Question about 2003 Ford Focus

1 Answer

Dials how do i remove them without breaking them

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 16 Answers

There is a retainer clip on some of the dials in the dash.

Posted on Jun 04, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My speedometer goes up and down , and my radio goes on and off

The speedometer can fluctuate rapidly under normal driving conditions when the car's speed changes abruptly, but sometimes the needle can start swinging around the dial without any fluctuation in speed. If the hairspring comes loose or breaks, it can't hold the speed cup in place, and the result is a fluctuation in the dial. In electrical speedometers, if the circuit that counts the magnetic pulses fails, it can cause the speedometer read-out to vary from the actual speed and to shoot upward or downward without notice. If a speed sensor in the automatic transmission starts to malfunction, it can affect the speedometer and cause fluctuations. In these instances, either the speedometer or the sensor needs replacement.

Sep 26, 2013 | Cars & Trucks

1 Answer

Bearings went out in gear box need break down of gear box picture

Buy a Haynes repair manual for your vehicle. It will have exploded diagrams and step-by-step repair procedures. Often, special tools are required for transmission rebuilds-like snap ring removers, feeler gauges, run-out dials.

Aug 25, 2013 | Cars & Trucks

2 Answers

Heating is only blowing hot air even when switched to cold air.

Have the pressure checked in your Freon lines, maybe have a leak and no Freon left.

Jul 14, 2011 | Ford Fiesta Cars & Trucks

2 Answers

How do I remove the inside door panel on a '98 GMC Sonoma?

There is a special tool that you can buy to remove the snapp caps on the door they are lined all the way around the pannel and you need to pull them toward the left and the tool is like 8 dollars and it is designed to grab them and pull without breaking the pannel I tried without the tool and there is no way to get it off without breaking some tabs

Apr 18, 2011 | GMC Sonoma Cars & Trucks

1 Answer

How di i remove rear side windows in tact

window fitters use a bent knife to cut the sealant around the window ,apply too much pressure and it will pop.

Mar 08, 2010 | 2003 Hyundai Tiburon

1 Answer

Mercedes Benz C-class 180C, the car stops engine each time I break, I have removed the switch connection to the air flow meter and this stops, what is the implication of removing the switch and driving car...

Mercedes Benz C-class 180C, the car stops engine each time I break, I have removed the switch connection to the air flow meter and this stops, what is the implication of removing the switch and driving car without an air flow meter?

Dec 02, 2009 | 1993 Mercedes-Benz 190

1 Answer

My car key is stuck in the driver's side door (VW new Beetle).

I assume you have tried juggling and turn ing the key and pulling all at once>>> Type in the security code for the auto locks on the driver door panel it should release the security device in the lock that holds on to fradulent keys (some models have this some dont) if this doesnt work , try unlocing and locking the door using the controls in the car and pulling on the key to try and remove, if the key wont trun any directions remove door panel locate the locking mechinism and use a flat head screw drivce to turn the lil dial o nthe back side to and try to remove the key.. If none of these work, pull really hard straight back dont bend key on lock as it will break off!! becarefull and goold luck.....
hope this will fix'ya

May 19, 2009 | 1999 Ford Taurus

1 Answer

1991 dodge dynasty rear window removal

I have never been able to remove sealed in glass without breaking it. But in theory if you can get a guitar string through the sealant and pull it through like a cable saw you might get it out. I've tried 15 times, and have 15 broken windshields to show for it. good luck

Jan 10, 2009 | 1991 Dodge Dynasty

1 Answer

Changing door speakers

The clip behind the handle requires a specialty tool available at any autoparts store. it is shaped like a U, but has little tabs on it to catch the ears of the clip.
After removing the clip, remove the plastic trim by the mirror... and a little trapdoor inside the door handle cup will have a screw in it.
The rest are just push-clips, so start at the bottom, and pull toward you... working your way around the door.

The tool looks like this...

Dec 29, 2008 | 2005 Chevrolet Cobalt

Not finding what you are looking for?
2003 Ford Focus Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

78010 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers


Level 3 Expert

5651 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides