Question about 1995 Ford Explorer

1 Answer

Engine stalls After recent head gasket repair.Engine stalls randomly

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 359 Answers

Check the timing belt has been fitted correctly and that there is no damage to your valves

Posted on May 25, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Guage showing overheat and locking up 2011 nissan urvan


steam from exhaust means engine burning water/anti-freeze -more than likely your head gasket went when your vehicle overheats [radiator not cooling] every thing else gets hot and over heats-- your transmission cooling lines are connected to radiator so your transmission will overheat ---also burning water/antifreeze messes up the power that the engine produces very low and or stall condition so vehicle wont want to move --dont drive vehicle in this condition you might get lucky and could by just a gasket change [can also be an intake gasket] but if continue you can seize engine making a repair turn into an engine replacement as well as damanging transmission

Apr 23, 2014 | 2004 Nissan XTerra

1 Answer

I recently had over heating problems in my 98 cavalier 2'2 liter. witch was because my heater core went out. But I kept driving it, so I blew my head gasket.I replaced hear gasket And heater core. Now its...


run fault codes and check for mechanical problems . If you did not have the head machined before replacing the gasket then have a compression test done as you may still have a compression / gasket problem

Nov 15, 2013 | Cars & Trucks

1 Answer

Blown head gasket


Well it would really depend on the condition of your engine.
It would take more labor to repair your engine than it would to just replace it. But unless the engine is very damaged it should be cheaper to have your engine fixed. And replacing the head gasket and having the head repaired should be under the price you were given. A head gasket set for a 4 cyl engine is around $100 wholesale.
I would call around and check with other shops next.

Jul 17, 2013 | Nissan Cars & Trucks

2 Answers

Coolant mixed with oil


You have a blown head gasket,call around to find a good mechanic to fix,may be more than a head gasket.Here's the cost to repair,dealer is 821.23,shop mechanic is 665.95 and do it you self is 53.18,takes 6.9 hours for both shops and 8.8 for the do it yourselfer.Prices will vary.

Jan 20, 2013 | 2004 Dodge Stratus

1 Answer

E52,F32,F48 codes are displayed cars stalls on the move or sitting still after running for a little time when running and stall occurs the speedometer flips back and forth a few times the check eng. and...


Sounds like an electrical problem. Check connections to battery remove & clean them , check + wires to engine, to power supply for the engine management.

May 29, 2011 | 1991 Cadillac DeVille

1 Answer

1994 Chev Cavalier - engine light comes on randomly


One cause of the light to come on randomly is a loose gas cap. If it's not replaced tightly (turned until it clicks three or four times) it throws the light on. It's one thing to check anyway.

Nov 30, 2009 | 1994 Chevrolet Cavalier

2 Answers

White coloured engine oil, overheating


White oil means water or coolant is leaking in via Head Gasket Failure or a crack in the head. Along with repair - be sure to have each cylinder compression tested to see if there is a crack that has developed. Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.

Jun 09, 2009 | 1991 Toyota Pickup

1 Answer

In my chevy s10 the oil pressure drops and the engine stalls


Possible warped cylinder head, or cyclinder head gasket.

Jan 09, 2009 | 2001 Chevrolet S-10

1 Answer

Flashing Check Engine Light 99 Camry


light flashes when comp. picks up a skip pull code and it will be po300 random miss p0301 p0302 p0303 p0304 all are for that # cyl that has the miss best bet change wires and plugs check for oil on wire to plug end in spark plug hole leaking valve cover gasket or spark plug tubes...

Dec 31, 2008 | 1999 Toyota Camry

2 Answers

1992 galant 2.0L, car runs for approx. 30-45mins. then stalls out, and runs on one or two cylinders. We recently changed distributor cap and rotor, and ignition coil. no luck yet! battery is nice and clean...


sounds to me that the rings on the piston are worn out with the engine warmed up the cylinder expands a little causing blow by take the oil cap off and see if there is excessive blow by

Dec 02, 2008 | Mitsubishi Galant Cars & Trucks

Not finding what you are looking for?
1995 Ford Explorer Logo

Related Topics:

111 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...