Question about 2002 Ford Windstar Cargo

1 Answer

Starts fine, but after 5 blocks starts to stall at a light. after reving the engine it runs fine. this only happens in the morning and just recently.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 2,019 Answers

Fairly normal. But you could check the plug, fuel and air filter, PVC valve, and all the normal things you check with an annual tune up.
You could also check and clean the air mass sensor.
It often gets coated with PVC foam.

Posted on Sep 16, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2006 VW GOLF TURBO DIESEL 1.9 STARTS UP GOES 5 TO 9 MILES STALLS WAIT 5 MINUTES GO AGAIN AND STALLS


Hi. It would be useful to get a code read and some live data from a decent diagnostic tool. There are quite a few possible causes including, pressure in tank - if the fuel tank can't vent pressure then a vacuum will eventually form stopping fuel getting to the engine, this will cause it to loose power and stall. Then after a few mins the pressure will drop and the process start again, easy test is when the car stalls remove filler cap - if that's the fault there will be an audible hiss and the car will start up again.

part blocked exhaust will have same problems but will more generally cause a lack of power and acceleration.
are there other symptoms? i.e only when conering or only when pulling off or stopping, engine light on/off. Jon

Dec 18, 2014 | Cars & Trucks

1 Answer

CRANKING NOT STARTING


Sounds like either the fuel filter or the catalytic converter. You will need to check the back pressure of the exahust and the fuel pressure after it fails. This I say because you did not mention any trouble codes.(check engine light on or flashing)

Feb 02, 2014 | 1999 Lexus LS 400

1 Answer

Emissions problem


may have a bad sensor or low fluid levels somewhere.. some have safety sensors that cut into the operating systems to keep from blowing the engine..

Dec 22, 2013 | Cars & Trucks

1 Answer

2000 Caravan won't start cold unless I rev engine for 5 min


You need to check the cold choke set up, which may be called a IAC
Idle Automatic Control this is sensor works the am starts for cold or hot idles...
Do you have a light on??

Oct 23, 2013 | Dodge Caravan Cars & Trucks

1 Answer

1995 Boneville 3.8 no supercharge. starts and idles fine but when reved up to about 2000 rpm starts missing/backfiring badly.exhaust would become red when reving up.removed cat converter did not look bad...


you need to check the 02 sensor that is on the engine

the converter is probably blocked if it is turning cherry red.

try putting some fuel cleaners in your system like heet from auto zone

you need to make sure the wires are in the right order

make sure there are no breaks in the wire

if you have a check engine light, you should take it to auto zone to get it tested for a better insight

Dec 05, 2010 | 1995 Pontiac Bonneville

1 Answer

Car starts fine, but stalls at stops and takeoffs occasionlly


Most likely it is running too ritch. should be around 7%. Mine did ecactly the same thing and I had several things done . Had the throttle body cleaned and installed a O2 senser.runs great now.

Hope this helps

May 14, 2009 | 1993 Oldsmobile Cutlass Supreme

1 Answer

2004 Chevy Trailblazer engine stalls after coolant temp senor R&R


clean your throttle body....same thing happened to me and my truck runs great now.

Mar 19, 2009 | 2004 Chevrolet TrailBlazer

1 Answer

No Power sometime, Engine Light is Flashing


If fuel filter hasn't been done lately I would start there & if you can, have fuel pressure tested while your at it. You may have tired fuel pump but pressure test will confirm. If you recently filled up somewhere different last time you got gas, I'd also try some "Heet" or similar just incase you got a tank full with some water in it.

Dec 13, 2008 | 1999 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

100 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5474 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...