Question about 1995 Isuzu Rodeo

1 Answer

I have to crank the ignition multiple times to get it to start. alternator, battery, spark plugs and wires, clutch have all been replaced

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 361 Answers

Start neutral switch is bad,try holding key in on position and pump clutch pedal should try to start

Posted on Sep 29, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Getting it to start


MAKE, MODEL, YEAR, PLEASE!!!!
Not only that, we need to know what's happening or not happening.

With what little you've given us, here are the possibilities.

Battery, battery wires, battery clamps, alternator, alternator fuse, regulator, starter, seized engine, lifters, crankshaft, camshaft, timing belt, timing chain, spark plugs, plug wires, distributor, fuel, fuel filter, fuel pump, fuel pump fuse, fuel injectors, fuel injector fuse, fuel injector relay, wrong key, key chip, key chip reading system, ignition switch, ignition switch relays, ignition switch fuses, multiple computers, in wrong gear, clutch not pressed, and I'm sure I missed a dozen more.

Sep 08, 2016 | Cars & Trucks

1 Answer

2001 jeep grand chorkee long crank times replaced crank sensor cam sensor and fuel pump cold starts only 4.7 engine


Car not starting or turning over indicates towards multiple possibilities. It can be issue with battery or weak battery. But if battery checks out ok, then it can be starter issue or faulty alternator or problem with low fuel pressure or no spark at spark plugs due to dirty spark plugs or faulty ignition coil or injectors getting cracked or dirty and needs to be cleaned.


To confirm the problem, the basic troubleshooting is required.


Click this link below and follow the troubleshooting:------

http://technoanswers.blogspot.in/2012/02/car-starting-issues.html

---------

This will help.

Thanks.

Feb 25, 2012 | 2001 Jeep Grand Cherokee

1 Answer

Water pump was leaking change the pump and timing belt now will not crank


Car not starting or turning over indicates towards multiple possibilities. It can be issue with battery or weak battery. But if battery checks out ok, then it can be starter issue or faulty alternator or problem with low fuel pressure or no spark at spark plugs due to dirty spark plugs or faulty ignition coil or injectors getting cracked or dirty and needs to be cleaned.


To confirm the problem, the basic troubleshooting is required.


Click this link below and follow the troubleshooting:------

http://technoanswers.blogspot.in/2012/02/car-starting-issues.html

---------

This will help.

Thanks.

Jan 28, 2012 | 2003 Chrysler PT Cruiser

2 Answers

Car wont run.


Does it crank well and all that but with no spark or is the battery just dead? If the battery is dead, it either won't charge while alternator is spinning or the alternator doesn't charge well enough to keep the battery charged well. If it jumps and runs indefinitely, battery is done. If it jumps and dies, alternator is done. If battery and alternator are fine, and you have no spark, you may need a new coil, new spark plug wires if they are worn out and too resistant, pick up coil inside of distributor, or you may have some other ignition system issue.

Most times when an alternator fails, it starts charging less and less till the car won't keep running or it won't start the next time. If the alternator hasn't failed, the battery needs replacing. If your battery is 5 or more years old this is a very good possibility. If your alternator failed and you have killed your battery many times before replace them both. Each time you drain a battery to dead you lose about 10% of its current capacity.

If the battery is fine and engine will not turn, starter may need replacing. Hope I helped.

Jan 30, 2010 | 1993 Jaguar Xj Series

2 Answers

98 dode ram wont crank no spark


May have no spark due to a bad crank sensor, which is responsible for spark when it gets a pulse through the cars' computer.

Apr 24, 2009 | Dodge Ram 1500 Cars & Trucks

2 Answers

The engine is cranking want start


check for fuel .? spray staring fluid into throtle body then crank if engine runs then stalls you have fuel related problem ( fuel pump) if no start you have ignition problem ( coil or distributor check for spark use a screw driver insert into spark plug wire at spark plug end hold about 1/4 away from gronded engine and crank engine see if spark jumps gap if no spark could be coil or crank sensor

Feb 26, 2009 | 1993 Subaru Impreza

2 Answers

Car will not crank sometimes unless you turn the key many times.


Check battery connections. Sometimes a weak connection will fail under very high loads like starting.

Feb 03, 2009 | 2001 Ford Escort ZX2

1 Answer

My hyundai santa fe


Hi! i think you must describe more problem symptoms;
DESCRIPTION The starting system includes the battery, starter motor, solenoid switch, ignition switch, inhibitor switch(A/T), ignition lock switch, connection wires and the battery cable. When the ignition key is turned to the start position, current flows and energizes the starter motor's solenoid coil. The solenoid plunger and clutch shift lever are activated, and the clutch pinion engages the ring gear. The contacts close and the starter motor cranks. In order to prevent damage caused by excessive rotation of the starter armature when the engine starts, the clutch pinion gear overruns. http://hmaservice.com/viewer/dispimg.asp?path=/data/Passenger/HY/HMA/ENG/SHOP-images/HY-SM13-IMAGES-ENG/ebkd010a.gif INSPECT SPARK TEST 1. Remove the spark plug cable. 2. Using a spark plug socket, remove the spark plug. 3. Remove the ignition coil. 4. Install the spark plugs to each spark plug cable. 5. Ground the spark plugs. 6. Check is spark occurs while engine is being cranked. 7. Using a spark plug socket, install the spark plugs. 8. Install the spark plug cable and ignition coil.

May 24, 2008 | 2002 Hyundai Santa Fe

1 Answer

Seems battery being drained


Q1. Engine will not start or is hard to start (Cranks OK) A1 -Ignition lock switch faulty -Ignition coil faulty -Power transistor faulty -Spark plugs faulty -Ignition wiring disconnected or broken -Spark plugs faulty Q2, Engine will not crank A2. Battery discharged Battery cables loose, corroded or worn out Transaxle range switch faulty (Vehicle with automatic transaxle only) Fusible link blown Starter motor faulty Ignition switch faulty Ignition lock switch faulty REMEDY Charge or replace battery Repair or replace cables Adjust or replace switch Replace fusible link Repair starter motor Replace ignition switch Replace ignition lock switch

May 20, 2008 | 2000 Hyundai Accent

Not finding what you are looking for?
1995 Isuzu Rodeo Logo

156 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...