Question about 1989 Peugeot 405

1 Answer

1999 406 hdi faults

Had car on computer today prob b injectors r high pressure pump was told injectors from any peugeot 2ltr hdi will fit is this right btw tks for earlier advice

Posted by on

  • flippen_fish May 22, 2008

    i have injectors from a 04 peugeot 307 2ltr hdi will they fit?

  • flippen_fish May 22, 2008

    srry 01

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 4,102 Answers

Hi,
As far as i know they are the same and you should have no problem fitting them but if you want to make sure just go into any car spares shop and they can cross referance the part for you.
But im sure the engines are the same as most of them have used the same engine across the range. As long as its the same size engine then you should be ok and have no problems.
Let me know if you have any problems and ill assist you the best i can

Posted on May 27, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Peugeot 206 1.4 hdi has developed a fault where the engine will not start.After leaving the car rest for a couple of hours it will not start .I have to manually bleed the system and the car will start and...


expensive to repair properly,quick fix??? fit two non return valves ,one in the feed and one in the return to the injector pump ,weither conventional pump or common rail pump .this will cure your problem and its cheap to do ,two valves (observe direction) in the lines .works every time on any diesel engine weither its plant or road use

Oct 18, 2009 | 2005 Peugeot 405

2 Answers

My 307 hdi does not accelerate properly


The electrovalve that controls the turbo waste gate needs to be changed it costs around £40. It is located on the front lower part of the engine block. I have done lots of them they are a common fault after about 50000 miles.

Jun 23, 2009 | 2005 Peugeot 405

5 Answers

Peugeot 306 problem


Thes have a weak point with the pump in the tank. It is under a cap under the rear seat, get someone to turn the ignition on and listen if no noise give it a tap and see if it whirrs, slacken a pipe on the filter and see if there is pressure, if not the pumps are available from factors or on line.

May 04, 2009 | 1987 Peugeot Liberte

3 Answers

PEUGEOT 307 LX 1.4 HDI 2003, 2 NEW INJECTORS, SAFE MODE 50MPH


I had same problems with my 307 hdi, turned out that the additive which drips into fuel was empty and changed particle filter,problems solved

Jan 31, 2009 | 1987 Peugeot Liberte

6 Answers

Peugeot expert 20 hdi


Hi, I have a 2.0HDI Expert which was doing the exact same thing as yours, blowing thick black smoke, sluggish and loss of power on gradients, a hissing sound and surging. I replaced the air flow meter but that didn't help. I was told to replace the turbo but a turbo expoert told me not to as it would blow white smoke if it was faulty. I was then told to replace the injectors but a diagnostic test showed them to be functioning fine. I was then told to look at the intercooler which had thick sludge at the lower left pipe. I replaced it today - Sunday 12th July and it is now driving like a new van. It now pulls me up gradients with ease in 4th and 5th instead of having to drop gear to get to the top. I got a replacement from Euro Car Parts for £147 inc VAT. To tell if this is your problem, look through the gaps in the lower section of the bumper at what looks like the radiator and look for sludge over the inside of the bumper and all over the pipe where it joins the back of the radiator (intercooler). Also open the bonnet and look down behind the grille for the same sludge. Hope this sorts it for you. Barry, Newtownards, Northern Ireland.

Jul 11, 2008 | 2006 Peugeot 604

2 Answers

Injectors


Injectors from the same ccm engine are most probably sounds same but to be on the safe side check not only the shape but code on the top of injector too. Because they are piezo effect injectors and set by the manufacture for a specific pressure for specific engine codes.

May 22, 2008 | 1990 Peugeot 405

2 Answers

Injectors


No, the size of the cars is different, so it wont work.

May 22, 2008 | 1989 Peugeot 405

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

309 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Wahs Team

Level 2 Expert

205 Answers

yadayada
yadayada

Level 3 Expert

61037 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...