- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
03 Jeep Liberty sunroof wont close. I have 4 sunroof buttons; Open, Close, Vent and ASC. Open and Vent buttons are working fine. Close button is not responding. ASC button is flashing red and green but does nothing when pushed. I have no way to get it closed
Yes . Remove door panel, switch connectors and plastic protective covering on the door. have a helper pull the windw up while you measure the distance from bottom of window regulator to bottom of door panel.
(approx 8-12"), cut a block of wood that will fit between the bottom of the regulator to bottom of door panel wedge it threw the opening in the door a place it between the regulator and door bottom. Wood is soft and sturdy and should hold up until you get the window fixed.
Can the driver control panel switch make that window work. If the answer is No then the problem is the motor on that side. If the answer is yes then the problem is the switch on that window. by the way if the driver control panel gets the window to rise Merry Christmas you don't need the wooden block.
They are ELECTRIC....... things happen like this......When the contacts don't touch they won't move. Try taking the switch from the door the window is down and wiggle it or clean the contacts...good luck. Replace the switch..'gona give you trouble down the road again !!!!!!
Have another look at the fuse-box. You must have disturbed something, probably in that area.
When you press the switch to open the window, a feed goes to the motor, and also to a timer, which holds the feed to the motor long enough for the window to open fully.
The timer will probably be located somewhere near the fuse box, looks like a small box, similar to a relay, about 30mm x 30mm. Make sure its plugged in fully
Hi there .
Check the horn relay . There's a fuse box under the stering wheel and another fuse box when you open the hood , on driver side .
You have the horn relay there and if I can remember you have more fuses there .
Hope this help
IF YOUR TALKING ABOUT THE POWER VENT WINDOW.IT MAY BE HYPER EXTENDED LIKE A KNEE OR ELBOW.TRY TAKING A SCREWDRIVER FROM THE OUTSIDE AND PUSHING THE HINGE INWARD JUST ENOUGH TO LET THE MOTOR WORK IT CLOSED.IF THE MOTOR ITSELF ISN'T WORKING PUSH THE HINGE JUST PAST CENTER THEN USE YOUR HAND TO CLOSE THE WINDOW PUSHING IT CLOSED WERE THE MOUNT IS UNTIL YOU CAN GET A NEW MOTOR.HOPE THIS HELPS
you can close it by pulling the door panel and removing the electric motor that raises the window, then lift the window closed and reinstall the motor, but the motor is most likely defective so if u go to all that hassle just replace the motor.