Question about 2002 Dodge Neon

1 Answer

I have a 5 speed and do not know were to fill the tranny

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Dodge Master
  • 2,019 Answers

There is a plug in the side of the transmission, about an inch in diameter, and you unscrew that. It is both filler and level indicator.
Use 80W-90 hypoid gear lube.

Posted on Sep 17, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is theTransmission Speed Sensor location on 1995 escort lx wagon?


Some of the trannys do not have the fill plug feature. On these trannys, you have to fill through the Vehicle Speed Sensor location (VSS). This is not fun. The VSS is located on the firewall side of the tranny, about in the middle of the tranny, down low. You can barely see it and reach it from the top of the engine compartment on the driver\'s side. You have to disconnect the VSS wire connector. Then, remove the VSS retaining bolt - this is a 10mm hex-head bolt in the tranny near the base of the VSS. The VSS must finally be pried carefully out of the case. Tranny fluid is filled through the VSS hole until full. Re-install the VSS and hook up the connector when complete. Have a box of Band-Aids ready.







If you have to change the fluid because you pulled the tranny, do yourself the favor of removing the speed sensor when the tranny is OUT of the vehicle. Then you can change the O-ring as well. Much easier not to damage the VSS which is a $60+ part to replace.

Aug 12, 2014 | Cars & Trucks

1 Answer

I have a 1993 mazda miata mx-5 5 speed manual tranny. I have a hard time shifting when the tranny is cold there are times I can't shift I.to reverse. I can put it in first but with alot of muscle. but...


Check the fluid level in the transmission. To do this, from under the car remove the fill hole on the one side. Transmission oil should just trickle out the fill hole when properly filled.

If it's low or you're uncertain what's in there and want to make sure the correct fluid is present, you'll need a bottle pump. Mazda calls for 75w90 GL4 and 2 quarts are need for a complete fluid change. Not a bad idea if you don't know when it was last done.

Sep 17, 2013 | Cars & Trucks

1 Answer

What fluid does a 1997 chevy C1500 5 speed manual trans. use


Do you people even read before you answer! There is no park on a manual tranny! The axles do not go into side of transmission either. on this TRUCK aka C1500... This is a truck not a fwd automatic car.If you dont know then dont answer questions!Flat ground take top plug on side of tranny out and fill till it comes back out with 75w90 or 80w140(depending hot/cold climate)You will need a Special removal tool(huge allen wrench type for the drain and fill plugs on right/passenger side of tranny)

Jun 29, 2012 | GMC Sierra Cars & Trucks

1 Answer

How do i check the transmission fluid and change it in a 2005 chevy colbalt, and where does the speedometer cable connect into the transmission at?


There is no dipstick on this tranny (4T40E). On the passenger side of the tranny just beside the output axle seal, there is an 11mm 7/16" bolt head. With the vehicle running in park remove the bolt. If tranny fluid runs out it was over filled. On the top Drivers side of tranny, there is a red plastic cap (marked vent). Remove and add fluid here if low. Once the fluid runs out of bolt hole its at correct level. To do tranny fluid and filter change, loosen off all the pan bolts, drain. Filter is located under pan. Do not remove the bolt with engine off, it will lower the tranny fluid level. Fill with approximately 6.5 qts or lts. Start engine, remove bolt, let run out, when it quits its full. This doesn't change all 16qts ( the torque converter and valve body hold 8 or more), if you want complete change, get it flushed at a shop. It doesn't have a speedo cable anymore either. It has VSS's (vehicle speed sensors) in the tranny and also use wheel speed sensors in the ABS system to calculate speed for different systems. ABS, Cluster, Cruise control, Tranny shifting etc.

Jan 26, 2011 | 2005 Chevrolet Cobalt

1 Answer

1991 dodge dakota 5 speed manual trans .... where do I check the transmission fluid level ?


A plug on the side of the tranny will be the filler, If you have a drain plug in the bottom, If not, you will have two on the side, lower is level, upper is fill. Most manual trannys never get checked or filled, they go for life without the oil being changed. check it out.

Aug 12, 2010 | 1991 Dodge Dakota

2 Answers

How to fill manual transmission fluid on dodge neon 5 speed?


It will be on the side of the transmission just above the halfway point. The plug is usually black or green. You will need to dip your finger in to feel the level the fluid is at. It should be just below the lip of the plug.

Aug 25, 2009 | 2002 Dodge Neon

1 Answer

How do u fill the tranny differential on a 1996 toyota corolla?


It depends on if have you have a 3 speed automatic, 4 speed automatic, or a manual transmission.

The 4 speed and manual tranny share their fluid with the differential so if you fill the tranny you fill the differential at the same time.

The 3 speed differential does not share its fluid with the tranny. To fill or check the fluid on the 3 speed automatic you will need to get underneath the car. The fill bolt faces the firewall side of the transmission. It is about 4 inches above the differential drain plug. You will need a fluid pump and hose to get the fluid into the fill hole. The fluid you will need is Dexron tranny fluid.

Jul 25, 2009 | 1996 Toyota Corolla

2 Answers

Where the plug for tranny on 96' jetta is located?


On the manual transmission you go through the vehicle speed sensor (VSS). Its suppose to go 1/2 way up the teeth marks. Does it not say in the Chiltons manual? I can check when I get home.

Apr 17, 2009 | 1996 Volkswagen Jetta

1 Answer

1993 ford explorer tranny problems


fix where its leaking at look at where torque converter is look where governor is speed sensor .tranny oil pan gasket. look where tranny lines goes to radiator for leak. make all these checks. fix the leaks. fill transmission back to proper level.check and see how it works.

Apr 12, 2009 | 1993 Ford Explorer Limited

Not finding what you are looking for?
2002 Dodge Neon Logo

Related Topics:

58 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...