Question about 1999 BMW 323 Series

1 Answer

2000 bmw 323ci

I have a problem with getting into m

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 4 Answers

I have the same problem getting into u

Posted on Jun 25, 2008

6 Suggested Answers

michigan man
  • 3533 Answers

SOURCE: does anyone have the alternator belt diagram for a

try this website to see if they have your car listed its www.autozone.com or stop by your local library to look at a Haynes auto repair manual for your car

Posted on Apr 27, 2009

  • 33 Answers

SOURCE: the light on the dashboard of my bmw 323ci wont go

get a new one

Posted on Nov 07, 2009

  • 5 Answers

SOURCE: I have a 2000 BMW 323ci . The car is over heating

check coolant level, might be a leak. most bmws have a water pump that uses a plastic impeller/propeller (dont know the technical name), but it breaks off the water pump shaft, and no coolant is circulated through the engine and radiator

Posted on Nov 25, 2009

jlisagearhea
  • 412 Answers

SOURCE: warning light with car and two head lights in rear

This is your rear parking/backup/taillight warning burned out bulb indicator.One or more of your rear lights is burned out.A simple bulb inspection and replace will take care of the trick.Hope I could help...

Posted on Dec 21, 2009

  • 82 Answers

SOURCE: i WANT TO KNOW HOW

Are you talking the expansion tank? If so - Drain coolant first by going underneath the car and take off the protective shield and unscrewing the blue plastic screw (make sure the car is NOT hot!), under the reservoir you'll see an electronic sensor - carefully twist is a 1/4 turn counterclockwise and gently pull downward to remove this sensor don't force it, you don't want to pay $150 to replace it. Disconnect the hoses on the top and bottom of expansion tank by pulling up the metal tabs upwards then pulling the hose away from the tank. I believe there are two or three screws which hold the expansion tank bracket in place, unscrew these and pull the bottom of the tank away from the radiator then lift upwards on the bracket (the bracket and expansion tank should then come out). Get the old expansion tank off the bracket and replace. You want to take off the bracket because getting a new tank on the bracket is a B*TCH!

Reconnect in reverse order.

Make sure to bleed the cooling system properly to remove air pockets (please use BMW coolant and distilled H20 in 50/50 mix - it's not the same as your Prestone or other mass produced coolants). Last replace the expansion tank cap because that might have created the expansion tank cracking.

Good luck and hope this helps

Posted on Dec 31, 2010

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replace rear light lens on 2000 bmw 323ci


open trunk and take out taillight assembly repair.

Dec 25, 2014 | BMW Cars & Trucks

1 Answer

Where is the compressor located on a 2000 BMW 323ci


I am assuming you want the air conditioner compressor BMW part number 64 52 6 910 458 for a 200 E46 323ci. Open the hood and look at the front of the engine where the belts are. There are two ribbed v-belts coming off of the crank shaft pulley located in the center of the engine down low. The longer belt (6PK x 1538) drives everything else (water pump, alternator). The short belt (5PK x 863) goes to the air conditioner compressor on the passenger side of the engine.

Jul 03, 2014 | 1999 BMW 323 Series

1 Answer

Location of cigeratlighter fuse on 2000 323ci bmw


Behind glove box there is a panel in back you can pull down to acess

Sep 29, 2013 | 1999 BMW 323 Series

1 Answer

Oil service light


No it's fine as long as it turn's off, if it stay on take it in for services.

May 13, 2010 | 2000 BMW 3 Series

1 Answer

Top wont go down in a 2000 bmw 323ci


check the trunk to make sure the space saving unit is lowered to the down poosition as it will not work when it is up

Feb 06, 2010 | 1999 BMW 323 Series

2 Answers

How often do i need oil change on a 2000 323i bmw?


Your car holds almost 8 quarts of oil and it doesn't need changing untill you drive 8,000 to 15,000 miles

Dec 24, 2009 | 2000 BMW 3 Series

1 Answer

Need a alternator belt diagram


My sincere apologies for the delayed response.
I am personally going back to answer your unanswered questions.

I do not know if you still need this information, but I am going ahead and answering it anyway. You may want to Print the Diagrams for future use.

I am also not sure if you have the 323Ci, 323i, 328Ci, or the 328i; however all Links display a variety of diagrams covering all of these along with the available options.

CLICK
on the following LINK. It has the Belt Diagrams you will need.
If you would: Before Clicking: Let me know if this helped you, or if you have any additional information or questions. Feel Free to contact me at FixYa.com!
Again my apologies...
http://www.2carpros.com/car_repair_information/year/2000/make/bmw/model/323ci/2000_bmw_323ci_drive_belt_routing_diagram.htm

Dec 21, 2009 | 2000 BMW 3 Series

1 Answer

Will an M3 e46 clutch fit my 2000 323ci bemmer


yes it will fit i have done it , if you wont to be sure get the diameter of the friction part and go to a automotive suply shop and get them to look in ther guide and it will have yor clitch size diameter

May 06, 2009 | 1999 BMW 323 Series

1 Answer

2000 323ci tractn ctrl lt comes on and stops power to rear wheels


THE LIGHTS COMES ON WHEN ONE OR TWO WHEELS STARTS SPINING (WHEN TERES NO TRACTION) ITS STOPS THE CAR FROM SPINING SO ITSTOPS POWER GOING TO THAT WHEEL.

MAKE SURE YOR TYRES ARE INFLATED RIGHT OR YOUR TYRES ARE WEARING OUT

Nov 14, 2008 | 1999 BMW 323 Series

Not finding what you are looking for?
1999 BMW 323 Series Logo

Related Topics:

154 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Fred Sops

Level 2 Expert

271 Answers

Al Clark

Level 2 Expert

290 Answers

Doberman

Level 2 Expert

246 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...