Question about 1997 Chevrolet Malibu

1 Answer

The fuel needle is under the peg it rests on - 1997 Chevrolet Malibu

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 24 Answers

Sometimes disconnecting the battery for 5 minutes will cure this. Otherwise, a new cluster will work. A salvage yard one will work also.

Posted on Sep 27, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why would Fuel gauge fluctuate erratically then shake at blinding speed?


Bad sending unit, bad ground, bad gauge, I have seen sending unit go bad they will work part way.

Jan 02, 2016 | Cars & Trucks

1 Answer

My speedometer isn't working on Jeep Grand Cherokee, the hands aren't spinning and is beneath the rubber peg


Disconnect the posative terminal then touch the terminal to the posative a few times quickly it will reset your odometer needle to above the resting pin. This happens because you moved your posative terminal and the needles spun around and sat on the wrong side of the pin.

Oct 23, 2012 | 2000 Jeep Grand Cherokee

1 Answer

I want to know how to reset my buick cluster, as far as the needles because i got my battery changed and then my needle for the gas and temp spun all the way around and now there stuck under the peg and...


You have to take the instrument panel cluster lens off, so that you can move the needles above the stopping peg. Depending upon the model you may have alot of dash trim to remove to get the lens off.

Feb 18, 2011 | 2000 Buick Park Avenue

1 Answer

My gas hand has flipped around to bottom of fuel gauge and is hitting peg on bottom. How can i get it back around to correct position. The car died as the gauge was coming up to full and needle continued...


Fuel pump!perhaps not working!sit in car turn ignition on do not atempt start or crank engine you should hear a grunt sound from back seat area like a GRRRRR if not fuel pump not working!

Dec 28, 2009 | 2006 Nissan Maxima

5 Answers

Fuel gauge stuck behind peg at FULL mark


one thing you can try is to get one of those magnetic pick up tools at a parts store.......prefferably one with a large magnet...and put a cloth around the end of it so you dont scratch the plastic on you gauges and try to pull it back to where it belongs,i have done this a few times with good results,hope this helps

Sep 26, 2009 | 1999 Oldsmobile Intrigue

6 Answers

Gas gauge stuck on empty


Adam, I like your solution, but this is easier:
1. Get a strong magnet
2. Use the magnet to move the needle into the top half of gage (don't take anything apart)
3. Test it by turning the car on.

Sep 09, 2009 | 2000 Buick Park Avenue

1 Answer

2001 grand caravan sport speedometer and tachometer not working


My van did the same thing. Actually the gauge had spun all the way around to the back side of the little peg that the needle rest on. To fix it I took the face of the dach board apart with a screw driver and rotated the needle by hand back to zero and its worked fine ever since..

Jun 06, 2009 | 2001 Dodge Grand Caravan

1 Answer

68 camaro aftermarket fuel gauge pegged passed full


Jess, Make sure you don't have the ground and sender level circuits crossed at the gauge. If the needle is pegs to full it indicates an open circuit, if the needle pegs to empty it is indicating a short to ground.
Let me know.
Regards,

Feb 12, 2009 | 1983 Chevrolet Camaro

Not finding what you are looking for?
1997 Chevrolet Malibu Logo

Related Topics:

37 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...