I need to find where the signal light flasher is on a Chrysler Cirrus 2000

did you check the celenoid which controls the flasher sequence. power cables should be connected there. in the trunk maybe? have a 97 cirrus and thats where mine are.

Almost certainly a fuse issue.

The Combination Flasher, also referred to as the combo-flasher, is mounted to the in-line bracket which is located to the right of the Junction Block. The flasher can be removed by pulling in a rearward direction. The left under panel silencer duct must be removed to access the flasher. The combo-flasher is black in color for ease of identification.
The Turn Signal and Hazard Warning Flasher is combined into one unit called a Combination Flasher (Combo-Flasher). The combo-flasher controls the flashing of the hazard warning system and the turn signal system. An inoperative bulb or incomplete turn signal circuit will result in an increase in flasher speed.

Ref: http://www.10w40.com/questions/auto-repair-questions/where-is-the-flasher-relay-on-a-2000-chrysler-concorde
Good Luck

The cover on the steering colum will have a few screws on the bottom side.

The turn signal flasher is located on the back of the turn signal switch assembly, remove the steering column shroud by removing the 3 screws on the underside, then look on the back of the switch for the relay.

This would indicate that the front indicator bulb is burnt out and needs to be replaced.

The wiring harness to the lights on the trailer might shorted somewhere. Trace the wires to the lights looking for a bare spot or chaffed area.

The flasher relay could be bad. Is this front and back on driver side or both sides. The flasher makes the bulbs to flash, so i would check it first.

try a new flasher unit

Hi...
You are looking for the location of the TURN SIGNAL FLASHER.
The turn Signal flasher on a 00 Chrysler Cirrus.
Is mounted inside of the Turn Signal switch.
Some model If you remove the steering cover you will have axces to the Flasher.
But In some Model you will need to replace the Multifuntion Switch ( Turn signal switch)

OK.. I hope this help on your question.
I'm Based on a AUtorepair Software. to give the answear..

Thank you for use fixya..