Question about 1998 Oldsmobile Aurora

2 Answers

98 Oldsmobile Aurora 4.0 liter

We trying to fix the pulley on the cam shaft pulley that turns the water pump

Posted by on

  • 3 more comments 
  • Anonymous Nov 09, 2008

    How do you get the cam shaft pulley off to replace the camshaft seal.

  • Anonymous May 25, 2009

    I DONT KNOW WHAT I CAN DO IT WITH THIS CAR

  • roysterk91 May 11, 2010

    I have a 1998 olds aurora ,it has all the power lights, auto and manual headlights, the problem i am having is that the headlight switch seem to making a clicking sound (in that area),sometimes when driving, during this sound the head lights flicker on and off,even if the car is parked and no one is in it, during the night it seems like a ghost car , maybe power is serging?

  • Anonymous Mar 18, 2014

    where is the evaporative emission system for a 98 oldsmobile aurora

  • Anonymous Mar 18, 2014

    how to replace the evaporative emission system for a 98 oldsmobile aurora

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I am having the same problem. I traced the problem to the antitheft box in the car. I was told that a certified mechanic can reset the box and the problem should be corrected. But if the wires going from the large harness from that box get hot to the touch then there might be an arch occuring causing the malfunction. In either case you can unplug the large harness and during the day you have no problems but at night you need to plug that harness back in to get your lights to work and when you arrive at your destination unplug the harness again.

Posted on Jul 20, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Replace belt on water pump and adjust the idlearm

Posted on May 18, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Remove water pump pulley 1998 Oldsmobile aurora that runs water pump


if no bolts then the new pump will have the pully on it meaning it is press fit.

Mar 05, 2015 | 1998 Oldsmobile Aurora

1 Answer

I need to know what purpose each pulley has on an 2002 aurora 3.5 v6


The crank shaft pulley drives them all. One pulley drives the power steering pump-- another drivers the alternator -- another drives the alternator-- another drives the ac compressor and the last ones will be adjuster idlers.

Aug 16, 2013 | Oldsmobile Aurora Cars & Trucks

1 Answer

Crankshaft position sensor on and olds 98


Should be behind the crank pulley under the water pump.

Jun 10, 2013 | Cars & Trucks

1 Answer

How to change water pump on 2001 olds aurora 3.5


does anyone have experience changing a water pump on a 2001 ...

https://answers.yahoo.com/question/index?qid...
Aug 13, 2008 - aurora.................good luck. if u got the "short star" (3.5 dohc v6) good luck. if u got the 4.0........even better luck. happy trails. TonWon ยท 8 years ...

Aurora 4.0 Exhaust Leak and Water Pump Whine - YouTube

? 0:46
https://www.youtube.com/watch?v=5mjg_Ps1Ctg
Dec 13, 2012 - Uploaded by Brendan Doyle
Aurora 4.0 Exhaust Leak and Water Pump Whine. Brendan Doyle ... How to Install a Waterpump on a Cadillac Northstar engine. ...How to access spark plugs on a 2001 Oldsmobile Aurora 3.5L Engine - Duration: 3:19. Dennis ...

Oldsmobile Workshop Manuals > Aurora V6-214 3.5L VIN H ...

workshop-manuals.com/oldsmobile/aurora/...3.5l.../water_pump/.../page...
Oldsmobile Workshop Manuals > Engine, Cooling and Exhaust > Cooling System ...Aurora V6-214 3.5L VIN H SFI (2001) ... Install the new water pump gasket.

How to change water pump on 2001 olds aurora 3.5 - Fixya

www.fixya.com/.../t16902718-change_water_pump_2001_olds_aurora_...
Mar 4, 2013 - 4.0? It's not that hard to replace but you need a special socket to changeit ... The starter motor sits in the "valley" between the two bank of cylinders ...

Mar 04, 2013 | 2001 Oldsmobile Aurora

2 Answers

Need the belt routining diagram for 1983 olds delta 88 royale, 5.0 liter engine


Air pump/Smog pump and Compressor go on first, on the shaft. Power steering goes on next Altenator is the last one. After market pulleys and the above mentioned parts may change this order.. 1983 olds delta 88 royale

Aug 19, 2011 | 1983 Oldsmobile Delta 88

3 Answers

Where is the water pump located on a 1996 olds aurua the car is over heating


Hi, i would check the thermostat first unless the water pump is leaking as the water pump is where the timing belt is is the timing belt needs removing to get to the pump, take the thermostat out and place it in a tub of boiling water and check if it opens up if it dont then it will need replacing.

you need to bare in mind that it could also be head gasket failure so make sure you get this tested if the thermostat is found to be in working order.

let me know if you need further assistance ok

Sep 14, 2010 | 1996 Oldsmobile Aurora

2 Answers

Does the crankshaft have a woodruff key for the harmonic balancer?


hi this depends on what harmonic balancer you are inquiring about, normal balancers do have a woodruff key,but the pulley type harmonic balancer only bolts to a cam hub on what ever it is connected to, such as water pump, etc etc... hope this helps

Sep 13, 2010 | 2001 Oldsmobile Aurora

1 Answer

Firing order 98 aurora


1998 Oldsmobile Aurora 4.0 liter DOHC V-8 VIN "C"

5359090.gif

Remember rated this; good luck.

May 21, 2010 | 1998 Oldsmobile Aurora

1 Answer

Need the belt diagram for the water pump belt for a 95 Auroa


42161874BELT, REPLACE
  1. Release belt tension and remove belt from power steering and alternator pulleys. Twist belt to get between tensioner and front cover and between power steering pulley and engine mount bracket.
  2. Raise and support vehicle.
  3. Turn wheel to the extreme right and remove right side splash shield.
  4. Remove belt from crankshaft and A/C compressor pulleys. Twist belt to get between idler pulley and engine mount bracket.
  5. Lower vehicle.
  6. Twisting new belt to get past the front cover, install belt around power steering pump pulley, Fig. 15. Allow belt to hang free.
  7. Twist belt to get between tensioner and front cover, wrap belt around alternator.
  8. Remove belt from power steering pulley and set aside.
  9. Raise and support vehicle, then twist belt to get between tensioner and front cover, wrap belt around crankshaft and A/C compressor pulleys.
  10. Install right side splash shield and lower vehicle.
  11. Position belt around power steering pulley and release tensioner.

Nov 23, 2008 | 1995 Oldsmobile Aurora

Not finding what you are looking for?
1998 Oldsmobile Aurora Logo

Related Topics:

1,063 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...