Question about 2003 Ford Taurus

1 Answer

Chnage starter 2003 - 2003 Ford Taurus

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 286 Answers

Generally you will need to disconnect the battery ground cable, look near the oil filter and remove wires from the starter. It should be in front of the motor at the bottom in the center extreme front near the radiator but down low in the engine compartment. Remove the bolts holding the starter after wires are disconnected and replace in the same order.

Posted on Sep 28, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2003 chevy impala and i had the converter changed in Jan. 2011, well my husband took it to the shop where they changed it, and they told him the converter needed to be changed again. Do to it...


There is no way a catalytic converter can be clogged or damaged in four months unless you have an engine that is burning tons of oil or that has a bad head gasket or the like that allows coolant to get into the exhaust.

Jul 19, 2011 | 2003 Chevrolet Impala

2 Answers

1995 Isuzu, 2.3L engine overheats, chnaged rad cap, water remians


head gasket, if a crean collor is on the oil cap, lools like water pump etc are good

Apr 14, 2010 | 1995 Isuzu Pickup

1 Answer

How to replace starter windstar 2003 V6 engine?


2003 Ford Truck Windstar 3.8L SFI 6cyl Repair Guide

Ford Windstar 1999-2003 - Starter Removal & Installation

  1. Disconnect the negative battery cable.
  2. Raise and support the vehicle safely.
    NOTE When removing the hard shell connector at terminal -S-, grasp the plastic shell. Do not pull on the wire.
  3. Disconnect the starter electrical harness.
  4. Remove the upper starter bolt.
  5. Support the starter and remove the lower bolt.
  6. Remove the starter from the vehicle.

    e1d1735.jpg

  7. Fig. The starter is located at the lower front of the engine, and is visible through the air duct

To install:
  1. Position the starter in the vehicle.
  2. Install the upper and lower bolts. Tighten to 15-20 ft. lbs. (20-27 Nm).
  3. Connect the starter electrical harness. Tighten the starter cable nut to 80-124 inch lbs. (9-14 Nm).
    NOTE When installing the hard shell connector, be careful to push it straight on and make sure it locks in position with a notable click or detent.
  4. Lower the vehicle.
  5. Connect the negative battery cable.

I really hope helps with this (remember rated this help) Good luck.

Dec 31, 2009 | 2003 Ford Windstar

2 Answers

How can i chnage my display language on my volvo


I have a volvo s80 2010 and the disoplay language is french and i would liek to chnage it to english how would i do so .???

Nov 06, 2009 | 2005 Volvo S40

1 Answer

2003 es300 starter does not work


the starter solinoid is bad

Jul 20, 2009 | 2003 Lexus ES 300

1 Answer

Changing fuel filter on 03 Cadilac Deville


I personally have never changed a fuel filter in that model year. You can Google it and find detailed instruction on all to do it. I would think that it would not be that big of a headache…

Jan 19, 2009 | 2003 Cadillac Deville

1 Answer

My POWERSTREEING DO NOT WORK IT IS FULL OF OIL IT IS HARD TO TURN MY Envoy.


chnage piower steering pump....or check hoses make sure fluids gets to pump

Dec 18, 2008 | 2003 GMC Envoy

Not finding what you are looking for?
2003 Ford Taurus Logo

72 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...