Question about 1992 Toyota Camry V6

1 Answer

Over heating already replaced thermostat new radiator new bottom hose new water pump it is still over heating

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Mentor:

    An expert who has written 3 tips or uploaded 2 video tips.

  • Expert
  • 289 Answers

You seem to have done all posibilities. A test though to try would be remove the thermostat, put it back to gether with-out it and run the engine. Also, if you do that try it with the rad cap off so you can see if the water is circulating. It wouldn't if the water pump impellors are damaged.

good luck!

Posted on Sep 29, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My 2001 pt cruiser limited over heated. It has already had a new radiator and both fans replaced with in the year. Should i now replace the water pump which is the original?


Overheating is caused by:
1. plugged radiator core
2. Wrong mix of water and coolant.
3. Low coolant level.
4. stuck thermostat
5. hoses collapsing.
6. Air lock in system
7. Bad fins on water pump.

Aug 30, 2016 | 2001 Chrysler PT Cruiser

1 Answer

Why is lower radiator hose cold when motor is at operating temperature?


Ensure thermostat is installed right side up or it wont allow proper flow. If thermostat is correct other problems could be Air in cooling system, low coolant level, plugged rad internal, water pump failure,coolant flow valve stuck,internal engine combustion leak to cooling system.
Auto Repair Diagnostics How to Diagnose Cooling System Problem

Jan 16, 2016 | 2007 Ford Focus 2.0

2 Answers

2007 nissan exterra overheats


Hi Kim,

I can feel your frustration. It sounds like you've done all the logical stuff already. The "donut hole" in your process would seem to be not changing the water pump. The water pump as you might imagine, is responsible for circulating (pumping) the relatively cool water in the radiator into the running engine that contains the hot water. Hoses connect the two together. A thermostat is between the radiator and the engine. Once the water in the running engine gets to a certain temperature, the thermostat opens allowing the water pump to send cool water into the engine and hot water out to the radiator to be cooled. The heater core is usually on the passenger side firewall area.

It sounds like the water pump is the only thing left to change - if it isn't working - it can't circulate the water - and will result in overheating. Lastly, a clogged heater core shouldn't cause the engine to overheat - in fact, if the engine begins to overheat, you should turn the heat to HIGH fan and HIGH temperature to help remove some of the heat in the coolant.

Good luck!

Apr 11, 2014 | 2007 Nissan Xterra Off Road

1 Answer

2006 CHEVY COBALT OVERHEATING HAS NEW RADIATOR WATER PUMP AND THERMOSTAT


That is normal, it will not get hot without the thermostat. The water cools in the radiator and falls to the bottom and the bottom hose is cold. This is what cools the engine and stops it from overheating.

Oct 26, 2011 | Cars & Trucks

2 Answers

My car overheats very easy.i can drive 1 exit on the highway and the temp goes up very fast. i dont know what it could be. there is always fluid in the reserve area and doesnt seem to be getting low or im...


COULD BE THERMOSTAT IF TOP RADIATOR HOSE IS NOT HOT AND BOTTOM RADIATOR HOSE GOING TO WATER PUMP IS HOT THE THERMOSTAT STICKING PARTIALLY CLOSE.IF TOP HOSE IS HOT THE RADIATOR,ENGINE BLOCK HEATER CORE NEED FLUSHING OUT.IF WATER PUMP WEEP HOLE LEAKING REPLACE WATER PUMP, FAULTY WATER PUMP WILL CAUSE ENGINE TO OVER HEAT.REPLACE RADIATOR CAP MAKE SURE YOU HAVE 50 / 50 MIX SOLUTION ANTIFREEZE AND WATER IN COOLANT SYSTEM. IF ALL LOOKS GOOD CHECK ENGINE OIL ON DIP STICK, IF OIL IN DIP STICK LOOK LIKE MILKSHAKE YOU HAVE BLOWED HEAD GASKET THAT WILL CAUSE ENGINE OVERHEATING WHILE DRIVING CAR IN SHORT DISTANCE AND ENGINE OVERHEATING.

Aug 16, 2011 | 1999 Oldsmobile Alero

1 Answer

Over heating, engine only, just had radiator replaced


Thermostat, is where top radiator hose connects / it could be that it is air locked /also could be water pump after removing the thermostat you should be able to see if water pump is circulating. if it was a used radiator ? it could be just as bad as the one you just changed / Have it flow tested .gallons Pier. minutes. also mack sure no kinks in hose./ let us know .Thank You.

Apr 05, 2010 | 1999 Jeep Grand Cherokee

1 Answer

2002 dodge 1500 Changed radiator, thermostat, and hoses. No heat


Why was radiator replaced?Did it have heat before ? If it was plugged, the heater core may also be plugged. Try flushing it with a water hose in both directions. I dont know why the botton radiator hose would be cold, the radiator should be a uniform temp and the air coming through the radiator should be HOT, when the engine is at operating temp. What condition was the old coolant? if it was rusty, the water pump may have lower flow than normal.

Nov 19, 2009 | 2004 Dodge Ram 1500

2 Answers

1994 Honda Civic LX\overheating within 2 mile drive


Remove and raise upper hose at thermostat end and remove lower rad hose.
Fill rad with a hose and watch for flow from bottom rad hose and/ or bottom rad hose connecton.......water should fall though rad easily.
Honda rads are cheap.....any restriction....replace rad.

Remove thermostat....fill thermostat housing with hose and watch for water flow at bottom rad hose.
Flush good.

Remove heater hoses.......flush back and forth until a good flow is present "With heater control set to hot" if no or poor flow....replace heater core.

Stop leak can plug everything.

Also.......not likely causing over heating....but ....at your mileage,if you do not know if the timing belt has been changed.....CHANGE IT NOW!
Water pump is optional at this mileage.

Aug 23, 2009 | 1998 Honda Civic

1 Answer

Is it necessary to remove the thermostat housing in order to replace a water pump bypass hose? Mechanic advises that my 2000 Mountaineer's small by-pass hose is leaking. In order to replace it, either the...


in the upper radiator hose to the engine side of an elbow with 2 screws in there is the thermostat and water pump need to remove the fan belt clucht with the fan off the bottom hose that goes from the radiator to the pump to remove the screws remove the pump the pump clean the surface and install the new pump

Aug 07, 2009 | 2000 Mercury Mountaineer

Not finding what you are looking for?
1992 Toyota Camry V6 Logo

126 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...