Question about 1994 Mazda Navajo

1 Answer

Where does the 4 wheel drive indicator plug insert in to the transmision

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 32 Answers

On the back side of the transfer case just above the harness clamp.

Posted on Sep 29, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I convert a 2wd Dodge transmissio to a 4wd


The transmission has nothing to do with the truck being 2 or 4 wheel drive. The output of the trans connects to a transfer case. The T C supplies the front & the rear wheels with power. All you would need to do is a normal transmission swap. A 2 wheel drive truck would just have a drive shaft vs a TC.
26114547-udpjxge305qjxfwojgj4ptwt-2-0.jpg

Mar 01, 2016 | Dodge Cars & Trucks

1 Answer

Where do i check the level of fluid on a manual transmission in a 94 dakota with3.9l


on the side of the transmision is a plug on the midle of the transmision remuve plug and insert your finger to ck

May 26, 2015 | Dodge Dakota Cars & Trucks

1 Answer

Over drive light keeps blinking on a 97 ford


need to scann the transmision posible transmision damage or bad s od switch

Oct 14, 2014 | Cars & Trucks

2 Answers

Replace carrier bearing differential


4x4 mean 4 wheel drive, it could be all time 4 wheel drive or u can engage into 4 wheel drive, the vehicle have to be equipped with that.

Nov 02, 2013 | 1998 Chevrolet Tahoe

1 Answer

Were is the transmision check in the engine


It's small, only an inch across so look hard. FRONT Wheel Drive: Check to the sides of your engine. REAR Wheel Drive: Check in back of your engine next to the firewall.

If the vehicle has a manual transmission there is no dipstick. When fluid is filled or changed. It is usually pumped into a removable plug on the side of the tranny until it starts to come out of another plug a little higher up on the tranny. In some older model you had a drain plug and a side plug. you would just fill it until it started to come back out of the side plug.

I hope helps.

Oct 05, 2010 | 1996 Toyota Camry

1 Answer

Location speed sensor cherokee 2006


If it is a four wheel drive it will be on the transfer case,
If two wheel drive it will be on transmission,it still looks like where a speedometer hookup,but it will have a sensor with three wires now

Jan 11, 2010 | 2006 Jeep Grand Cherokee

2 Answers

How do i check my transmission fluid? for a 2000


Set the parking brake and put a block on at least one wheel. Pop the hood and find the Transmission dipstick. Start the engine and shift the gear shift into neutral. Pull the dipstick, wipe it with a clean rag, put it back in, pull it out and read it.

Oct 20, 2009 | 2000 Pontiac Grand Am GT

2 Answers

98 Dodge 1500 problem codes indicate mulitpule misfiring


This could be your problem. If this is not it then email me at chuckie12_87@yahoo.com and I can help you to troubleshoot it a little more in depth

Jun 12, 2009 | 1998 Dodge Ram 1500 4WD

1 Answer

Need help fitting a clutch on a VW GTI Golf


undo centre wheel hub nut 30mm/32mm, socket. undo lower wish-bone outer bolts, disconect battery,/remove starter motor,/remove transmission mounting bolts to body frame ,/ remove all surrounding bolts around bell housing transmission,/ remove clutch cable from transmission,/ remove drive shafts from centre hub and transmission,/ make sure car is standing on axle stands at front of jacking points,/use a trolley jack to suport engine sump with a piece of wood,/ slide transmission away from flywheel,/lower transmision on floor,/undo all clutch plate preasure bolts 10mm,/remove thrust bearing located on centre transmision shaft ,.also make sure if fitted speedo cable needs to be removed.new clutch plate should indicate flywheel ,without fitting clutch plate wrong way round/otherwise transmision will not bolt to engine block.,

May 17, 2009 | 1999 Volkswagen GTI

1 Answer

(!) A Light like that went off and my steering well got stuck!?


hello this the indicator for a transmision fault or problem /the pulling motion you felt could be a harsh shift from the transmision when you were coming to a stop . if the light is on the vehicle should feel slow when driving off because when this light is on the transmision will go in to felsafe mode and will actualy shift its self to 4 gear to give you a high gear for highway use . you should take the vehicle to a certified bmw shop or mecanic to have it check out , dont used it in fellsafe mode this could damage the transmision internaly and that will become a $ problem ,.

Nov 15, 2008 | 2003 BMW 325

Not finding what you are looking for?
1994 Mazda Navajo Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8560 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...