Question about 1997 Toyota Celica
The washer motor is placed normally very near to the washer nozzles and can be behind the hood panels in line with the windshield wipers.
Posted on Sep 29, 2010
It is connected to the bottom of the windshield washer reservoir... under the hood.
Posted on Sep 29, 2010
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Tips for a great answer:
Feb 05, 2017 | Mercury Cars & Trucks
Dec 10, 2016 | 2006 Hummer H3
Nov 25, 2016 | 2003 Pontiac Montana
Windshield wiper system module / motor
Windshield washer fluid pump
Windshield washer fluid level switch
Instrument panel cluster (IPC)
ACC 15-amp fuse
WSW 30-amp fuse
Jan 04, 2016 | 2002 Pontiac Bonneville
Body control module (BCM)
Wiper 1 relay
Wiper 2 relay
Windshield wiper motor
Windshield washer pump
Windshield washer nozzles
Windshield washer solvent container
Windshield wiper arm and blade assemblies
Windshield wiper transmission
WIPER/SW 10A fuse
WIPER 25A fuse
The body control module (BCM) controls the wiper motor based on input from the windshield wiper washer switch. The BCM monitors the wiper washer switch through three separate signal circuits and a ground circuit. The windshield wiper switch high signal circuit is used to determine high speed wiper operation, the windshield wiper switch low signal is used to determine low speed, intermittent, and mist operation through the use of a resistor ladder, and windshield washer switch signal circuit is used to determine washer operation. The windshield wiper motor park operation is controlled by the BCM. The BCM recieves an input from the park switch to determine wiper blade position. When the wiper blades are at the bottom of the windshield glass in park position the wiper park switch will open and the circuit will be pulled up to B+ by the BCM. The park signal will be pulled to ground by the wiper motor park switch while the wiper blades are not in the park position.
The BCM controls the windshield wiper motor through two output controls, controlling two relays which determine the desired wiper speed, high or low
Diagnostic Trouble Codes (DTCs)
The body control module (BCM) monitors the voltage on the windshield wiper switch signal 2 circuit for diagnostic purposes. If the circuit is shorted to voltage while the driver is commanded OFF, the BCM will store DTC B3715. If the circuit is shorted to ground while the driver is commanded ON, the BCM will store DTC B3715. Refer to DTC B3715.
It would be best to have a factory scan tool to diagnose this problem . it would make it easier anyway .
Dec 05, 2015 | Cars & Trucks
Feb 20, 2015 | 2007 Ford Mustang Coupe
Jan 16, 2011 | 2004 Chevrolet Tahoe
Jan 05, 2011 | 1999 Mercury Mystique
Nov 09, 2010 | Chevrolet Colorado Cars & Trucks
Jan 04, 2010 | 1983 Ford Ranger
328 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: