Question about 1995 Chevrolet Caprice Classic

1 Answer

Pass key fault indication light

What does the Pass Key Fault light indicates, what could be the problem when it goes on.

Posted by on

  • 1 more comment 
  • Anonymous Jun 03, 2008

    1993 caddilac fleetwood broughm. Flashing pass key fault light and car wont start. Would like to bypass pass key or disarm by replacing resistors in harness any solutuions?

  • lmason2 Jul 15, 2008

    turn theignition on waited for tenminutes then turned it off waited for five seconds. cleaned the key with tooth brush. the car still will not start.next step is to buy a new key and change the ignition switch

  • Anonymous Nov 19, 2008

    i have the 95 caprica and have an alarm on it. i dont know if this has anything to do with it but i have the same problem. usually doesnt last more than 4 or 5 min but is annoying

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 625 Answers

That means than your antitheft system is not operating right,
if your car has a tilt wheel steering system most likelly you need to replace the ignition lock cylinder
this will be also with intermitant wont star simptom

Posted on May 28, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is trsnreceiver in 99 cadillac sts


Anti-theft system transceiver ?
Theft Deterrent System
The Theft Deterrent System on this vehicle is comprised of two separate systems, the Personal Automotive Security System (PASS-Key?® III) and the Content Theft Deterrent (CTD) system. These system are described and diagnosed separately within this section. For CTD operation, refer to Content Theft Deterrent (CTD) Description .
SECURITY Indicator The yellow indicator SECURITY on the instrument cluster is controlled by both the PASS-Key?® III system (VTD module) and the CTD system (RIM).
?€¢
PASS-Key?® III system, the VTD commands the instrument cluster to control the indicator only when the ignition switch is ON.


?€¢
CTD system, the RIM commands the instrument cluster to control the indicator only when the ignition switch is OFF.
PASS-Key?® III System The PASS-Key?® III system is designed to help prevent vehicle theft by disabling the engine unless an ignition key with a specific electrical value is used in the ignition lock cylinder. The PASS-Key?® III system operates independently of the CTD system. Protection is provided even if the CTD system is not armed. The components of the system are the ignition keys (black or gray), ignition lock cylinder, Theft Deterrent (VTD) module, Reader Exciter, Powertrain Control Module (PCM) and two starter relays (START 1 and 2) in the underhood fuse block.

Oct 06, 2016 | 1999 Cadillac Seville STS

1 Answer

Wont go past 35 mph engine run good idles fine but when in gear wont pass 35 mph also abs light on


the car is in limp mode
run the fault codes to find the fault
the indications is the abs circuit / brake problem

Jan 07, 2016 | Cars & Trucks

1 Answer

Why is the Pass Key Fault light stay on in my 1996 Fleetwood Cadillac


The pass key light or lock picture/icon is a visual indication that something in the car's antitheft system is failing. In most GM cars and trucks there is a hidden system that most people are unaware even exists. From the moment you put your key in the ignition, there begins a constant line of communication between your key's security chip or transponder, to the ignition's lock cylinder, and then to the car's TDM (Theft Deterrent Module). These 3 parts are in CONSTANT communication. If the key is in the ignition, then these parts are sending signals to each other. The security light illuminates when that signal gets broken, even just for a second. When the signal breaks, the car misinterprets this as an attempt at theft and goes into antitheft mode. The car thinks its being stolen or hotwired because it is not getting that signal from YOUR specific key. This is why the security light turns on and shuts down your vehicle. This link explains it pretty well.
http://vatspasslockpasskeysecurityhelp.yolasite.com/

Jul 18, 2014 | 1996 Cadillac Fleetwood

1 Answer

Have a 1995 Chevy Caprice classic won't start get light that says pass key fault


Get a second ignition key, the one you are using is dirty or moisted, you need to turn on and off the car witha clean key, hapens to me once in a while.!!

Jun 24, 2012 | 1995 Chevrolet Caprice Classic

1 Answer

1994 pass key fault on


Ya, this is a common and potentially expensive problem on GM vehicles like your cadillac. Go to this link for a rundown of how the system works and ways to fix it yourself

http://vatspasslockpasskeysecurityhelp.yolasite.com/

Apr 21, 2012 | 1994 Cadillac Fleetwood

1 Answer

Cant Find a list of codes 1989 Buick Century. Car stalls and has a rough idle. coads are 31 43 and 44


Here is a code list for you. Remember this doesn't always mena a sensor issue, the problem can be in the wiring as well, or in the case of a lean code you may have an actual lean condition due to a vacuum leak at the intake or vacuum hoses or connections. I have highlighted your fault codes and added extra notes.
GM common codes for OBD1 (for vehicles made before 1995)
12 System normal
13 oxygen sensor circuit open
14 coolant sensor high resistance or shorted
15 coolant sensor circuit low or open
16 direct ignition system (DIS) fault in circuit
17 cam position sensor fault
18 crank or cam sensor error
19 crank sensor circuit fault
21 tps sensor out of range
22 tps sensor signal voltage low
23 intake air temp sensor out of range, low
24 vehicle speed (vss) sensor circuit fault
25 air temp sensor sensor out of range, high
26 quad-driver module (computer) circuit #1 fault
27 quad-driver module (computer) 2nd gear circuit
28 quad-driver module (computer) circuit #2 fault
29 quad driver module (computer) 4th gear circuit
31 camshaft position sensor fault
32 egr circuit fault
33 map sensor signal out of range, high
34 map sensor signal out of range, low
35 idle air control sensor circuit fault
36 ignition system circuit error
38 brake input circuit fault
39 clutch input circuit fault
41 cam sensor circuit fault, igntion control circuit fault
42 electronic spark timing (EST) circuit grounded
43 knock sensor malfunction or electronic spark control (ESC) circuit fault (ignore this for now)
44 oxygen sensor lean exhaust (make sure you no engine vacuum leaks)

