Question about 2006 Pontiac Montana SV6

Open Question

I have a clunking noise in the back of my 2006 pontiac montana. I was wondering how to change the rear shocks or if it could be something wrong with the automatic rear levelling system

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 255 Answers

SOURCE: Cavalier rear suspension clunks

HI, this noise can be caused by worn shocks,even if the bushings look good, you can remove one of them and check if is hard to constracts ,if not they must be replaced,

Posted on Jan 04, 2009

  • 98 Answers

SOURCE: My 1999 pontiac montana rear sliding power door will not work

I went to bulldogsecurity.com and looked up the wiring diagram for this vehcle. However, prior to checking this part, I would check to see if you have a blown fuse. It doesn't hurt and only takes a few minutes. There should be a fuse for that either somewhere on the side of the dash or near the brake pedal area. If not it may be under the hood, but it should be inside the vehicle. You may have multiple fuse boxes. If it has (2) sliding doors it will have a wire for the auto doors in each kick panel (under the plastic trim/molding) when you open the door and look down you will see all of the trim/molding it should snap out or may be held in place with a screw or (2). Once you remove that you should see the wires. It says for the left side it is either light blue or black and the right side is definitely light blue. Trace this wire until you find out where it ends (the motor or switch to control the auto doors) Then test the switch/motor to see if it is bad.

Posted on Mar 02, 2009

michigan man
  • 3533 Answers

SOURCE: 2006 Pontiac Montana rear brake lights and signal

check the ground in the fuse link also take out the rear tail light lens and make sure you don't have a broken or damage wire on the socket itself

Posted on Mar 12, 2009

  • 1 Answer

SOURCE: clunking from front end

CHECK FRONT STABILIZER LINK KITS FOR PLAY.
ONE ON EACH SIDE ATTACHED TO STRUTS.

Posted on Apr 26, 2009

1ATony
  • 159 Answers

SOURCE: How do I install a rear wiper motor on 2003 Pontiac Montana?

Here's a great video that will show you how to install the rear wiper motor on a 97-05 Montana or Venture">

Posted on Mar 02, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you replace rear springs on a 2001 Pontiac Montana?


images for 2001 Pontiac Montana rear springs ..

Replace broken rear coil spring on pontiac montana - Fixya

www.fixya.com/cars/t3213136-replace_broken_rear_coil_spring_pontiac
Oct 17, 2009 - replace broken rear coil spring on pontiac montana - Pontiac 2000 ...Im having problems with my rear lighs on my 2001 pontiac montana, the ...

Sep 22, 2015 | 2001 Pontiac Montana

1 Answer

Pontiac G6 2006 GT 3.5 L Knocking noise in rear over bumps


the favourite place for that type of noise is the top plates which are situated just above the rear shock towers.to check this open the trunk,remove the carpetting around the shock towers and move the car in the rear up and down checking the plates at the top for any movement or noise.if either occurs change top plates

Nov 07, 2011 | 2006 Pontiac G6

1 Answer

My 2004 montana seems to have a bad shock in the rear. It vibrates after 55mph and feels like it jumps if you hit a pothole. Is this what it is?


this is what bad shocks do when they are worn out.have the rear suspension checked out first just in case something in the back is bad.if all okay then replace both rear shocks/struts.they act like this because there is no restriction in the hydraulic portion of the shock to keep the wheels on the road when hitting bumps.

Apr 27, 2011 | 2004 Pontiac Montana

1 Answer

2004grandam when driving over bumbs clunking noise in the rear end


the noise u hear would be the suspention the cold weather cuases the shocks not to push back out properly larger springs would solve the problem or new shocks

Dec 07, 2010 | Pontiac Grand Am Cars & Trucks

1 Answer

The back passanger wheel area seems to be making clunking noise's while the van is in motion,,,,,could it be a shock or something,,, ?


The noise you are describing does sound like a shock absorber,check and see if its just loose if its not loose then replace perferrabley both rear shocks but at least the passenger side.

Apr 07, 2010 | 1998 Plymouth Grand Voyager

1 Answer

I have a 2006 dodge ram 2500 diesel and just recently got a leveling kit for the front and new shocks installed...but NOW i notice a clunking noise when i drive...i have no idea what it is..and i am...


I would try to change it to the original factory setup which is the way it was before the dealer messed with it .See if that helps .
They did something wrong when they installed it .

Nov 24, 2009 | 2006 Dodge Ram 2500

1 Answer

Rear spring shock is broken on my pontiac montana van, year make 2002,is it easy to fix or how much will it cost,thank`s


I usually charge a base price on shocks and struts.to change shocks I charge around 30.00 or 40.00 dollars labor per pair.struts i charge 65.00 per pair.i'm cheeper than most guys because of the rural small town i live in here in alabama.but it may be your leaf spring not real sure by the discription,you could mean the shock,or the strut but it could mean the leaf spring which i think montanas have a shock and leaf spring set up not struts.i can't pull up my picture in my head too clearly,i've seen underneath hundreds of those vans just can't remember.hope i helped you with a price,don't let any body rip you off on the labor cause shocks are fairly easy to change.

Jul 05, 2009 | 2002 Pontiac Montana

1 Answer

Clunking from front end


CHECK FRONT STABILIZER LINK KITS FOR PLAY.
ONE ON EACH SIDE ATTACHED TO STRUTS.

Mar 22, 2009 | 2006 Pontiac Montana SV6

Not finding what you are looking for?
2006 Pontiac Montana SV6 Logo

Related Topics:

425 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...