Question about 1998 Volkswagen Beetle

1 Answer

Where is the crank pos sensor located on 1998 beetle 2.0 4cyl

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 2,272 Answers

Crankshaft Position Sensor. It's located just under the oil sender on the bottom front of the engine. Crankshaft position/speed sensor is an induction coil that goes into a hole in the side of the block and monitors a notch or bump on the crank for crankshaft position. It is held in by one small bolt....unfortunately, you have to pull the front motor mount bracket so you need to pull starter motor mount etc. to get it out of the block. Not a 5min job, but doable for anyone who knows his/her way around a basic tool box. Need to support engine while the front mount is off.-------------- Thanks. Keep updated for any more query. You can rate this solution and show your appreciation.

Posted on Sep 28, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1998 vw beetle 2.0 standard code p0322 chk engine speed sensor it chks good changed plugs and it stalled again


Resecure loose wire or connectors - If battery charge is low, recharge or replaced battery - Replaced crank position sensor - Replaced starter motor

Dec 16, 2013 | 1998 Volkswagen Beetle

1 Answer

1998 volkswago beetle, 2.0 litre engine. oil light stays on! oil level is fine. what,s wrong???


in picture sending unit screws in brass fitting just under and to the left of the distributor
22194211-t35fnqlfllluxki2iugbxdmw-4-0.jpg

Dec 14, 2013 | 1998 Volkswagen Beetle

2 Answers

Crank sensor for 1990 toyota pickup location


Hi, Located in the bell housing, sensor for the crankshaft gear!

Jun 15, 2011 | 1990 Toyota Pickup

1 Answer

Truck quit running, is getting fuel, spark, timing is dead on, local shop said it may be crank pos sensor or cam pos sensor,where are they located/


Very possible. I would check the sensor with a meter. I would say it most likely the crank shaft sensor. Some are located behind the pulley area and some are located at the back of the engine where the transmission meets the engine. Good Luck

Mar 04, 2011 | 1994 Dodge Ram 2500

1 Answer

Where is the coolant temperature sensor on a 1998 beetle located


In the temp sensor housing on the right side of the cylinderhead which has either a square 4 pin blue sensor or a semi rounded four pin sensor which can be black or green, the green ones are the latest version!

Sep 22, 2010 | 1998 Volkswagen Beetle

1 Answer

1998 Jeep Cherokee -- car won't start. Turns over


have scanned to find problem code to get an idea of what it is. .it may either be the crank or cam sensor, check the crank sensor first. if it is bad it sends wrong timing info to pcm. therefore jeep will not start!! It is either the camshaft or crankshaft positioner. I would check the crank pos. first. Zach Cabot, AR
It is either the camshaft or crankshaft positioner. I would check the crank pos. first. Zach Cabot, AR
It is either the camshaft or crankshaft positioner. I would check the crank pos. first. Zach Cabot, AR

May 31, 2010 | 1998 Jeep Cherokee

2 Answers

Oxygen Sensor


http://www.autozone.com/autozone/catalog/parts/partsShelf.jsp?displayName=Oxygen+Sensor&currentPage=1&categoryDisplayName=Exhaust&navValue=16100117&itemId=117-0&parentId=61-0

This link will take you to a site that will show you what the sensor looks like and it's cost.Your sensor is located in the exhaust pipe by the catalytic converter.This is under the car,screwed directly into the pipe just behind the converter.Hope this helps?

Dec 30, 2009 | 1998 Volkswagen Beetle

1 Answer

Ware is the crank sensor located on a chrysler


should be at the right rear of engine block just ahead of the transmission

Dec 08, 2009 | 2002 Chrysler Sebring

1 Answer

Volkswagonbeetle


check your idle control valve it is on the sid eof the intake.

Oct 03, 2008 | 1998 Volkswagen Beetle

1 Answer

1998 silverado misfire


Check for a vaccum leak at the intake. Frankster016

Aug 02, 2008 | 1998 Chevrolet K1500

Not finding what you are looking for?
1998 Volkswagen Beetle Logo

524 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

75817 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...