Question about 1993 Ford Tempo

2 Answers

Power Windows My power windows have stopped working. I have replaced the fuse under the dash and the master switch in the driver's door. Not sure what to check next. Have not found another fuse panel to check.

Posted by on

  • 1 more comment 
  • Anonymous Jun 05, 2008

    windows wont go down

  • Anonymous Jul 14, 2008

    no power to right rear window

  • newnew1 Jul 20, 2008

    window maks clicking sounds but wont go down

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I've had the same problem. like the person before me I used wd-40 and greesed the tracks and it worked fine for a while.. It happened again and I wasent so lucky that time. The next time I was getting the clicking sound but no movement. So I toar apart the door panel and removed the moter for the window. Cleaned it out to find that the lube that was used in it originally got dried up and was hard not allowing the window to move. cleaned that out got some grease and once again i have a window!
Sarah

Posted on Aug 21, 2008

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I had the same problem,i took the door panels off shot wd-40 &greesed the tracks they work fine now

Posted on Jun 09, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000Mustang,under dash fuse good,for pwrpwr.window,door loc ok,where is under hood slot for relay fuse located?I've no manual or other diagrams..Thanx!


Not a relay or a fuse for the power windows. It's a 20 amp circuit breaker in the Central Junction Box, under the hood. A circuit breaker resets itself if an overload trips it, so that is not likely to be a problem. The windows and the door locks are on separate circuits.

So, do no windows work at all? In that case, it is most often either the master switch on driver's door is at fault, or the power or ground wire to the master switch is broken in the driver's door opening. In the bundle of wires, the black wire is the power windows ground, and it is the ground wire for all the windows, so check it closely. The power wire to the master switch is a light blue with black stripe wire.

See if you can pull out the master switch and its electrical connector, without having to take off the inner door panel. Or if you have to, take off the inner panel, then pull off the connector to the master switch . Now all you need is a voltmeter or test light to check for the power and ground at the connector, with the key in on position. If both are good, the master switch may be defective.

Jul 06, 2014 | Cars & Trucks

1 Answer

Fusebox diagraghm


Usually, power windows use a circuit breaker, rather than a fuse, in the fuse panel under the driver's dash.
If any windows work or even make noise, it's not a fuse or circuit breaker problem. If no windows work, pull out the driver's door master switch and check for one hot wire to it with key on. If there is that, the ground for the windows originates at the master switch and runs back into the cabin to a nearby ground. One could check both power and ground with a test light or voltmeter. Check for broken wires in the group of wires entering the door. If either the power wire or the ground wire has broken there, the windows will not work. If both power and ground are good, possibly a bad master switch.

Jan 04, 2014 | Ford Taurus Cars & Trucks

1 Answer

Where are located the fuses for the power windos


Most power windows use a single circuit breaker in the under dash fuse panel. And if yours does use a fuse, it will be only one for all windows. Should be in the under dash fuse panel. Do any of your windows work? If none work, most likely a broken power wire or ground wire in the little wiring harness going into the driver's door. Or if wiring is not broken there, could be a bad PW master switch on the driver's door.

Dec 13, 2013 | 2000 Land Rover Discovery

1 Answer

Ecectric windows and locks will not work


POWER WINDOWS AND LOCKS
Window fuse's and relay's may be up under driver or passenger side dash or behind glove box, under the hood and even under the seats, and finally on the ends of the dash. All passenger power windows and locks are controlled thru and get power from the master control switch on the drivers door.

May 14, 2012 | 1999 Toyota Camry

1 Answer

Windows only work from the drivers door controls


Check the master window control panel on the driver's door. There is probably a lockout switch. It may have a window outline on one end and the same outline with an "X" over it on the other. Press the outline without the "X" and all your windows should work again. As silly as that sounds, a lot of people hit that switch without knowing it. Also, if that switch(lockout) is faulty, none of the windows will work. That happens A LOT!!

Window fuse's and relay's may be up under driver or passenger side dash or behind glove box, under the hood and even under the seats, and finally on the ends of the dash. All passenger power windows and locks are controlled thru and get power from the master control switch on the drivers door.

Aug 26, 2011 | Dodge Stratus Cars & Trucks

1 Answer

All power windows and sunroof will not budge suddenly on neither the drivers master switch or any of the door window switches. Power locks DO work though. I replaced all 10 and 15 amp fuses in fuse box,...


Window fuse's and relay's may be up under driver or passenger side dash or behind glove box, under the hood and even under the seats, and finally on the ends of the dash. All passenger power windows and locks are controlled thru and get power from the master control switch on the drivers door.

