Question about 2006 Dodge Charger

Open Question

Where is purge solenoid located on 2006 dodge charger

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1596 Answers

SOURCE: location of the evaporative cannister solenoid? 2003 saturn vue

Depends if the engine is 3.0 or a 2.2?
3.0 purge is on the top, back side of the intake. Black, cylinder. Looks the same on a 2.2, but is located next to the air filter.

Posted on Jan 24, 2009

SOURCE: purge solenoid location

which vehicle are you actually looking for the purge solenoid on? you have 2 vehicles listed in your question. i'll answer both, lol

the locations are described as if you are looking at the engine from the front of the car with hood open.

on the blazer:

it is located on the left side of the intake manifold just under and behind the throttlebody. it is a canister looking device.

on the silverado:

it is located on the intake manifold on the left side in about the same spot as the blazer. providing the silverado has the 5.3 or 5.7 liter engine. if it also has the 4.3 then obviously it will be the same.

hope this helps!

Posted on Feb 17, 2009

  • 160 Answers

SOURCE: 2006 saturn ion 2.2L engine code came up for EVAP purge/vent

replace your pvc vavle then have your cars underbody washed

Posted on Mar 15, 2009

  • 61 Answers

SOURCE: SPARK PLUG INSTALLATION ON 2006 DODGE CHARGER 2.7L

In my experience with the 2.7L engine, the spark plugs are located on the top of the engine below the individual ignition coils. The coils are placed between the intake manifold and the valve covers, 3 per side. The coils are held in with "torx" screws. Simply remove the screws, and disconnect the connectors to remove the coils. The spark plugs will be underneath. Be sure to properly gap the spark plugs for maximum life and emissions compliance. Also, an improperly gapped plug can shorten the life of the coil packs.
Hope this helps!

Posted on Jul 25, 2009

  • 80 Answers

SOURCE: where is EGR Valve located on a 2006 dodge charger

to find the egr valve you will have to remove the purge soleniod from the bracket.

1. EGR tube
2. EGR Valve



8cd5dac.jpg

Posted on Oct 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the location of the Vapor Canister Purge Solenoid on a 2006 Buick Rendevous


Here is a link for locating/replacing the canister purge solenoid on a 2006 Chevy Impala. I couldn't find a video for your Buick, but I suspect it may be located in the same area - near the fuel filler neck. How To Install Evaporative Emissions Canister Purge Solenoid 2006 12 Chevy...

Jan 11, 2016 | 2006 Buick Rendezvous

2 Answers

I have a 2006 Isuzu Ascender with a 6 Cyl. 4.2L Engine and I need to locate the Vapor Canister Purge Valve. Any ideas where it is located. I have looked but am unable to locate it. Is it under a plastic...


Hello have a 2006 Isuzu I-280 and I needed to replace, at this moment, the Evaporative Valve Soleniod which is instaled next to the Vapor Canister. In my case, It is mounted on the frame behind the gas tank you will have to move the spare tire out of the way one bolt holds it in place, this is where the canister is and the valve is mounted on the canister this is where it is mounted on my 2006 I-280. If you need to replace the solenoid and you can't find the original Isuzu part, you can ask for the 2006 Chevy Impala V-6 3.5 Purge Valve Solenoid. It is the same piece. The old Evaporative Vent Valve Solenoid has a number part PA-GF30, and it is the same part number I found in the new Chevy Impala Evaporative Vent Valve Solenoid. Good luck.

Aug 08, 2013 | Cars & Trucks

1 Answer

Where is the evap purge solenoid located on a 07 dodge magnum


my purge valve solenoid on my 2007 dodge magnum is under the hood on the back left hand side...gonna replace it when the part comes in tomorrow because after all my research that should resolve the issue.

Sep 15, 2012 | 2006 Dodge Charger

1 Answer

Engine light on diagnosed PO44O dodge said probably the purge control solonoid. where is this located on a 2004 dodge neon?


Try checking the gas cap first off. 95% of the time, an EVAP code, (purge solenoids, or any EVAP code) could be caused by a lose gas cap, or a defective gas cap.

And I know on SOME neons, the evap canister purge solenoid is located on a bracket attached to the air cleaner. Hope this helped.

Feb 25, 2011 | 2004 Dodge Neon

2 Answers

Where is the purge solenoid on an 01 Dodge Stratus 3.0L V6?


On top of the fuel tank, it plugs into the tank in a groment and has a vacume line on it and a three wire connector with a weather tight plug.

Dec 26, 2010 | 2001 Dodge Stratus

4 Answers

I received the following trouble codes on my 1997 Dodge Ram 1500 with the 5.9 liter engine: 12, 31, 56 I assuime 12 is a toss away... I don't understand the description for 31 and I cannot locate 56 in my...


code 31 is the evap system, the fumes from the tank, the computer can seal or vent the vapors, and so its telling you theres a big leak its not able to seal, could be a loose or bad gas cap or a broken vacuum line for the system or a vent or purge valve went bad,code 56 is not a code, double check . good luck,hope this is helpful.

Dec 19, 2009 | 1997 Dodge Ram 1500 Club Cab

1 Answer

Dodge charger will not shift out of park 2006


there is a solenoid that is operated when you put your foot on the brake to shift out of park, if the solenoid doesnt recieve power than either you have no power to the switch on the brake pedal to activate the switch (check fuses) or the solenoid itself has gone bad, the solenoid is usually right next to where the shifter is located

Nov 18, 2009 | 2006 Dodge Charger

2 Answers

Where is EGR Valve located on a 2006 dodge charger 3.5L pic would be helpful


to find the egr valve you will have to remove the purge soleniod from the bracket.

1. EGR tube
2. EGR Valve



8cd5dac.jpg

Oct 04, 2009 | 2006 Dodge Charger

Not finding what you are looking for?
2006 Dodge Charger Logo

Related Topics:

296 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...