Question about 2005 Jeep Wrangler

1 Answer

What would cause a jeep wrangler steering wheel shake at 49 mph and i have changed the steering stableizer shock?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Check your brakes I had the exact prolem I had the front end aligned ,tires balanced 2 times it finally stopped when I chnged my brake pads

Posted on Oct 16, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Vibration at 70 MPH.


Warped or out-of balance brake rotor? Also keep in mind that loose rear differential trailing arms that allow the rear differential to squirm around can also cause steering wheel shake.

May 19, 2012 | 1998 Jeep Cherokee

2 Answers

Shaking Stering Wheel in a 2006 Jeep


If it shake only when the brakes are applied, then it is a brake issue/ uneven wear on the pads & discs.
There are upper and lower control arms, but if they are bolted tight, it shouldn't be the issue. If you hear clicking, check out you CV joints.
Have you rotated you tires? Patterns can wear in and cause lots of shaking.

Jan 15, 2010 | 2006 Jeep Wrangler

1 Answer

Front wheels are loose and wobbly. too much play in steering wheel, and while driving the wheels cause the whole car to shake real bad. what needs to be replaced?


There is a steering dampener underneath that looks like a strut or shock absorber. Replacing this should correct the problem.

Dec 11, 2009 | 1989 Jeep Wrangler

2 Answers

Bad virbration


You may have rotated imbalanced wheels from the rear to the front .Its possible not to feel the imbalance from the rear as it is far less sensitive and not transmitting through the steering wheel. Check tire balance or move the tire back to their original position which might help veify the source of your imbalance.

Aug 23, 2009 | 2004 Jeep Wrangler

1 Answer

My front end shakes when i hit a bump at 50 mph, the front tires


could be a bent rim ? have you changed the universal joints? how about the tie rods and stabilizer bar

Aug 13, 2009 | 2006 Jeep Wrangler

1 Answer

2005 jeep shimmy's (steering wheel and all)


Good excuse! You need to find a shop that does alignments and have special attention to caster. However, did the shake happen from when you first got it or did it develop over time? Check all front components for wear (by all I mean all) especially ball joints and steering damper (the sideways shock on the linkage) All can cause this condition.

May 28, 2009 | 2005 Jeep Wrangler

1 Answer

Jeep shakes bad out sometimes. I can hardly hold


make sure the steering stabalizer shock is not blown out(leaking), or a seperated tire.

May 08, 2009 | 2004 Jeep Wrangler

2 Answers

Steering problem


Shocks are usually pretty much shot after 45-50K. Also check damper (sideways shock on steering linkage). Shake is either wheel balance or a worn steering component (should have been checked before alignment...shame on them if they didn't)

Apr 19, 2009 | 1999 Jeep Wrangler

4 Answers

Violent shake


My Death Wobble started immediately after I installed a set of Coil Spring Spacers (to lift 1.75 inches) on my 2005 Jeep Wrangler X. Turned out, the DW was because while changing the height, I also lowered the CASTER angle in the front end. So, to fix it, I could have purchased a set of eccentric bolts for $50+. Instead I went out and purchased a piece of 1.5 inch flat bar for $10 from OSH. I cut out 4 1.5 inch squares. Then i drilled 7/16 inch holes centerline, but close to one side (in exactly the same place) on all for squares. I then removed the lower control arm bolts, nuts and washers. I installed these square offset washers I made so the front axle would be pushed forward (to increase the Caster angle). The toe setting changed a bit, so I reset them to about 1/8 inch toe in. After driving my Jeep, I noticed there is no more DW. The steering wheel was off center, but after 3 attempts, I have that perfectly centered. I have every intension of having the alignment checked, but not till after I find the new tires I want. If anyone is interested, I can draw out and photograph the cure and send it to you. My e-mail is bb62471(at)yahoo(dot)com.

Oct 10, 2008 | 2004 Jeep Wrangler

2 Answers

My 2002 Jeep Wrangler shakes when traveling 45-50 mph. I had the tires balanced and rotated regularly and the Jeep only has 47000 miles on it. What causes this? Alignment? Shocks?


my jeep had the same problem. it was the shocks going bad along with the steering stabilizer. all easy to replace and costs about 170 far all the parts. search how to replace shocks jeep grand cherokee on google if you need more help on replacing them. i got my parts at autoanything.com (free shipping)

Jul 31, 2008 | 1996 Jeep Grand Cherokee

Not finding what you are looking for?
2005 Jeep Wrangler Logo

178 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...