Question about 2000 Ford Contour

1 Answer

It fill like the transmission on my 2000 ford countour is sliping. is their any way i can adjust it

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 137 Answers

Sorry, but you'll probably have to take it to a good trans shop. I assume yours is an automatic - if you don't have the special tools and knowledge to deal with these things, don't mess with the innards!

Posted on Sep 30, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

****** is sliping


Usually there is only a reverse and low band.
You might check a shop manual that covers transmissions to see if there is anything you can do without tearing down the transmission.

Sep 22, 2012 | 2002 Honda Civic

1 Answer

My heater/ac fan doesn't work. Where is it located on the 2000 ford contour?


I have a 1999 countour, its up under/behind the glove box. There may be a soft panel covering the entire area.

Aug 24, 2011 | 2000 Ford Contour

1 Answer

MI have a 2000 ford mustang and need to check or fill the transmission fluid where do I find this? It is a manual transmission.


naughtyon904, Most manual transmissions have a drain plug (on the botttom) and a fill plug (on the side ) of the transmissions. You need to raise the vehicle with ramps and visually check the transmission. Find the fill plug and remove it. With your finger check the level of the oil. It should be at the top of the fill hole. Also, check with your local dealer to find out exactly what is in the transmission as it is usually gear oil and not transmission fluid that is used. They can tell you the exact weight of the oil to be used and if there are any additives. Good luck with this.

May 29, 2011 | 2000 Ford Mustang

1 Answer

How many quarts of transmission fluid goes in a 2000 ford explorer /


Hello there
abar_a.gif?v=72006
2000 FORD TRUCKS EXPLORER 5.0L 8-cyl Engine Code P

FILTERS
AMSOIL Ea Oil Filter.........EAO11
Wix Oil Filter.........51372
AMSOIL Ea Air Filter.........EAA122
Wix Air Filter.........46253
Wix Fuel Filter.......33595
Wix Trans Filter.....58955 [1]

[1] 4R70W

CAPACITIES
Engine, with filter..........5.0 quarts[1]
Cooling System, Initial Fill..........15.0 quarts
Automatic Transmission, Others Initial Fill..........3.9 quarts[2]
Automatic Transmission, 4R70W Initial Fill..........5.0 quarts[2]
Automatic Transmission, Total Fill
4R70W..........14.0 quarts
2wd ..........10.0 quarts
4wd ..........10.0 quarts
Manual Transmission, ..........5.5 pints
Differential, Rear..........5.7 pints[3]
Differential, Dana 35 Front..........3.6 pints[4]
Transfer Case,Full-Time 4WD..........2.7 pints

1. When refilling, remove dipstick to provide adequate venting and allow oil to flow into crankcase.
2. With ENG at operating temperature, shift through all gears. Check fluid level in PARK and add fluid as needed.
3. Fill to no more than 1/4 to 9/16" below fill plug hole.
4. Fill no higher than 9.5 mm or 3/8" below fill plug.


Aug 07, 2010 | 2006 Ford Explorer

1 Answer

My tran is sliping how much will one cost


Have you first had the transmission flushed and re-filled? COuld save you a bunch on a new transmission.
A reconditioned tran will be easy to find and cost will vary. Research online.

Mar 04, 2010 | 1997 Ford Taurus

1 Answer

Middle seat of 2000 Excursion moved forward, but now will not latch back in place It just keeps sliding back and forth.


It sounds like your latch has stuck on one side or the other. Get a flashlight and look under the seat, and at the same time pull on the handle that you use to move seat. Look for the movement of the seat adjuster, I bet that you have one that either sliped out of place, or some thing got between the adjuster and latch I.E. trash or one of your kids toys.

Sep 03, 2009 | 2000 Ford Expedition

1 Answer

My toyota 2000 camery clutch is sliping what can i do


hi there most toyota motor cars since way before 2000 are hydraulic clutches and as such can not be adjusted hope this is helpful regards JR

May 17, 2009 | 2002 Toyota Camry

1 Answer

My check engine light has been on \Replace cam sensor ?


The cam sensor and VCT sprocket is a fairly common problem on those cars and $1400 is a bit on the high side, but not terribly so. A new car might be in your future. If it runs ok, I would not worry about it though. The VCT adjusts timing for fuel efficiency and emmisions and won't hurt the car to drive. Though your fuel mileage and performance may suffer a bit.

Apr 13, 2009 | 2000 Ford Escort

Not finding what you are looking for?
2000 Ford Contour Logo

Related Topics:

97 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...