Question about 1995 Toyota Paseo

Open Question

1992 Toyota Paseo change brake light bulb on right side the brake light on the left side is on but the right side is still not coming on even though I change the bulbs

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 373 Answers

SOURCE: 1992 Honda Accord LX Brake Light Switch Repair

Hi....
if you replaced the light bulb . and the light bulb went on short.
The more possible is that the FUSE went BLOWOUT too.
Try to locate the STOP LIGHT fuse. on the Engine compartment
at left side. You will see the FUSE BLOCK. The fuse only have the letters. STOP.. and normally is 15amp.

NOTE.. ANY WOMEN can do this. I hop this help on your problem. Thank you for use fixya....

Posted on Aug 08, 2008

Ad
clarktravis8
  • 74 Answers

SOURCE: How to change my rear brake light bulb

Okay you need to lift your trunk remove any carpeting remove hidden screws to undo light fixture be careful not to drop the case once case is in your hand remove the appropriate bulb that needs replacing after wards reinstall light housing/casing and screws good luck with this. Please Rate Me. And for further assistance you can always ask me.

Posted on Apr 25, 2009

  • 150 Answers

SOURCE: 2005 Toyota Sienna rear brake light problem.

have you checked the earthing continuity-if it's this other bulbs may also partly light when brakes used
otherwise-
Check continuity of live from center to lh & rh lights and/or is there a live at those lights

Posted on May 03, 2009

  • 1 Answer

SOURCE: How do I replace the Rear Brake light bulb of 2001 Toyota Sienna?

I have a 2001 Sienna and have had to replace most of my tail light bulbs.

The bulbs that are mounted in the fender (wrap arounds) have acess panels in the van's interior that easily pop out and expose the back of the light assembly.

However, the bulbs that are found in the lift gate are a different matter. You have to remove the whole interior panel to the lift gate to expose the light assemblies. Go to your auto parts store and get a tool to help pop out the plastic retainers from the lift gates metal frame. Don't force the retainers out. Go slowly and gently so that you don't damage the interior panel. If you are really gentle you might even get to reuse the retainers.

Good luck!

Posted on Jul 01, 2009

techbuster
  • 5081 Answers

SOURCE: How do I change the shift gear bulb in a 1992

1.- Remove the rear part of the console. There are 2 bolts inside of the box compartment, they are under a felt.2. Remove the black plastic trim around the shift. It is clamped. You can use your fingers tips by inserting them around the inside cut out of the trim, rear side, lift the trim.
3. Remove a screw that holds the front part of the console at the drivers side. It is located under the steering wheel.
4. Then strecht out side way this front console as much as you can in oder to have space and reach the bulb. You may also have to remove some of the carpet. See picture
You can not see the bulb, so you have to use your fingers to fill it by following the wires up to the bulb socket.
5. Once you have touch the socket, hold it with you fingers and make a 1/4 turn to loose it and then bring it out to remove the bulb.

Posted on Aug 05, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Dashboard light not working


Check the instrument panel warning light bulb holder for power.
If no power present, then check wiring connector and wiring condition.

Nov 04, 2012 | 1995 Toyota Paseo

1 Answer

1992 PASEO, HEADLITES AND RUNNING LITES STAY ON WITH IGNITION TURNED OFF...


Censor issue maybe. My brake lights did the same thing. I just readjusted the lining... around the trunk latch. And learned to pump my brakes after I turned the engine off. It finally worked itself out.

Feb 08, 2011 | 1992 Toyota Paseo

1 Answer

How do you fix the dash board lights, on a 1994 toyota paseo?.....I can't read how fast I'm going, at night, how do i fix that>


Usually this is a simple fix. Locate your fuse panel under your driver's side dash on your left. Check your fuses and see if any are blown. This can be determined by looking at the little wire inside the fuse to make sure it's not separated. If this doesn't resolve the problem you have either blown bulbs inside your dash or you could have a faulty dimmer switch. To determine this you can disconnect the dimmer switch plug and jump a wire across the plugs and see if they come on them. If they still don't come on then the problem could be dash light bulbs. This can be very difficult to change and is usually best left to a mechanic.

May 29, 2010 | 1994 Toyota Paseo

2 Answers

I need a FREE 1992 Toyota Camry taillight wiring diagram. My side rear park lights come on but my park lights that work with the brake lights don't. I changed the bulbs and tested everything. I narrowed it...


brown wire is your park LT yellow Left-turn green right-turn. Now the break light my be on it own wire it is red black is ground. but if you have a test light see if the brown wire turns on the test LT when you turn on the park LT or what wire light up when you step on the break pedal. and so on.

Feb 25, 2010 | 1992 Toyota Camry V6

1 Answer

How to change brake lights on 92 toyota paseo


look in trunk behind light it might twist out

Sep 26, 2009 | 1992 Toyota Paseo

1 Answer

1992 Dodge Dakota LH tailight problem


Have you taken bulb out & cleaned terminals inside socket & either cleaned bulb base & terminals, or tried replacing bulb?

Mar 10, 2009 | 1992 Dodge Dakota

1 Answer

1992 toyota paseo back lights


check fuses first usuall under dash/ and engine compartment/then check bulbs and the wiring to the lights make sure they are not pinched/ Please rate my response thank you very much

Feb 02, 2009 | 1992 Toyota Paseo

1 Answer

92 toyota paseo alternator not charging


you may have missed a fuse or fusible link , there is a 100amp alternator fuse and a 50 amp fuse on that circuit , location of those 2 fuses are (left side of engine compartment) also there is a fusible link in that circuit right off the positive side of the battery , those big fuses don't look anything like a normal if that helps , cheers'

Jan 13, 2009 | 1992 Toyota Paseo

1 Answer

Right side brake light stays on all the time


Assuming you don't have a trailer connector the bulb failure warning module might be you problem

Nov 19, 2008 | 1992 Toyota Celica

Not finding what you are looking for?
1995 Toyota Paseo Logo

Related Topics:

244 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8531 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...