Question about Chevrolet Camaro

1 Answer

1994 camaro - right turn signal and brake light went out - replaced the bulbs - worked for about 30 minutes and went back out - now the dash board lights went out.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    MVP:

    An expert that gotĀ 5 achievements.

    Master:

    An expert who has achieved Level 3.

    Sergeant:

    An expert that hasĀ over 500 points.

  • Master
  • 449 Answers

When bulb went out what color was the inside of the bulb the reson I ask sometimes moister in the bulb will burn it out if it is clear you have a differnt Problem if its milky white it moister

Posted on Sep 28, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1969 z28 Camaro with a painless wiring


All wires are marked in small letters, so first make sure everything is hooked up right. Next check grounds and that correct bulbs are in taillamps. Dash lights could be bad light switch.

Sep 20, 2014 | 1969 Chevrolet Camaro

1 Answer

1994 dodge dakota brake light ground location


The ground wiring on newer vehicles is a little complicated. Older cars, the ground would have been to the body around the tail-lights, but these have a ground wire in the harness and is connected to the turn-signal switch, and other sources. I don't think you have a ground problem. Does the fuse blow as soon as you press it into the fuse-block, or when you step on the brake? I believe you have a dead short somewhere, possibly a pinched turn-signal wire close to the tail-light assembly. Brake lights work through the turn-signal wires from the turn-signal switch on the steering column. That's how you can have one side blinking for turn while the other side stays on for brake. I'm kind of shooting in the dark here because I don't know what all you've done. If you replaced the turn-signal switch in the steering column, you may have pinched a wire or something there. Another thing, if the fuse doesn't blow as soon as you press it in, will both turn-signals work as long as you don't press on the brake? If you can provide a little more information, I might be able to help you more. One last thing....Have you replaced tail-light/turn-signal bulbs? If so, be sure you used the right bulb. You should only have two bulbs, one for back-up lights and one 1157-type combination for tail-lights and turn-signals. I have seen people use a single contact (1056) bulb in place of a 1157, which creates a short from brake/turn-signal back into the tail-light circuit. I do have a 1994 Dodge Dakota.

Mar 12, 2014 | 1994 Dodge Dakota Club Cab

1 Answer

1994 Camaro Z-28 : ABS Lite and Brake Lite both on...Whats wrong?


this may sound crazy but change the bulbs in the light that is up by spoiler and im sure the lights in dash will go off. the dash light and the rear spoiler light use the same ground. let me no if it worked or not.

Dec 28, 2011 | 1994 Chevrolet Camaro

1 Answer

Instrument cluster and tail lights went out. checked all fuses, replaced bulbs. what naxt


replace them and get new led lights for ur car buddy ..
i also bought from www.wholesaleledlghts.co.uk they are COOL ..:)

Dec 11, 2011 | 1994 Buick Roadmaster

1 Answer

I have possible electrical wiring problems, my headlights recently both went out one by one low beams left then right then high beams the same also my turn signals do not work also reverse light. all bulbs...


I WOULD CHECK THE ALTERNATOR, POSSIBLY OVERCHARGING. I WOULD ALSO REPLACE 2 OF THE SMALLER BULBS BEFORE STARTING THE CAR. IF THE BULBS COME ON, FIX THE CHARGING SYSTEM & REPLACE THE REST OF THE BULBS

Jan 02, 2011 | 1994 Chevrolet Camaro

1 Answer

Electrical problem...(without turning the key)...when I apply brakes, the interior (dash-board) lights and exterior turn signal lights come on. Also when I have my lights on, my driver side brake light is...


check for chauffed wiring under dash around steering column and brake pedal, as for your rear brake/side light you have probably put the bulb in the wrong position remove bulb and rotate and retry

May 07, 2010 | 1994 Jeep Grand Cherokee

1 Answer

Brake light, reverse light and turn signal issues


Hello. The symptoms you are describing are likely due to a poor ground. Temporarily install a new ground wire by securing a piece of copper wire to the frame with a self tapping screw. Use this ground wire along with the hot wire to see if each of these lights works. If it does, trace the ground wire back to the frame, unscrew it and clean up the metal with emery cloth so you reestablish a good ground.

Jan 28, 2010 | 2003 Ford Windstar

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

71 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...