Question about 1997 Dodge Neon

1 Answer

Put two qt oil in my car a day i have put oil seal stop leak in it and it sill leaking have do i stop it or replace it

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 149 Answers

Probley need to replace some gaskets not sure of the ones you need. need more info.

Posted on Sep 16, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 Mazda Protege 1.6L big oil leak passanger side. No oil in timing belt area. All over firewall & steering rack. What is leaking?


probably gaskets are not sealed properly you have to redo it or try and cleaned it remove all the oil that sorrounds the engine and try to seal with a high temp silicon

Jan 17, 2013 | Mazda 323 Cars & Trucks

1 Answer

Front seal leak in my highlander


front seals do not squirt out
check for loose oil filter, problem filter seal or gasket

Jul 07, 2017 | 2004 Toyota Highlander

1 Answer

I have a huge oil leak in my 98 Toyota Camry It leaks roughly 1 qt of oil for each hour of driving. What would be the cost of repair?


Need to find out where leak is from. Kinda sounds like a crankshaft main seal, front or rear of engine. Front one is pretty easy to change, but rear main seal leak means you have to drop transmission to get to it. But it could be another seal or gasket. Can you tell about where leak is, from oil spills on ground where parked? Look at engine. Is oil seeming to leak from bottom end or upper engine. May need to wipe or clean it off to see where fresh oil leak develops. A mechanic may need to put it on a car lift to pinpoint the leak. Good luck.

Oct 24, 2011 | 1998 Toyota Camry

1 Answer

2004 gmc yukon lite came on low oil pressure just had oil change 5 days ago checked it was low about a qt. Has 157,000 miles what can be the cause


There can be alot of causes, such as valve covers leaking, oil pan gasket leaking, oil filter leaking, rear main seal leaking, front timing chain cover seal or gasket leaking even bad rings. Does it smoke out of the back? Your valve seals could be leaking. Best way to find out if you have a leak is to inspect the valve covers manually, or take newspapers and lay them under the entire engine on the ground, and it will leave the tell tale stain of a leak. Hope this helps.

Jun 15, 2011 | 2004 GMC Yukon

1 Answer

I have a 2001 Saturn L. Oil is leaking, it is not the head gasket. Tore engine apart and replaced gaskets. Stopped leaking for about 6-7 months and it started to leak again. Did oil change last week...


If you have no visible signs of oil leaking out of the engine then the oil is being burnt. By visible leaking I mean a small puddle of oil under the car after having been left overnight. This can be cured by replacing shaft seals and gaskets. Burning oil is visible as smoke under deceleration (no throttle) and under full power(flooring it). This is due to worn/old valve stem seals(smoke under deceleration) and worn oil rings(smoke under acceleration) This can only be cured by a major engine overhaul or engine replacement. Bear in mind that losing a pint of oil in 1000 miles is acceptable.

Sep 25, 2010 | 2001 Saturn L-Series

1 Answer

I have a Ford 3.8 that has a leak, it looks like it was


Make sure when you put the filter on that there's not a piece of an old gasket sitting there. That will prevent the new gasket from sealing.

Nov 22, 2009 | 1993 Ford Taurus

2 Answers

Quantity of Oil to use


most only take 5 qt put in 4 and check the dip stick if it is on full run the engine for a min and let it stand for a bit recheck and add what you need to full mark

Apr 05, 2009 | 1998 Mercury Sable

Not finding what you are looking for?
1997 Dodge Neon Logo

Related Topics:

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...