45 oxygen sensor rich exhaust
46 pass-key II circuit or ps.pressure switch circuit fault
47 pcm-bcm data circuit
48 misfire diagnosis
51 calibration error, mem-cal, ecm or eeprom failure
52 engine oil temperature circuit, low temperature indicated
53 battery voltage error or egr or pass-key II circuit
54 egr system failure or fuel pump circuit low voltage
55 a/d converter error or pcm not grounded or lean fuel or frounded reference voltage
56 quad-driver module #2 circuit
57 boost control problem
58 vehicle anti-theft system fuel enable circuit
61 a/c system performance or degraded oxygen sensor signal
62 engine oil temperature high temperature indicated
63 oxygen sensor right side circuit open or map sensor out of range
64 oxygen sensor right side lean exhaust indicated
65 oxygen sensor right side rich exhaust indicated
66 a/c pressure sensor circuit low pressure
67 a/c pressure sensor circuit or a/c clutch circuit failure
68 a/c compressor relay circuit failure
69 a/c clutch circuit head pressure high
70 a/c refrigerant pressure circuit high
71 a/c evaporator temperature sensor circuit low
72 gear selector switch circuit
73 a/c evaporator temperature circuit high
75 digital egr #1 solenoid error
76 digital egr #2 solenoid error
77 digital egr #3 solenoid error
79 vehicle speed sensor (vss) circuit signal high
80 vehicle speed sensor (vss) circuit signal low
81 brake input circuit fault
82 ignition control (IC) 3X signal error
85 prom error
86 analog/digital ecm error
87 eeprom error
99 power management

Jul 21, 2011 | 1989 Buick Century

1 Answer

When i pull the code up on my 1992 park avenue it blinks once then blinks twice. what does this code mean?


This is code 12 and it means "System Normal"
Here is the complete list of fault codes for your Buick
GM common codes for OBD1 (for vehicles made before 1995)
12 System normal
13 oxygen sensor circuit open
14 coolant sensor high resistance or shorted
15 coolant sensor circuit low or open
16 direct ignition system (DIS) fault in circuit
17 cam position sensor fault
18 crank or cam sensor error
19 crank sensor circuit fault
21 tps sensor out of range
22 tps sensor signal voltage low
23 intake air temp sensor out of range, low
24 vehicle speed (vss) sensor circuit fault
25 air temp sensor sensor out of range, high
26 quad-driver module (computer) circuit #1 fault
27 quad-driver module (computer) 2nd gear circuit
28 quad-driver module (computer) circuit #2 fault
29 quad driver module (computer) 4th gear circuit
31 cam position sensor fault
32 egr circuit fault
33 map sensor signal out of range, high
34 map sensor signal out of range, low
35 idle air control sensor circuit fault
36 ignition system circuit error
38 brake input circuit fault
39 clutch input circuit fault
41 cam sensor circuit fault, igntion control circuit fault
42 electronic spark timing (EST) circuit grounded
43 knock sensor
or electronic spark control circuit fault
44 oxygen sensor lean exhaust
45 oxygen sensor rich exhaust
46 pass-key II circuit or ps.pressure switch circuit fault
47 pcm-bcm data circuit
48 misfire diagnosis
51 calibration error, mem-cal, ecm or eeprom failure
52 engine oil temperature circuit, low temperature indicated
53 battery voltage error or egr or pass-key II circuit
54 egr system failure or fuel pump circuit low voltage
55 a/d converter error or pcm not grounded or lean fuel or frounded reference voltage
56 quad-driver module #2 circuit
57 boost control problem
58 vehicle anti-theft system fuel enable circuit
61 a/c system performance or degraded oxygen sensor signal
62 engine oil temperature high temperature indicated
63 oxygen sensor right side circuit open or map sensor out of range
64 oxygen sensor right side lean exhaust indicated
65 oxygen sensor right side rich exhaust indicated
66 a/c pressure sensor circuit low pressure
67 a/c pressure sensor circuit or a/c clutch circuit failure
68 a/c compressor relay circuit failure
69 a/c clutch circuit head pressure high
70 a/c refrigerant pressure circuit high
71 a/c evaporator temperature sensor circuit low
72 gear selector switch circuit
73 a/c evaporator temperature circuit high
75 digital egr #1 solenoid error
76 digital egr #2 solenoid error
77 digital egr #3 solenoid error
79 vehicle speed sensor (vss) circuit signal high
80 vehicle speed sensor (vss) circuit signal low
81 brake input circuit fault
82 ignition control (IC) 3X signal error
85 prom error
86 analog/digital ecm error
87 eeprom error
99 power management

May 05, 2011 | Buick Park Avenue Cars & Trucks

1 Answer

Pass key fault light comes on and car want strat.


i had the same prob in my 94 the ignition cylinder is bad change the ignition and i swear it will work perfect

Jul 03, 2009 | 1995 Chevrolet Caprice Classic

3 Answers

95 chevy caprice pass key fault.


WELL I HAD THE SAME PROB. ON A 95 CHEVY CAPRICE.I REMOVED THE IGNITION AND THE WIRE WAS BROKE.WHEN U TURN THE KEY THE PASS KEY WIRE TURNS WITH THE IGNITION,WHAT A FAULTY DESIGN.ANY HOW BUY A NEW IGNITION AND KEY THAT SHOULD SOLVE THE PROB. GOOD LUCK

Feb 25, 2009 | 1995 Chevrolet Caprice Classic

Not finding what you are looking for?
1995 Chevrolet Caprice Classic Logo

Related Topics:

802 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...