Question about Nissan Frontier

1 Answer

Steering fluid level below normal level - Frontier Nissan Cars & Trucks

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 71 Answers

Add fluid

Posted on Sep 29, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 Buick LeSabre power steering dip stick. Where is it?


The power steering fluid level is indicated by marks on a fluid level indicator. The fluid level indicator is located on the fluid reservoir cap. Inspect the fluid level when the engine compartment is cool. Ensure that the fluid level is at the FULL COLD mark. When the engine compartment is hot, ensure that the fluid level is at the HOT mark.

Located on back side of engine below the alternator

Feb 08, 2017 | 2000 Buick LeSabre

2 Answers

How to add power steering fluid to 2008 pontiac g6


If you can't find a power steering fluid reservoir under the hood in the engine compartment your G6 could have Electronic Power Steering . If you look up under the dash below the steering column you will see a electric motor mounted to the steering column !
The power steering system reduces the amount of effort needed to steer the vehicle. The system uses the powertrain control module (PCM), body control module (BCM), power steering control module (PSCM), discrete battery voltage supply circuit, steering shaft torque sensor, steering wheel position sensor, power steering motor, driver information center (DIC), and the serial data circuit to perform the system functions. The PSCM and the power steering motor are serviced as an assembly and are serviced separately from the steering column assembly. The steering shaft torque sensor and the steering wheel position sensor are not serviced separately from each other or from the steering column assembly. The steering column assembly does not include the power steering motor and module assembly.

Jun 23, 2015 | 2008 Pontiac G6 Sedan

1 Answer

Leaking power steering fluid out of filler neck


You must check the fluid level for overfill.... preferably with cold fluid (about 3 hours of no driving, or better, overnight) and see if the level is higher than the "cold level" mark. If you recently add fluid (and the reservoir was empty) you must purge air from the system (frequently this is made with preferably cold fluid, turning the steering wheel stop-to-stop, side-to-side, about 2 times). If the steering fluid is high, drain it to obtain the normal level and then do the purge sequence. Hope it helps.

Feb 04, 2014 | 2010 Ford Transit Connect

1 Answer

1992 lexis car replaced thepowersteering pump now it won't turn at all


bleed power steering with engine off pour power steering fluid in the power steering reservoir until fluid stay at full mark on powersteering pump dip stick.wait few minutes then check powersteering fluid again if low add little more when fluid level stop dropping crank vechicle turn steering left to right with out a stop turn steering wheel all the way to the left to all way to right for minute until air bubbles leave the powersteering fluid. when steering wheel feel normal stop engine check check power steering fluid should be at full hot mark if fluid level dont drop air is out the system. dont overfill powersteering reservoir if so you will blow front seal.dont drive vechicle if steering dont feel normal have vechicle towed in garage.

Sep 15, 2012 | Cars & Trucks

1 Answer

Adding power steering fluid


Locating the Power Steering reservoir and adding PS fluid. 1999 Pontiac GP


  • The reservoir is clearly visible in the engine bay on the 3.1 litre engine cars.
  • For the 3.8 Ltr engine cars, use a flashlight to look down past the alternator for a black cap with a steering wheel printed on it to indicate the power steering fluid reservoir. ( passenger side of the vehicle).
  • Remove the cap of the power steering reservoir, clean the dipstick, re-insert and remove again to check the fluid level. If the level is at or below the low level mark, add fluid slowly, taking care not to fill above the MAXIMUM mark. It's best to add small amounts and re-check the level as you go to ensure you do not overfill the reservoir above the MAX level.
  • ONLY use the power steering fluid recommended for that vehicle by GM.



  • Dec 03, 2010 | 1999 Pontiac Grand Prix

    1 Answer

    WeMy power steering fluid was leaking I tool it to the shop they told me It was the pump so I brought a new pump and got It put in and now I still cant turn my steering wheel


