Question about 1997 Chevrolet Malibu

1 Answer

What is the spak plug fiering order on a 1997 chevrolet malibu?

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 4,793 Answers

ALL engines..4cylinder..1342...six cylinder left(looking from front, backwards to gearbox)135...right 624...

Posted on Sep 28, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1997 chevy malibu ls heater core repairs

Entire dashboard has to be removed. Ac system may have to be discharged in order to replace heater core. Probably a 10 to 12 hour job.

Oct 07, 2016 | 1997 Chevrolet Malibu

1 Answer

I have a 1997 Malibu 3.1, no fire at the spark plugs. Ignition module checked good so I replaced the crank sensor but still no fire at plugs. What could be the problem?

you have to check spark plug fire with a HEI plug. you didn't mention the coil primary and secondary coil check with del test light

Aug 06, 2013 | 1997 Chevrolet Malibu

1 Answer

How to remove the console on a 1997 malibu

Malibu/Cutlass 1997-2000 Center Console



  1. Remove the shift control handle by unfastening the retaining clip and lifting the handle off.
  2. Gently pry upward on the trim plate in order to disengage the retainers from the console.

NOTE It may be necessary to move both seats several times to properly remove the center console.
  1. Remove the rear cupholder.
  2. Unfasten the 6 retaining screws, then remove the console.

0900c15280269368.jpg enlarge_icon.gifenlarge_tooltip.gif

Fig. Location of the center console's attaching hardware. Note that both seats may have to be moved a few times in order to access all of the console retainers

Sep 01, 2012 | 1997 Chevrolet Malibu

1 Answer

Try to start the engine but it want start . so i checked to se if the fuel pump was getting fier to the positive wire and it was . so i changed the fuel pump but it is still doing the same thing. so I...

I ran into this problem with one of these at my shop. Gave me a fit for a week. Replaced quit a few parts. After lots of time and money, I finally fixed it by adding a ground wire from the negative battery post to one of the distributor mounting bolts. These also have problems with the distributors.

Feb 06, 2011 | 1997 Mazda Millenia

1 Answer

How to replace front wheel bearings on a chevrolet malibu 1997

  1. take caliper off
  2. knock off wheel bearing dust cover
  3. take out cotter pin
  4. take nut off
  5. pull hub off
  6. outer bearing will fall out
  7. inner bearing if put nut back on couple of threads put hub over nut let lay on spindle an pull hard toward you the inner bearing will come off and seal
  8. replace bearing/seal
  9. grease bearing you can use bearing packer or put grease in palm of hand and push bearing into palm to get grease in bearing
  10. re-assemble in reverse order

Dec 03, 2010 | 1997 Chevrolet Malibu

1 Answer

My 1997 Chevy Malibu is getting a misfire code. Any solutions to my problem will be greatly appreciated. Thanks

a miss fire is usually caused by a bad spark plug, wires, or coil not producing enough voltage.

Dec 28, 2009 | 1997 Chevrolet Malibu

1 Answer

Cylinder #2 Misfire-after intake manifold replaced

It's possible he has two plug wires crossed, or pulled a spak plug wire apart replace #2 spark plug wire First. To test check the firing order and make sure all the wires on the right plugs and the correct place on the distributor, if it is right, then buy a can of carburator cleaner and spray around the intake gasket if the engine revs up when you spray the carb cleaner around the intake manifold with (engine running) if the engine rpm revs up you have an intake leak.

Jul 03, 2009 | 1997 Chevrolet Tahoe

Not finding what you are looking for?
1997 Chevrolet Malibu Logo

Related Topics:

42 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

78919 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides