Question about 2002 Chrysler Town & Country

1 Answer

What is the small bent hose (approx 3/4 in diameter) that runs from the air filter box lid to the top of the engine right next to the oil fill cap? it is approx 14 in long...

Posted by on

  • jonfru Sep 29, 2010

    How would I find a part number for replacement, since is it split where it connects next to the oil fill cap? Did you mean to say "air cooler?"



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 51 Answers

It is an are cooler for the valves and cams.

Posted on Sep 29, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

There is a open ended pipe that runs above engine oil intake, the other end has a hose connected to it? mines leaking fluid thinking gas

Catch what is dripping and see if it smalls of gas, oil or water. Whatever it is I doubt it should not be open ended and should have a hose attached to it that goes somewhere.

Sounds a bit like an Oil Breather Pipe at that diameter.

Take a look at these.

Oil Breather Pipe Bing images

Jan 05, 2016 | 1997 Dodge Grand Caravan

4 Answers

Air does not come out of the ash vents

Check for cable or vacuum lines not opening the direction flaps.

Aug 26, 2014 | 1999 Chevrolet Astro

2 Answers

Code po456?

The code po456 is leak in the evaporative emissions system.
First thing to check is for a poorly installed fuel fill cap

or try the following

1. Loosten the worm clamps that connect the air box hose to the intake.
2. Remove the bolt holding the air box to the radiator support.
3. Remove the small hose that comes off the front of the air box and goes from the air box to under the intake, I beleive this is the AIR tube.
4. Remove the AIT sensor from the intake hose.
5. Pull up on the air box.

Once removed set the air box a side. Locate the two lines that are wrapped in flex loom and tied to each other that go under the air box. They go from the solenoid that is mounted right next to the horn, behind the right headlight, to the rear of the vehicle. Locate a small 2" rubber hose that connects the front line to the rear line under the air box. Most likely this small hose that connects the two lines has a crack in it because it has been stressed from being stretched over a metal tube. If you replace this, it should fix your 'small leak'.

Reset the code by disconnecting the ground to the battery for a few minutes.

Hope this helps

Mar 02, 2011 | 2003 Chrysler Town & Country

1 Answer

Where is the oil filter 2007 santa fe v6 not under plastic cover


It is located on the top of you engine compartment, under the hood, to the right (Driver Side) of the engine and left of your battery. You need to take off the plastic engine cover (two bolts and four screw nuts) to expose it. It is cylinder in shape with a black plastic cap, which screws off to show the oil filter. The filter is different than your normal one, it doesn't have a outside metal cover to it. It looks like a air filter but round. Also in the box with your new oil filter comes two "O" rings, one small and one big. The big one replaces the "O" ring at the top of the screw part of your black cap and the small one goes on the bottom of the same cap.

Take care.

Aug 27, 2010 | 2007 Hyundai Santa Fe Limited

2 Answers

Need to know what color wires run my mass air flow sensor in my 93 maxda mx3 1.8l should be 2 wires what color and where to find then

You can pick up a Haynes manual. They have all necessary diagrams in them, including electrical schematics.


Sep 15, 2009 | 1993 Mazda MX-3

1 Answer

Where is the ac drain hose

Normal 0 false false false /* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-parent:""; mso-padding-alt:0in 5.4pt 0in 5.4pt; mso-para-margin:0in; mso-para-margin-bottom:.0001pt; mso-pagination:widow-orphan; font-size:10.0pt; font-family:"Times New Roman"; mso-ansi-language:#0400; mso-fareast-language:#0400; mso-bidi-language:#0400;} -- open the driver's door
-- locate where the air conditioner blower box is attached to the passenger side of the firewall – see photo #1 – look to the immediate right at the top of the gas pedal arm
-- condensation flows toward the front of the vehicle through the firewall at the leftmost edge of the air conditioner blower box – drain channel
-- open the hood and stand next to the front wheel on the driver's side
-- look down at the firewall over the battery and to the passenger side of the brake master cylinder – see photo #2
-- locate the small diameter metal tubes running horizontally and attached to the engine compartment firewall
-- locate the hole in the engine compartment firewall panel behind the small diameter metal tubes
-- this hole leads to the drain opening in the air conditioner blower box mounted in the passenger compartment
-- follow the brake tubes as they run from under the vehicle and turn toward the front wheel on the driver's side
-- locate the hole in the engine compartment panel behind the brake tubes
-- insert a short length of stiff wire into the hole through the engine compartment panel to unblock the drain hole

Jul 11, 2009 | 2004 Mitsubishi Endeavor

1 Answer

Cannot get battery out of car

W/ flathead screwdriver loosen air intake hose clamp (this holds the the air intake tube to the filter box lid), pop open 2 spring clamps on Left and front of air filter box lid. Look for 4 plastic tabs on back of lid, u must push lid approx 1inch away from u to disconnect this tab type hinge, then lift it off. Disconnect air hose from top, remove top (lid, cover or whatever u want to call it!) remove air filter, the remaining housing (bottom of filter box) snaps in place, so u must give it a good tug straight up to remove. Ahhhh, I remember the good old days, when u just took out the battery. Don't feel bad though, recently had a Buick battery problem, it's located under the rear seat. And I wondered why this guy couldn't find the battery? good luck countrycurt0

Oct 13, 2008 | 2001 Chrysler PT Cruiser

2 Answers


There is an air box with 2 hoses one going to the intake and one underneath going to another airbox, loosen the clamps and pop off the hose to the lower airbox and remove the 2 10mm bolts holding the top one to the radiator support. There are 2 clips holding the lower box lid in place pop them open rotate the lid toward the rad and remove the old filter and replace it with the new one. The assembly is reversing the order to take it apart I had trouble with this the first time I did it also.

Jul 23, 2008 | 2000 Dodge Caravan

2 Answers

Hard to start

what about the starter?

Jun 12, 2008 | 1993 Volkswagen Jetta

Not finding what you are looking for?
2002 Chrysler Town & Country Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

80417 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides