Question about 2005 Ford Taurus

2 Answers

Transmission issue Was driving home...pulled out from side street...seemed to have no power..would not shift past 2nd gear....blinked " check transmission"....checked fluid ( OK) any ideas??

Posted by on

  • Anonymous Jul 04, 2008

    starter was replace today and for some reason the transmission is making afunny noise and act like it want to stop working but there was no problem before the starter was replace did he mess up the job by put wires where they don't go help please

×

2 Answers

A starter was replace on mf taurus today before the happen my tranmission was fine after he replace the starter then the tranmission started making a funny noise like it want to go.for some reason i think he mess up wire some how is this possible and what can i do to fix it

Posted on Jul 04, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 625 Answers

If there is not any noises then most likelly your transmission is gone see if the car still have factory warranty even if you did not buy car at dealer

Posted on May 31, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My truck wont shift out of 2nd gear. was pointed to the ignition switch the truck will start but the yellow wire to the switch has no juice in either position. Would this put the truck into limp mode?


Why wont my Chevy truck shift out of 2nd gear - JustAnswer

www.justanswer.com > Chevy
Question - Why wont my Chevy truck shift out of 2nd gear - 3I. ... the past. Voltage drop to 10v on fuse #20 when the fault was present. Thanks for the help!

Chevy Blazer won't shift past 2nd gear. PLEASE help - Transmission ...

forums.automotive.com > Forums > Maintenance & Repair > Transmission

Jan 1, 2012 - 14 posts - ‎3 authors
Transmission - Chevy Blazer won't shift past 2nd gear. ... has the check engine light been on lately when driving the truck??? other than just a ...

My transmission in a 1993 chevy truck wont shift from 2nd to 3rd ...

https://answers.yahoo.com/question/index?qid...

Jan 10, 2016 | Cars & Trucks

1 Answer

The Pacifica will not shift past 4th gear. It shifts normally through 1st, 2nd, 3rd, and 4th gear. Their is no high reeving RPS, no clunking, no lurching. It will just not shift past 4th gear.


is there an OD button that might have been pressed .if it has lots of miles on it it could be needing a flush job . last one I got done was around 100.00 at jiffy lube.

Nov 12, 2015 | 2005 Chrysler Pacifica

1 Answer

How do i get my 98 volvo s7o to shift up past 2nd and fix the speedometer


Volvo Forum • New Transmission Shifting Issue - Matthews Volvo Site

www.matthewsvolvosite.com/forums/viewtopic.php?f=1&t=35574
Jan 11, 2011 - 14 posts I just completed replacement of the transmission in my son's 1998 V70xc. Problem: car runs and drives in reverse and 1st gear, but will not shift up to 2nd, etc. ... Does the upshift arrow light up if you move gear lever down in lower gears? ... use the original trans case and final drive since FWD gearboxes do ... Volvo Forum • 1998 V70 XC AWD Transmission Problems
14 posts
Jul 15, 2010
Volvo Forum • 1998 V70- Should I change Transmission ...
14 posts
Jun 1, 2010
More results from www.matthewsvolvosite.com

Oct 01, 2015 | 1998 Volvo S70

1 Answer

My 1990 honda accord for some time has had the s(green) light blinking off and on, had it is solid S green and it seems as it won't shift gears, I don't have power like before? what happened?


The flashing s light means a transmission problem. The transmission computer is under the carpet on passenger side under where you put your feet. Pull down the carpet to see the diagnostic light. Turn on the key to count the flashes to get the code. Pulll a list of codes from the internet.
If your trans shifts properly if you manually shift it thru the gears, going from D1, D2 D3 but feels like it is starting in second when in drive at a stop, the computer is probably the issue, and can be repaired or exchanged for a good computer, lots of companies do this ,find 1 on the internet.

Sep 18, 2014 | 1990 Honda Accord

3 Answers

94 chevy k1500 wont shift past 2nd gear.


its possible the shifters linkage is bent

Mar 17, 2010 | 1994 Chevrolet K1500

1 Answer

93 honda accord


Sorry to deliver bad news but that blinking light means you have a code that has been sent to the computer. That code usually means the transmission is about to go out. If it seems you loose power in fact the clutches in the transmission are more than likely slipping. This could be from wear or you might get lucky and your transmission may be really low on fluid. My daughter had thesame year honda and she was checking the oil level for about a year thinking it was the transmission dip stick. You may be able to go to Auto Zone or Advanced Auto parts and get them to pull the code out of the computer to tell you what is the problem they usually do this for free but the problem is a lot of them do not have the older codes anymore. But if its free then its a try. Hope this helped, Good lick

Feb 07, 2010 | 1993 Honda Accord

1 Answer

4L 60E - 2001 k1500 will not shift into 3-4. Oil is not burn't and stifts great into1-2


  • No 3rd or 4th gear: “3-4” clutches are worn out. R&R. The car is safe to drive (in 2) until you can get it fixed.
  • Trans shifts into gear harshly, car feels sluggish off the line, No 1st, 4th or TCC lockup available, Manual 2nd, 3rd and Reverse are only available gears, CEL is on: Transmission is either in limp-home mode or has lost electrical power. If there are lots of error codes in the PCM, check the under hood fuse that powers the transmission, and if it pops again, look for a short in that circuit like an O2 sensor harness touching exhaust. Otherwise, check PCM codes for a particular fault in the transmission causing the PCM to put it in limp-home mode.
  • No 1st or 4th available; trans shifts 2nd to 3rd by itself in D or OD and locks the converter : Shift A solenoid failed. Easy fix in the pan. Or a wiring problem from PCM to trans.. or PCM.
Check to see if your transmission is in the limp mode, which would only give you 2nd, 3rd and reverse gears. No 1st or 4th gear.

Nov 19, 2009 | 2003 GMC Sierra 1500

1 Answer

Transmission on 1995 Buick Century, slipping badly


Sir I would first change my filter. When you do you should be able to acertain if anything is wrong by what yuo find in your pan. I think your clutchs are probably bad, but with out being able to scan it I don't have any other ideas. I have been lucky a couple of time before and changing the filter solved my problem. Your car is in limp mode generally you have reverse and second gear. 1st gear and reverse use the same clutches, so I am wondering if maybe you have second gear only!

Dec 26, 2008 | 1995 Buick Century

2 Answers

Transmission issue


is ''s'' light blinking on the dash
the tranny uses a speed sensor mounted on the outer side,
this sensor calculates the transmission speed and compairs it
with the vehicle speed if the tranny speed sensor is not working
proper this can cause the miss shift

Aug 17, 2008 | 1990 Honda Accord

Not finding what you are looking for?
2005 Ford Taurus Logo

145 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...