    HEY DO THIS,YOU NEED TO BLEED SYSTEM. TO BLEED POWER STEERING SYSTEM.TO DO THIS.FILL THE POWER STEERING RESERVOIR TO COLD FULL MARK ON DIP STICK.WAIT A FEW MINITES,FLUID LEVEL DROP ADD MORE FLUID UNTIL REACH COLD MARK ON THE DIP STICK..WAIT FEW MINUTES.START ENGINE LET IT RUN FOR 2 OR 3 SECONDS.TURN OFF ENGINE CHECK POWER STEERING FLUID ADD MORE FLUID.DO THIS UNTIL FLUID LEVEL STOP DROPPING.WHEN FLUID LEVEL STOP DROPPING.SAFELY RAISE FRONT OF THE VECHICLE UNTIL FRONT WHEELS DONT TOUCH THE GROUND.START ENGINE UP.TURN THE STEERING WHEEL GENTLY FROM STOP TO STOP,CHECK THE RESERVOIR FLUID LEVEL LOOKS GOOD TURN OFF ENGINE LOWER VECHICLE .LOWER VECHICLE TO GROUND. LET VECHICLE SET FOR 2 MINUTES CHECK POWER STEERING FLUID LEVEL.IF STILL LOW ADD LITTLE MORE.TO THE COLD FULL MARK ON DIP STICK. DONT OVER FILL BECAUSE FLUID LEVEL RISES WHEN IT GET HOT.WHEN DONE IF STEERING WHEEL STILL FEEL HARD TO TURN YOU SEE AIR BUBBLES IN FLUID THATS WHEN FLUID HAS A TAN LOOKING COLOR WAIT 5 MINUTES AND.REPEAT THE BLEEDING PROCESS. DONT DRIVE OR OPERATE VECHICLE ON HIGHWAY UNTIL POWER STEERING HAS NORMAL OPERATION.

    Sep 26, 2010 | 1999 Oldsmobile Alero

    1 Answer

    Directions of how to change a power steering pump


    Removal/Installation
    1. Disconnect battery ground cable.
    2. Disconnect inlet and outlet hoses from pump.
    3. Remove serpentine belt guard as necessary.
    4. Remove belt from pulley, using 1/2 inch breaker bar.
    5. Remove coolant recovery bottle as necessary.
    6. Remove pump assembly.
    7. Transfer pulley as necessary.
    8. Reverse procedure to install, them bleed power steering system as follows:
      1. Turn wheels all the way to left.
      2. Add power steering to Cold mark on fluid level indicator.
      3. Start engine and run at fast idle, then add fluid, if necessary, to bring level to Cold mark.
      4. Bleed system by turning wheels from side to side without hitting stops. Keep fluid level at Cold mark.
      5. Return wheels to center position and continue running engine for 2-3 minutes.
      6. Road test vehicle to ensure steering functions normally and is free of noise.
      7. Check fluid level and ensure level is at Hot mark after system has stabilized at its normal operating temperature.

    Aug 19, 2010 | 1992 Oldsmobile Cutlass Supreme

    1 Answer

    When I turn steering i get a graon from the power steering reservoir


    Hi. Check the Power Steering fluid level. Usually you will be hearing a groan if the fluid level is low. If fluid is normal then you still getting the groan, i advised you to check the power steering mechanism. It could be the bearing inside that is having the problem.

    Aug 09, 2010 | Volvo S70 Cars & Trucks

    1 Answer

    Where is the power steering reservoir located on the 1990 Toyota Carolla?


    Make sure that your vehicle is parked on a level surface and the engine is cool before you check fluid levels. Power steering fluid and other fluids read at different levels when warm instead of cool. Locate the power steering fluid reservoir. It is located under the hood of your Toyota Corolla on the passenger side next to the engine. The reservoir is connected to the power steering pump. Remove the cap and use the dipstick to check the fluid level. For the most accurate reading, clean off the dipstick with a rag first, then re-insert and remove for the fresh reading. Add automatic transmission fluid or power steering fluid approved for use in Toyota vehicles if the fluid is below the low level mark. Add fluid gradually to keep for over filling the reservoir.
    this will help.thanks.

    Feb 20, 2010 | 1990 Toyota Corolla

    1 Answer

    Power steering fluid level


    most power steering caps have dipstick attached to the lid,and show a level for warm and cold, if not check the level is approx 1inc below neck...

    Oct 10, 2009 | 2003 BMW 325

    Not finding what you are looking for?
    Cars & Trucks Logo

    Related Topics:

    18 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Nissan Experts

    yadayada
    yadayada

    Level 3 Expert

    75807 Answers

    Phil Lovisek
    Phil Lovisek

    Level 3 Expert

    713 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22133 Answers

    Are you a Nissan Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...