Question about 1996 Volvo 960

1 Answer

My 1996 volvo 960 trany stop working. No gear at all. After is cool down, go again about 2 mile and stop again. In the shop they check all the solenoid,change the filter and oil but nothing, the car not going.Mechanic say have to get onother trany. I got the feeling is something else may be I can do, to know make sure I need to buy a trany or not. The car have 124000 mile. Thanks

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Mine is doing the same exact thing???

Posted on Sep 29, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1996 960 volvo it gets power up hill an down hill and then it gets sluggish almost like it wants to stop.


Check ignition points (distributor, coils, wires and spark plugs) ten use a fuel pressure guage on the fuel rail comnector to see if ur fuel pump is giving consistant pressure. Also check / replace fuel pressure regulator if necessary

Mar 19, 2016 | 1996 Volvo 960

1 Answer

'97 volvo 960, Orange W-mode arrow blinking, then lost power. What is wrong?


The usual cause of this is a bad PNP switch or gear position sensor.
The "W" is flashing because the transmission control module is stuck in the Winter mode. If you are not familiar with sensor, I suggest you go and have the transmission codes read and reset to begin with and then post back the results.

May 10, 2015 | 1997 Volvo 960

1 Answer

1996 volvo 960 transmission will not go in gear and drive shaft will not turn


run fault codes and check for torque converter clutch operation and TCM failure.

Jan 13, 2014 | 1996 Volvo 960

1 Answer

94 volvo 960 shutting down, then cools off restarts last time it has erratic fire and no throttle response what you think?


how many miles? could need tune up, cat could be gone, drop the exhaust and see if it runs

Jul 07, 2010 | 1994 Volvo 960

1 Answer

How to check trans fluid 96 volvo 960


Look way down just behind the throttle body intake assembly, low on the drivers side near the firewall and below the brake fluid container. You'll see a square yellow dipstick which doesn't have a handle on it. It which accepts a 3/8 inch drive extension: stick the socket extension on it, reach down and depress the hold-down clip, and pull it out. It is sometimes easier to reach from the side of the car, reaching down low. Or just reach down and pull it out. You'll need a long funnel to put fluid in. Be sure that the car has been driven 15 minutes or so, stop, move to and stop in each gear about 5 seconds, and back to park. Check fluid level. Don't overfill by even a small amount.

Dec 15, 2009 | 1996 Volvo 960

1 Answer

My Volvo 960 stalls while driving


check fuel pump and fuse and relay+change fuel filter.

May 28, 2009 | 1995 Volvo 960

1 Answer

Temp gauge on dash fluctuates up and down and stays at times red.


Check your cooling fans to insure they are working to cool the radiator...

Apr 05, 2009 | 1996 Volvo 960

1 Answer

1996 960


Codes prob stored in trans control module. I would say problem is gear position sensor is faulty. It is located on the pass side of trans, next to cat. the wiring goes over top of the trans. It will need put up on lift to replace. prob a 3 hr labor job in shop.

Oct 27, 2008 | 1996 Volvo 960

3 Answers

1996 Volvo 960 has low air conditioning flow while accelerating


Faced similar problem. Open up the dash, change all the 4 vacuum bellows and the 2 vaccum hoses connected from the firewall to the bellow on the driver's side. Also replace the 2 valve in the hood which are connected into the firewall. Problem of losing air during acceleration solved.

Aug 08, 2008 | 1996 Volvo 960

Not finding what you are looking for?
1996 Volvo 960 Logo

Related Topics:

144 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...