Question about 2000 Pontiac Montana

2 Answers

Bearing noise I sometime hear a kind of a bearing noise when i am accelerating on the road. Then I stop the van on the side of the road ,put it on park and shut of the engine. After restarting the engine if I still hear that noise and want to drive again then the transmission switch rufly at all the 4 speed. If instead the noise dissapeared , everything after is ok. It is in intermitent problem. Would you now what defective part could affect the transmission shifting ????? would it be the alternator ? or a transmission electronic controler. I hope you can help me Thank you Will

Posted by on

2 Answers

Thanks for trying Ajkill, it is not a wheel bearing problem. I still hearing the noise aven when I am on Park and rising the engine.
I am quite shure that it is an electronic problem. Please somebidy help me !!!!

Posted on May 20, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 2,035 Answers

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When I accelerate, why do I hear a roaring noise coming from the rear?


Is the exhaust blowing? If you rev up in park does it do it? If you accelerate then lift off does the noise stop?
Do a road test and take someone with mech knowledge to pinpoint noise. Try running it on jackstands, carefully!!

Nov 06, 2015 | 2005 Chrysler 300

2 Answers

High pitched noise and Rattling in gear box.


sound like main shaft bearing assuming it is manual( if it comes on all the gears)

if it is automatic it must be your torque converter bearing

Apr 20, 2013 | 1992 Ford Ranger

1 Answer

Rumbling sound at acceleration on 1999 plymouth voyager expresso van


The transmission was rebuilt-- but not the differential
within the same case

You hear worn out bearing noise

Feb 12, 2013 | 1999 Plymouth Voyager

1 Answer

I was driving 40 mph and I heard something that sounded like a bolt hitting the street from off of my car and a loud sound was coming from under the front end of my 2002 dodge neon. When my car is rolling...


Hi, the problem is either a wheel bearing or driveshaft joint. You will need a mechanic to repair the car, as these repairs require experience and special tools. To verify the problem, you can get under the front of the car and grab the half-shafts--there is one on each side going to the middle of the wheel hub. Pull the shaft up/down or side to side. There should be no movement at all. If there is movement, you are holding the bad shaft. A mechanic can tell if the problem is with the shaft itself or the bearing in the hub. Please let me know if you have more questions, and thanks for using FixYa.

Mar 17, 2011 | 2002 Dodge Neon

1 Answer

Strange noise (sounds like when kids put cards in spokes of bikes to make sound). Sometimes loud; sometimes low. (Kind of THUDY sound. On left hand side (near the wheels). Usually every day I drive it;...


sounds like it may be bad wheel hub bearing. wen going down road with no traffic steer left then right left right and see if noise gets louder and softer wen weight shifts from side to side. if it does u may need to get new hub bearings

Feb 23, 2011 | 2000 Dodge Caravan

1 Answer

Bad road noise/tire growl. Thinking it was just the tires, I just changed OE Goodyears (with 33k on them) with new Firestones--and I still hear lots of noise. Car is maintained by the book. 30k service 3...


Have you checked the spindle bearings, what about the rear wheel bearings, jack up the car and spin the wheels, start the car and put in drive for the front wheels (you might have to sit inside and shut the door to hear it), always stop the wheels from turning before putting back in park.

Dec 29, 2010 | 2008 Nissan Maxima

1 Answer

Driving van down the road and the RPM shot right up and the vehicle started to slow down. Stepped on gas, no movement but RPM still went up. Stopped van and it would stay in park but would not engage any...


I had a Ford Winstar van that had this problem. There is an acceleration switch near the firewall on the passenger side that needs replacing. Unless you're very good under the hood, see a mechanic as it's a totall B**ch to get to the darn thing!

Dec 06, 2010 | Ford Freestar Cars & Trucks

1 Answer

Suzuki Forenza Road Noise


wheel bearings or diff bearings try coasting wiht the engine shut off down a hill to listen better,or get someone who knows cars to come with you to hear the noise

Oct 22, 2009 | Cars & Trucks

1 Answer

93 Grand Caravan right rear wheel/brake problem(s)


well i can help with problem #2

even if you tightened the wheel bearing, it is probably worn out..

what it does when it's loose is you won't hear much noise when you drive on a strait road but the minute you put some weight on it, like when you take a curve, the weight of the body is applied on the bearing resulting in a scraping noise....

and the faster you'll drive the more noise you'll get

so let's say you take a left turn you're gonna hear noise from the right wheel...

Apr 29, 2009 | 1993 Dodge Grand Caravan

Not finding what you are looking for?
2000 Pontiac Montana Logo

206 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...