Question about 2003 Ford Expedition

Open Question

#14 fuse on 03 expedition keeps blowing. this fuse controls the reverse lights and the climate control actuator motor. please advise of some possible causes. thanks

Posted by on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
dnewcombe1
  • 1564 Answers

SOURCE: Air Blend Actuator not working

Make sure you are getting plenty of vacuum to the control, if you are than it will have to be replaced.

Posted on Sep 05, 2009

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does 1 side of dash blow hot and the other cold when ac is on with the dual climate control?


Check the actuator motor on the heater it directs the air into the vents. There is probably two of them be sure to check both. The motor makes the vents move and again directs the air where you want. Hope this helps.

Aug 01, 2016 | 2005 Ford Freestar

1 Answer

Blowing fuse


It sounds to me like a direct short I think you need a sparky to keep the cost down

Jul 07, 2014 | 2002 Ford Explorer

1 Answer

Accessing the climate control cable


climate control is control by a controller or computer which read inside car temperature sensor and ambient sensor.best have vechicle check at garage you need diagnostic equipment to trouble shoot climate control.many things cause climate control problems. could have faulty temperature blend door actuator or bad sensor.

Jun 11, 2013 | 2008 Hyundai Elantra

1 Answer

Radio, ignition coil, antitheft and climate control fuses keep blowing


try looking for a short in the wiring harness and do they run to the same fuse

Feb 16, 2012 | 2000 Ford Expedition

2 Answers

I have no heat in my 2000 ford expedition. The blower motor works but only blows cold air. As far as i can tell the heater core hasnt been by-passed.


Time to either flush or replace the heater core as it may be plugged with rust build-up. I'm assuming the engine is running at normal operating temperature, if not then the thermostat may need replaced.

Mar 04, 2011 | 2000 Ford Expedition

5 Answers

My 1997 ford f150 heater will not blow hot air. i have replace the switch that controls the hot and cold air. i do not know what else to do. i do not heat any vacuum noise when i switch it to the heater or...


first, check under te hood to see if the heater core water hoses are hot going in and coming out. If hot going in but cold coming out, water valve (if you have one) may not be working.
------------------------------------------------------------------------------------------------
Control System Outputs
The air management doors are controlled by vacuum control motors (18A318) and an A/C electronic door actuator motor (19E616). The air inlet and distribution doors are controlled by vacuum control motors. The temperature blend door is controlled by the A/C electronic door actuator motor.
The A/C electronic door actuator motor provides a variable number of temperature blend door positions. Temperature control position energizes the A/C electronic door actuator motor moving the temperature blend door.
Vacuum control motors are used on both air distribution and air inlet doors. The air inlet and panel/defrost doors use a two position vacuum control motor. The floor duct/panel door uses a three position vacuum control motor. Vacuum control motors are controlled by engine vacuum through the climate control head.
For more information on the control components Section 412-04 .
-------------------------------------------------------------------------------------------------------------------------------------
Air Management Doors
The air management doors are controlled by vacuum control motors (18A318) and an A/C electronic door actuator motor (19E616). The air inlet and distribution doors are controlled by a vacuum control motor. The temperature blend door is controlled by the A/C electronic door actuator motor.
The A/C electronic door actuator motor provides a variable number of temperature blend door positions. Temperature control position energizes the A/C electronic door actuator motor moving the temperature blend door.
Vacuum control motors are used on both air distribution and air inlet doors. The air inlet and panel/defrost doors use a two position vacuum control motor. The floor duct/panel door uses a three position vacuum control motor. Vacuum control motors are controlled by engine vacuum through the climate control head.
-------------------------------------------------------------------------------------------------------------------
Section 412-04: Control Components - Climate Control 1997 F-150, F-250 Workshop Manual
REMOVAL AND INSTALLATION A/C Electronic Actuator
Removal
  1. Remove the floor duct panel.
    • Remove the two plastic push pins (one each side) and release the expander clip.
  1. Remove the RH instrument panel brace.
    1. Remove the lower nut.
    1. Remove the upper bolt.
    1. Remove the brace.
  1. Remove the LH instrument panel lower nut and position brace out of the way.
  1. Disconnect the vacuum harness from the vacuum actuator.
  1. Remove the floor duct.
    1. Remove the two screws (one each side).
    1. Remove the floor duct.
  1. Remove the panel/floor door vacuum control motor.
    1. Disconnect the vacuum line connector.
    1. Remove the two panel/floor door vacuum control motor screws.
    1. Slide the rod out of the door and remove the panel/floor door vacuum control motor.
  1. Remove the electronic actuator.
    1. Disconnect the electrical connector.
    1. Remove the three screws.
    1. Pull down to release the actuator shaft and remove the electronic actuator.

Jan 24, 2011 | 1997 Ford F150 Regular Cab

1 Answer

My 2003 Ford Expedition a/c blows out the defrost vents and will not blow out the dash vents


The vacuum motor is not operating right due to a loose vacuum tube, ore electrical connection or the logic is bad in the climate control electronics. The vacuum motor controls the door angle which controls whether the a/c blows out of the front vents or the defrost vents.

Jul 02, 2010 | 2003 Ford Expedition

1 Answer

Rear actuator, when heat is on in front with controls in rear on heat, rear blows cold air


The actuator on the rear controlling the climate control door was bad, the 2 top door panels had to be removed, then removed the 1 door foot step panel on the rear passenger side and the rear bottom hatch panel, then you can pull the large side panel back enough to get into the control, simply unplug the unit and remove the screws and install in reverse order, it took roughly 30 minutes, very much worth the time to DIY, We saved $ 430.00.

Dec 11, 2009 | 2003 Ford Expedition

1 Answer

03 Buick Century DUal Climate problem


the problem is a part called the air temperature control blend door acuator motor, it is deep inside the dash and the dash must be removed to replace it.

Jul 09, 2009 | 2003 Buick Century

1 Answer

5 amp fuse in passengers fuse panel keeps blowing


It also feeds the overhead console.Suspect that is were your problem is.

Feb 07, 2009 | 2005 Ford Mustang

Not finding what you are looking for?
2003 Ford Expedition Logo

Related Topics:

40 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...