Question about 1991 Ford Mustang

Open Question

How to set timing on 91 mustang 5.0? - 1991 Ford Mustang

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need to adjust timming on 91 ford mustang


pull the spout connector (a grey jumper located in the engine wiring harness either near the code reader port or the distributor) and put a timing light on the #1 spark plug wire. Aim the light at the pointer near the 10-o'clock position on the harmonic balancer (looking aft) while the engine is running and rotate the distributor until you see the pointer aiming at 8-10* BTDC. Don't forget to put the spout connector back in when you're done or else the computer won't be able to automatically advance the timing.

Nov 22, 2011 | 1991 Ford Mustang

1 Answer

I have a 84 351 windsor that runs way to hot i put


seems to me that you could have an air lock, try loosening the rad cap slightly and run car until fans kicks in, squeeze upper rad hose a few times to push any air out. Careful with hot hoses. see if this helps.

Apr 27, 2010 | 1991 Ford Mustang

1 Answer

How do the rear quarter panel windows come off a 91 mustang GT


You have to pull the inside trim off to get access to the nuts that hold the 1/4 glass in place.

I better way of attacking your problem is to tape off the molding and paint it still attached to the car. I have done this several times with very good results.

Feb 26, 2010 | 1991 Ford Mustang

2 Answers

WILL A SPEEDOMETER OUT OF 89 MUSTANG WORK IN A 91 CLUSTER PANEL BECAUSE THE 91 SPEEDO SPURATICALLY GOES UP AND DOWN


i do not know but give these websites a try www.alldatadiy.com and www.autozone.com you can also stop by your local Ford dealership in the parts department and they be able to tell you if it does not work and you are looking for one try a good salvage yard near you give this website a try www.junkyarddog.com wish you the best of luck Michigan Man.

Feb 08, 2010 | 1993 Ford Mustang

1 Answer

I have a 91 mustang gt. when i crank it over i


Bad ign switch, not the key switch, the one down on the column. good luck

Jan 20, 2010 | 1991 Ford Mustang

1 Answer

91 ford mustang convertible driver side rear window is off track or something as it wobbles around and does not roll up and down smoothly


you going to have to take it apart to get to it, is not that hard but time consuming; the parts is cheap. The common problems with those is the regulator is worned and need replacing. regulator is a window track, it keep the window in it track and when it become worned it get sloppy. hope that help some

Oct 04, 2009 | 1991 Ford Mustang

1 Answer

Car repair


i had the same problem just a little bit ago with my 91 mustang lx 2.3L. b. If you are not getting and sparks from your coil packs then im going to guess this is where the problem is. start by replacing all spark plugs and wires. if this does not work it most likely the coil packs ,But if there is spark then its your timing belt.

Oct 13, 2008 | 1991 Ford Mustang

1 Answer

91 four cylinder ford mustang


whens the last time you had a tune up, plugs and wires could solve this problem.

Sep 24, 2008 | 1991 Ford Mustang

Not finding what you are looking for?
1991 Ford Mustang Logo

Related Topics:

272 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

fordexpert

Level 3 Expert

5575 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...