Question about 2007 Pontiac G6 GT Convertible

1 Answer

Convertilble wont go up

My top on the g6 2007 just goes up a couple inches then stops the motor is running for it to go down but it wont i can return it to its original place without any problem what could be doing this

Posted by on

  • cakref76 Jul 26, 2008

    the deck lid will not close and the motor stopped making the sound when opening and closing the top. the deck lid is stuck in the open position. the fuse box was checked and is ok. please comment on how to fix the problem.

  • MandagirlNC Mar 24, 2009

    I have the same problem. Today I chose to put the top down and when I was trying to put the top back up--the trunk opened like normal and the top came up like normal, but the top made a loud crashing noise when it was trying to land and stopped about 2 inches from the "resting point" and the trunk was still up. I kept trying to put the top back down--nothing happend, and I kept moving the switch back and forth & still nothing. I had to call for a tow truck, the vehicle is not drivable. Also, just last week my car battery died, the check engine light kept flickering on and off, car was sputtering, the window motors had to be reset because they were not going up all the way & now when the windows go up they slam & when I am driving down the road with the windows completely rolled up--the window sounds like it is down (air is coming in). My front seat sqeaks really bad (dealership's reply is "newness of the leather" but how new is 40K?), and the headliner in the interior has been replaced 2 times. Also, the front end is making a popping noise when steering and the car when sitting still makes a loud running noise--is this normal?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Had the same problem with my G6 convertible too....The pontiac dealer said the bar that lift the top were bent...They had to replaced the whole assembly...

Posted on Oct 05, 2008

  • leah ellison Apr 20, 2012

    How much did this cost to get it fixed

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Window goes all the way up or down but stops every couple inches until you push the switch again.


Thats a bab window regulator motor you gonna soon it will take a couple try to lift up your window

Mar 11, 2015 | 2011 Ford Fusion SEL

1 Answer

Power window on drivers side messing up


I would say the noise is the gears over-running each other. There is a gear on the motor and one on the window regulator.
You probably have a restriction in one of the tracks.

Apr 09, 2013 | 1989 Oldsmobile Cutlass Ciera

1 Answer

Antenna relay switch


is it original antenna and radio? the antenna runs on a seperate switch oor goes up and down with radio on and off switch? if it is original stereo that is original chances are the antenna is broken and stuck in up position the mast may be purchased at dealership but motor may also be no good or not far behind. Listen at antenna for motor noise when radio is turned off if you hear the motor the plasic that drives it inside is broken.

Apr 02, 2013 | 2000 Cadillac Eldorado

1 Answer

Window wont go all the way up


one of 2 problems , either slide not inline anymore , or cable ready to break

Mar 25, 2013 | Cars & Trucks

2 Answers

My drivers side power window went down and now wont go all the way up. It will only go up about 3 inches then stops


Three inches at a time, or three inches total? If three inches at a time, you need a power window motor. If three inches total, you need a window regulator. Both these items are typically replaced as an assembly anyway.

Aug 17, 2011 | 2005 GMC Envoy

1 Answer

Passenger power window put it down about 6 inches,would not go back up by either side switch. Took the door panel off and wiring is ok.


COULD BE A COUPLE OF THINGS, THE EASY THING TO DO IS TO GET A GOOD 12V BATTERY AND MAKE SOME LONG JUMPER WIRES,THEN UNPLUG THE WIRE HARNESS THAT GOES TO THE WINDOW REGULATOR OR MOTOR.NOW GET THE WIRES AND ATTACH TO BATTERY POSITIVE ,NEG,AND CAREFULLY TOUCH LEADS GOING INTO MOTOR ,YOU CAN REVERSE THEM FOR WINDOW DIRECTION.IF IT GOES UP AND DOWN WITH NO PROBLEM THEN YOU CAN ELIMINATE THE MOTOR,AND LOOK SOME WHERE ELSE....THE MOTOR MAYBE HEATING UP AND ONLY GOING DOWN A BIT THEN QUITS.OR THE SWITCH IS BROKEN .AND WONT GO UP.

Jul 09, 2011 | 2000 Chevrolet Monte Carlo

2 Answers

Do you have to remove motor mount to change the belt


jeffriesa97, You fail to mention what size your engine is here but I will take you through the procedure. If your belt goes over and under the motor mount then yes you will have to remove it first. The motor will have to be supported first. Place a piece of wood on a floor jack and place it under the oil pan. Raise the jack until you see the engine come up a little. Remove the engine mount. I believe they are 15MM bolts holding it in. You may have other things attached to the mount. Remove these and set aside. Check your belt tensioner to see if it returns to it's original position before you put the new one in. If it sticks then either lubricate it or replace it. Reverse the procedure for replacement. Good luck with this.

May 16, 2011 | 2002 Buick LeSabre

1 Answer

The rear window went down a couple of inches and wont stay up


you will need a window regulator, its not cheap.

Mar 12, 2010 | 2004 Pontiac Grand Prix

Not finding what you are looking for?
2007 Pontiac G6 GT Convertible Logo

Related Topics:

755 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6879 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...