Question about 1997 Dodge Intrepid

1 Answer

Transmission not shifting into high gear

Hi, just started yesterday. Apparently it's staying in 3rd gear, cause when I drop it down nothing changes. I got a code 45 but AutoZone couldn't help me, i needed a P code. i found a 45 online that says "turbo boost limit exceeded (engine was shut down by logic module). Don't understand what that means. Car runs fine other than that.
thanks, C Brown

Posted by on

  • ceebee1 May 24, 2008

    Hi, no I sure didn't. But will check it out. thanks.

  • ceebee1 May 29, 2008

    Just wanted to pass this info on. The problem with the shifting turned out to be a circuit problem. Something had gotten under the hood and chewed through the wires. I taped them together, and so far so good.

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 359 Answers

Have u checked the gearbox solonoid?

Posted on May 24, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Won't drive or shift in 3rd gear but will reverse first and second gear


If it won't shift to 3rd and stays in second, bad shift solenoid/s. If it shifts and the transmission drops out(high RPM's), the bad clutches in the transmission. Rebuild. Solenoids around $600 to replace. Transmission rebuild around $2200.

May 06, 2016 | 2002 Buick LeSabre

1 Answer

92 dodge ram 150 not shifting


Two things happen on the Dodge's. 1. the rear O2 sensor shorts out and meses things up. 2. the Inner seal on the Direct drum (3rd) shrinks and causes a delayed up shift.

Aug 05, 2008 | 1996 Dodge Ram 1500 Club Cab

1 Answer

How to fix ram 1500 2005 transmission that sometimes gets stuck in 3rd gear. from start to finish truck will stay in 3rd gear.


When did you last replace trans filter and fluid? Dirt may be causing shift valve to stick.

Dec 28, 2014 | 2005 Dodge Ram 1500

1 Answer

2002 chrysler sebring transmission


Drive it slowly to a reputable transmission shop. There is nothing you can fix yourself.

Oct 02, 2013 | Cars & Trucks

1 Answer

1997 gmc 1500 went to start and tach and speed odometer not working and transmission shifts in hard and wont shift down stays in like high gear


Check transmission fuse its the one labeled PRNDL or similar.Use a test light when you check it by the way.If the fuse is good then its probaly your ignition switch failed.If that fuse is bad or the ignition switch is not suppling power to that fuse your tack,speedo,and gear indicator wont work, and your transmission will go into a safe mode.Safe mode is just the transmission staying in 3rd gear all the time until you fix this.

Aug 26, 2011 | 1997 Chevrolet K1500

1 Answer

I have a 1993 f-250 u have to manually shift to 1st to take off shift to 2nd and still in 1st gear. Shift to overdrive and transmission will shift through 2nd 3rd 4th and then to overdrive with no problem....


When was last trans fluid & filter change? Should be done every 30k/3 years or sooner of you do any towing. I'd start there and get it flushed thoroughly.

Mar 16, 2011 | Ford F-250 Cars & Trucks

1 Answer

Wont shift into drive


Have you changed the fluid & filter lately? Start there, much cheaper fix than anything else.

Sep 28, 2009 | 2003 Chevrolet Tahoe

1 Answer

2004 mazda 3 transmission problem


Check transmission fluid. If that is full, try changing the fuel filter. It could be starving for gas, and trying to shift but can't. It could also be the speed sensor, or shift solenoid.

Jul 06, 2009 | 2005 Mazda 3

1 Answer

Transmission problem in E230 Benz


What you need to check is the transmission release bearing because if there is a clearance on the release bearing you will encounter this problem and also check the transmission oil.

Jun 08, 2009 | 1996 Mercedes-Benz E-Class

2 Answers

95 isuzu rode0-starts in high gear


try replacing the altonator low voltage will not let it shift.also a stoped up exaust system will cause the same problem.

Dec 12, 2008 | 1995 Isuzu Rodeo

Not finding what you are looking for?
1997 Dodge Intrepid Logo

Related Topics:

163 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...