --- note if message illuminates when you start the engine the system did not reset. Repeat the process

Mar 06, 2015 | 2011 Dodge Ram Pickup 1500

1 Answer

My wife has a 2004 Freelander that starts, but then the engine immediately shuts down.


could be a sensor.My suggestion is have a scann preformed on it.. could be a few things...

Aug 16, 2012 | Cars & Trucks

1 Answer

2001 Chevy Silverado have replaced the fuel filter checked fuel preasure and it falls within specifications but immediately drops off to 0 psi while the the switch is on and the pump willnot represuri


I probably did not get your post clearly.
The pump gets power from the relay in the start mode, then if the engine does not produce any oil pressure the fuel pump power is shut off. That helps prevent a fire in a wreck.
You get about 3 seconds of power to the pump when you first turn the key on, then nothing if the engine does not start.
The pump is supposed to hold pressure after it stops pumping.
Is there a problem with the truck starting ?

Jul 19, 2012 | Chevrolet Silverado 1500 Cars & Trucks

2 Answers

I have a 1991 L98 Tuned Port Corvette. When I turn the key to the on position the fuel pressure reads 50psi but falls back to zero within 2-3 seconds and the car won't start. I can spray injector cleaner...


It could be a cam sensor. If the sensor isn't sending a signal to the computer then it will not allow the fuel pump to continue running after 2-3 seconds. Since you have spark and fuel pressure upon initial start this could be your problem.

Dec 17, 2010 | 1991 Chevrolet Corvette

1 Answer

I AM RESTORING A T020 MF. I REPLACED ALL WIRING AND IGNITION SYSTEM AND REBUILT THE CARBURATOR, AND ADJUSTED IT TO SPECS. I GOT IT TO START RIGHT AWAY AND IT SOUNDS GREAT. HOWEVER, IT WILL ONLY RUN FOR...


Ok a quick check. When the engine cuts out and you go for restart it dies within 5 seconds. Next time put the ignition at position 2 (on but not starting) and wait one minute, then start the car. If the engine again runs for 30 seconds before cutting off this tells you its is a fuel problem. If the fuel is supplied slowly it fills the carburettor fuel bowls and when the car starts it quickly uses up these local reservoirs of fuel faster than they can be replenished. When you try to restart immediately there is only a tiny amount of fuel and so it used up almost immediately. By leaving the ignition on 2 for while it gives the pump time to fill the carburettor bowls and this takes a while longer to run down when the engine starts. Just before moving on does the car have a choke OK remove the low tension connection to the coil, basically remove any chance of a spark. Put a big old towel around the carb. Now remove the fuel line at the carburettor and put ignition on 2 to engage the starter pump. Listen to pump operation and look at the rate of fuel being pushed from the disconnected fuel pipe. If the flow is slow check on pump and filters.

Sep 13, 2010 | Ford F-100 Cars & Trucks

1 Answer

02 Sienna, idling issue, new battery, alternator tested good


check for vacume leaks listen for a hissing sound if you here one but cant pin point it you can use a spray bottle of gas of can of ether both very flamable so be gentle and spray around the sound when the engine revs up theres your leak thats where i would start

Mar 08, 2010 | 2002 Toyota Sienna

Not finding what you are looking for?
2005 Chevrolet SSR Logo

Related Topics:

100 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8514 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...