Drivers door window gets used the most so it could be the motor, window switch, relay or fuse.
Could also be a broken wire in the rubber boot going from the door to the body. You will have to eliminate each till you find the culprit. Check that all switches return to neutral when released.
The motor and the relay are the most likely to cause this problem. Try swapping the relay with a working window relay. If it still doesn't work, remove the door panel and remove the window motor.
Turn the motor shaft in both directions by hand several turns. Then plug the motor in and see if the switch will now run the motor. Sometimes that's all it takes to get it working again. I have had to do this with brand new motors. If voltage is not present at the motor connector, either a bad switch or a broken wire exists. Make sure to check for voltage coming to that windows switch. Actually, GM use's a circuit breaker type relay for each window and one fuse for all the circuit breakers.

Try this....
Open the door, turn the key to the ON position without starting the engine and everything that makes noise is off. Lean down placing your ears close to the bottom center of the door or at the speaker grill. Press the window switch UP and DOWN. Listen for the window motor. If heard the drive is damaged. If not heard, turn key off and locate and replace the relay with one of the other window relays. Check window again. If it works now, get a new relay. More often than not, removing the motor and turning it by hand will get it working good as new. I have had to do that with Brand New motors! So try it.
If all has failed, with the door panel still off, check for voltage at the motor connector when pushing the window switch. No voltage means its the switch, especially if its a auto down or up switch.

Check the master window control panel on the driver's door. There is probably a lockout switch. It may have a window outline on one end and the same outline with an "X" over it on the other. Press the outline without the "X" and all your windows should work again. As silly as that sounds, a lot people hit that switch without knowing it. Also, if that switch(lockout) is faulty, none of the windows will work. That happens A LOT!!

Aug 24, 2011 | Toyota Land Cruiser Cars & Trucks

1 Answer

All windows and sunroof will not budge suddenly. I replaed all fuses, and even tried a replacement master switch, but still not fixed. 1997 Landcruiser.


Window fuse's and relay's may be up under driver or passenger side dash or behind glove box, under the hood and even under the seats, and finally on the ends of the dash. All passenger power windows and locks are controlled thru and get power from the master control switch on the drivers door.

Drivers door window gets used the most so it could be the motor, window switch, relay or fuse.
Could also be a broken wire in the rubber boot going from the door to the body. You will have to eliminate each till you find the culprit. Check that all switches return to neutral when released.
The motor and the relay are the most likely to cause this problem. Try swapping the relay with a working window relay. If it still doesn't work, remove the door panel and remove the window motor.
Turn the motor shaft in both directions by hand several turns. Then plug the motor in and see if the switch will now run the motor. Sometimes that's all it takes to get it working again. I have had to do this with brand new motors. If voltage is not present at the motor connector, either a bad switch or a broken wire exists. Make sure to check for voltage coming to that windows switch.

Check the master window control panel on the driver's door. There is probably a lockout switch. It may have a window outline on one end and the same outline with an "X" over it on the other. Press the outline without the "X" and all your windows should work again. As silly as that sounds, a lot people hit that switch without knowing it. Also, if that switch(lockout) is faulty, none of the windows will work. That happens A LOT!!
You may also find that the connector has simply come loose from the master window control. Good luck!!

Aug 24, 2011 | Toyota Land Cruiser Cars & Trucks

2 Answers

How do I fix the problem of all 4 power windows


See if you have power coming out of the master power window switch when a button is pushed down. Remove a door panel and check for power at the window motor with the switch pushed. If you do not have power it could be the master switch. Good luck.

Aug 06, 2009 | 2002 Ford Explorer

2 Answers

Power windows stopped working


If it's all your windows not working from the driver's seat, then it's your window switch on the driver's door or it may be a fuse(I doubt it's a fuse). If it's just one window, then it's the motor inside the door of that one window.

Apr 18, 2009 | 1995 Jeep Cherokee

1 Answer

Pass.side power window won't work.


First be sure the window lock in the drivers side master switch is not LOCKED. This will prevent the windows from being rolled down by any other switch. (p106+)

Usually windows operate off a RELAY - not a fuse... and all the windows work off the same power relay.

Your Relay Part Number is 41-5021.
Here is the electrical schematic for your windows - showing the relay is common to all windows.

6713bdf.gif
CLICK HERE for a better pic.

If the relay is replaced - and/or tested good, You will need to remove the offending door's panel and verify the motor is getting 12VDC when you press the button for it to go down.

If there is 12VDC when you push the button, the motor is bad.

If there is NOT 12VDC when you push the button - the master switch or child lock bypass switch is faulty.

Click HERE for a PDF version of your owners manual

Under the ROADSIDE EMERGENCIES section (p.245) you will find a layout diagram of your fusebox.

P.248 instructs to pull DOWN on the fusepanel door to access... however your power window relay is located under the driver's side dash.



If the other windows work - there are 3 options to test/replace - in this order
1. Relay
2. Master Switch
3. Window motor.


Thanks for using FixYa - a FixYa rating is appreciated for taking the time to answer your FREE question.

Mar 20, 2009 | 1998 Mercury Villager

Not finding what you are looking for?
1993 Ford Tempo Logo

Related Topics:

106 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

63661 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21986 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...