Question about 1992 Acura Legend

1 Answer

My car Just Stoped turning over

The car was operating fine, then after changing all of the fuses on the drivers side of te vehicle it doesnt turn on at all... Nothing else was touched at all but the fuses.. I havent heard of something like this ever happening till experiencing it... When I turn the key the engine pretty normal other than the fact it wont start. Should i just put the old fuses back into the vehicle????

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.


    An expert whose answer got voted for 20 times.

  • Expert
  • 119 Answers

Why did you change the fuses? Fuses do not require periodic replacement. Either they are good or they are bad. Sounds like you did not put a fuse back in it's proper place. When you turn the key on, does the Check Engine light come on? If it does not, then the main computer is not receiving any power from the fuse box.

Posted on May 22, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My turn signals stoped working on my 95 chevy Tahoe, The hazard lights work and when I turn the alarm off or on they flash. I've had the flashers checked, the relay checked, and the switch has been...

Try checking fuses under the hood, and under the dash,
there are fuses in both locations, both on drivers side of vehicle.
I hope this helps you.

Sep 11, 2013 | 1999 Chevrolet Tahoe

1 Answer

What make the turn signal stop blinking

check the lamps inside the turn signal housings on the side of the vehicle your trying to passenger side front and rear or driver side front and rear.

Also is it only one side, or both? when turn indicator is operated?
check fuse block to see if fuse is blown. owners manual will show a fuse box location and identify which fuse if for turn indicators

Jan 27, 2013 | Cars & Trucks

2 Answers

Dodge ram 3500 turn signal - headlight problem

WAY TO GO !!! another "great idea" from vehicle manufactures

Jun 07, 2012 | 2004 Dodge Ram 3500 Truck

1 Answer

2006 escalade the left side of the driver switches dont work, ie left side front or back windows wont role up or down and the unlock doesnt work. The lock side of the button works and the right side...

has the vehicle been in an accident around the drivers door A pillar? Sounds like there are some wiring issues inside of the harness or connector that goes from the body to the door.

Aug 22, 2017 | 2006 Cadillac Escalade

1 Answer

Hazard lights and turn signals not working. Fuses are fine.

First check on the drivers awareness of operation knobs from the interior of vehicle. The drivers is required to familiarise with vehicle lightening knobs, buttons or switches dependign on the brand of volks wagen or type of vehicle. Also, the type of brand may allow for lightening to fucntion only when the vehicle is turned on completely and not on ingnition battery test alert. Insert the key in the ingnition to turn on the vehicle. Usuing the available switches either on the dashboard area at drivers side to ascertain which powers the signal lights. The same switshe smay be situated on the steering where as stick levers. Second, the vehicles power supply from bateries including electrical wirings, light blubs and finally when in fucntioning order is indication of drivers unfamiliarity ith operations functionality from within vehicle.

Jan 22, 2011 | 1999 Volkswagen Passat

1 Answer

97 dodge cooling fans stoped working

If you have checked the relay module under the fans,on drivers side,and they are fine,replace the coolant sensor,and make sure all the air is bled out of the cooling system.

Jul 10, 2010 | 1997 Dodge Grand Caravan

1 Answer

My buick park avenue wont start, i think its a fuel pump relay

the relay can be found in the fuse box thats located under the hood open the box and look for the fuse or relay that says fuel pump. this fuse box is usually on the drivers side of the vehicle but it can also be on the passenger side.

Jan 30, 2010 | 1994 Buick Park Avenue

1 Answer

I own a 2005 chevy trail blazer and the whole driver door stoped working....i mean the window buttons and the power mirrors and the door lock stoped working and i don't mean the whole car just the buttons...

Your vehicle has a drivers door control module,and a passenger doors control module that operates all the other dorrs except the drivers door.I have seen more than my fair share of drivers door modules go bad in the earlier models. Check the connections if the are ok you probally need a new module.Which will need to be programed to your vehicle.

Sep 02, 2009 | 2005 Chevrolet TrailBlazer

1 Answer

Radio/side view mirror switch does not work but fuse for it (#7) is fine. According to owners manuel, fuse #7 is also for instrument cluster ligts which work. Any Ideas?

start looking at the wiring harness in the door frame it sounds like it is broken
failing thet did it get wet recently ?
water inside of switches will film the contacts and all of a suden they dont work
or might it have been pop
the wife spilled diet coke on a keyboard once
took about 40 seconds 1/2 te keys stoped working.
diet coke plus switches epecialy in newer cars doesnt work well unless you dont want em to work ever again

Apr 16, 2009 | 2004 Mazda Tribute

1 Answer

Back lights on car not working

Driver side, under the dashboard left hand side you will find a box. To the right hand side of the box, there will be a bkack color knob. pull/turn the knob. The box will open downwards. Fuse # 23 is for te Backup light.

Sep 23, 2008 | 1998 Ford Contour

Not finding what you are looking for?
1992 Acura Legend Logo

Related Topics:

66 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides